ELEM.PRIN.OF CHEMICAL...ABRIDGED (LL)
ELEM.PRIN.OF CHEMICAL...ABRIDGED (LL)
4th Edition
ISBN: 9781119540632
Author: FELDER
Publisher: WILEY
bartleby

Concept explainers

Question
Book Icon
Chapter 3, Problem 3.42P
Interpretation Introduction

(a)

Interpretation:

The fraction of 137Cs that have to decay for the level of cesium-related radioactivity of the contents, total mass of cesium (kg) represented by loss and year at which the level will be reached should be calculated.

Concept introduction:

The radioactive decay can be calculated as follows:

N=N012t/t1/2

Here, N is amount of subtance remain after time t, No is initial amount of substance, t is time and t1/2 is half life time.

The specific radioactivity per liter SrL can be calculated as follows:

SrL=Srρ

Here, Sr is specfic radioacivity and ρ is concemtration.

Interpretation Introduction

(b)

Interpretation:

The concentration of 137Cs in the tank (g/L) should be calculated when the waste was first stored.

Concept introduction:

The radioactive decay can be calculated as follows:

N=N012t/t1/2

Here, N is amount of subtance remain after time t, No is initial amount of substance, t is time and t1/2 is half life time.

The specific radioactivity per liter SrL can be calculated as follows:

SrL=Srρ

Here, Sr is specfic radioacivity and ρ is concemtration.

Interpretation Introduction

(c)

Interpretation:

The reason for the radioactive cesium in the tank to poses a signifiicant environmental threat but not by the radioactive barium should be explained.

Concept introduction:

All the radioactive substance are harmfull for environment. The extent of harm they can cause to environment depends on their decay rate that depends on their half life time. More the decay rate or lower the half life time, less the substance is harmful to environment. Therefore, a substance with higher half life time will have low decay rate and it will be more harmful to the environment.

Blurred answer
Students have asked these similar questions
Hydrogen (H₂) is considered a clean energy carrier. For its use as a fuel, hydrogen is stored at 5 bar insidea cylindrical tank made of nickel (Ni) with 7 cm inner diameter, 1.2 mm thickness, and the length of L. Thetank is maintained at 358 K. Unfortunately, a small amount of hydrogen diffuses out of the tank, slowlydepleting its contents. You may assume that the hydrogen pressure outside the tank is essentially zero andconvective resistance inside and outside of the cylinder is negligible.• Solubility of H2 in Ni at 358 K = 0.00901 kmol/m3·bar• DH2, Ni at 358 K = 1.2 x 10-12 m2/sCalculate the maximum length of the nickel tank wall to ensure that the hydrogen loss does not exceed0.01 kg per year.
You just took out a cold soda can (at 1 oC) from the refrigerator. Calculate thetemperature of the soda can after the can is placed in a room (at 31 oC, h = 100 W/m2-K) for 60 mins (we all know that soda tastes much better when it is cold!). • k = 0.617 W/m-K, density = 996 kg/m3, Cp = 4178 J/Kg-K• Height = 10 cm & Diameter = 5 cmCalculate the temperature of the soda can surface at the middle point of the heightusing 2-D analysis.
A thick nickel wall is exposed to pure 5 bar H2(g) at 85 oC on one side of its surface (13 pts).(a) Assuming thermodynamic gas-solid equilibrium, calculate the H2 concentration at the surface ofthe nickel wall. (b) Assuming that the concentration of H2 at the surface is constant, determine the concentration ofH2 at the penetration depth in percentage of its concentration at the wall surface

Chapter 3 Solutions

ELEM.PRIN.OF CHEMICAL...ABRIDGED (LL)

Knowledge Booster
Background pattern image
Chemical Engineering
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemical-engineering and related others by exploring similar questions and additional content below.
Similar questions
SEE MORE QUESTIONS
Recommended textbooks for you
Text book image
Introduction to Chemical Engineering Thermodynami...
Chemical Engineering
ISBN:9781259696527
Author:J.M. Smith Termodinamica en ingenieria quimica, Hendrick C Van Ness, Michael Abbott, Mark Swihart
Publisher:McGraw-Hill Education
Text book image
Elementary Principles of Chemical Processes, Bind...
Chemical Engineering
ISBN:9781118431221
Author:Richard M. Felder, Ronald W. Rousseau, Lisa G. Bullard
Publisher:WILEY
Text book image
Elements of Chemical Reaction Engineering (5th Ed...
Chemical Engineering
ISBN:9780133887518
Author:H. Scott Fogler
Publisher:Prentice Hall
Text book image
Process Dynamics and Control, 4e
Chemical Engineering
ISBN:9781119285915
Author:Seborg
Publisher:WILEY
Text book image
Industrial Plastics: Theory and Applications
Chemical Engineering
ISBN:9781285061238
Author:Lokensgard, Erik
Publisher:Delmar Cengage Learning
Text book image
Unit Operations of Chemical Engineering
Chemical Engineering
ISBN:9780072848236
Author:Warren McCabe, Julian C. Smith, Peter Harriott
Publisher:McGraw-Hill Companies, The