Concept explainers
Can a body be in equilibrium when only one force acts on it? Explain.
The body is in equilibrium or not when only one force is applied on it.
Answer to Problem 4.1DQ
Therefore, the body is not in equilibrium because the net force acting on the body is not equal to zero.
Explanation of Solution
When, only one force is acting on the body, there is no other force on the body which cancels out the effect of this force. The net force acting on the body is not equal to zero. So, the body will be not in equilibrium which means the body will accelerate.
Conclusions:
Therefore, the body is not in equilibrium because the net force acting on the body is not equal to zero.
Want to see more full solutions like this?
Chapter 4 Solutions
University Physics with Modern Physics (14th Edition)
Additional Science Textbook Solutions
Microbiology: An Introduction
Genetic Analysis: An Integrated Approach (3rd Edition)
Campbell Biology (11th Edition)
Human Anatomy & Physiology (2nd Edition)
Chemistry: A Molecular Approach (4th Edition)
Cosmic Perspective Fundamentals
- A block of ice (m = 15.0 kg) with an attached rope is at rest on a frictionless surface. You pull the block with a horizontal force of 95.0 N for 1.54 s. a. Determine the magnitude of each force acting on the block of ice while you are pulling. b. With what speed is the ice moving after you are finished pulling? Repeat Problem 71, but this time you pull on the block at an angle of 20.0.arrow_forwardThe board sandwiched between two other boards in Figure P4.91 weighs 95.5 N. If the coefficient of friction between the boards is 0.663, what must be the magnitude of the compression forces (assumed to be horizontal) acting on both sides of the center board to keep it from slipping? Figure P4.91arrow_forwardYou have been hired as an expert witness in a case involving an injury in a factory. The attorney who hired you represents the injured worker. The worker was told to lift one end of a long, heavy crate that was lying horizontally on the floor and tilt it up so that it is standing on end. He began lifting the end of the crate, always applying a force that was perpendicular to the top of the crate. As the end of the crate got higher, at a certain angle, the bottom of the crate slipped on the floor, and the worker, in trying to recover, stepped forward and the crate landed on his foot, injuring it badly. As part of your investigation, you go to the factory and measure the coefficient of static friction between a crate and the smooth concrete floor. You find it to be 0.340. Prepare an argument for the attorney showing that it was impossible to lift the crate in the manner described without it slipping on the floor.arrow_forward
- Why it is easier to open a door if you pull perpendicularly to the door instead of pulling at an angle?arrow_forwardCan an object be in mechanical equilibrium when only a single force acts on it? Explain.arrow_forwardThe figure shows a person whose weight is W = 782 N doing push-ups. Find the normal force exerted by the floor on (a) each hand and (b) each foot, assuming that the person holds this position.arrow_forward
- Please help mearrow_forwardWhich one of the following statements is true regarding the normal force? )At any instance there can only be one normal force acting on an object. OAt static equilibrium, the normal force on the object is equal to zero. ONormal force always points perpendicular to the surface the object is in contact with. The normal force is equal to the weight of the object.arrow_forwardA drill rod is used with a air hammer for making holes in hard rock so explosives can be placed in them. How many impulsive forces act on the drill rod during the drilling? Assume the weight of the drill rod is nonimpulsive 2 1,arrow_forward
- Question 19 In order to prevent muscle contraction from misaligning bones during healing (which can cause a permanent limp), injured or broken legs must be supported horizontally and at the same time kept under tension (traction) directed along the leg. One version of a device to accomplish this aim, the Russell traction apparatus, is shown in the figure below. This system allows the apparatus to support the full weight of the injured leg and at the same time provide the traction along the leg. If the leg to be supported weighs 47.0 N, what must be the weight of W? 25° 25° W Question 20 In order to prevent muscle contraction from misaligning bones during healing (which can cause a permanent limp), injured or broken legs must be supported horizontally and at the same time kept under tension (traction) directed along the leg. One version of a device to accomplish this aim, the Russell traction apparatus, is shown in the figure below. This system allows the apparatus to support the full…arrow_forwardQuestion 1) The figure shows a person wearing weight boots and doing lower leg flexion/extension exercise in sitting position to strengthen the quadriceps muscles and a simple mechanical model of his leg. W 1 is the weight of the lower leg, Wo is the weight of the boot, FM is the magnitude of the pulling force exerted on the tibia by the quadriceps muscles through the patellar tendon, F, is the magnitude of the reaction force acting on the tibiofemoral joint. Point O is the center of the tibiofemoral joint, Point A is the point where the patellar tendon attaches to the tibia, Point B is the center of gravity of the lower leg, C point of gravity is the center of gravity of the boat. The distances between point O and points A, B and C were measured as a = 10 cm, b=22 cm and c=43 cm, respectively. The angle between the long axis of the tibia and the horizontal is B=38°, the angle between the action line of the quadriceps muscle strength and the long axis of the tibia is a=18°. Points O,…arrow_forwardA person is pushing a wheelbarrow along a ramp that makes an angle ?=43.0∘ with the horizontal. The wheelbarrow and load have a combined mass of ?=24.05 kg with the center of mass at the midpoint of the length ?. What is the magnitude of the net force ?net that the person must apply in order to push the wheelbarrow up the ramp at a constant velocity, while keeping the wheelbarrow in a level, horizontal orientation? Assume that the radius of the wheel is small enough to ignore. Use ?=9.81 m/s2.arrow_forward
- College PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningGlencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-HillCollege PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning