Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (Chs 1-42) Plus Mastering Physics with Pearson eText -- Access Card Package (4th Edition)
4th Edition
ISBN: 9780133953145
Author: Randall D. Knight (Professor Emeritus)
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 27, Problem 53EAP
The resistivity of a metal increases slightly with increased temperature. This can be expressed as
- First find an expression for the current / through a wire of length L, cross-section area A, and temperature T when connected across the terminals of an ideal battery with terminal voltage
- For copper,
- What is the rate, in A/°C, at which the current changes with temperature as the wire heats up?
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
of 20.0°C and satisfies the equation p = Po[1 + a(T - T)], where po is the resistivity of
= 20.0°C. Suppose the coefficients were given the symbol B and were based on a T, of 0°C, so that they satisfied the equation p = Po*[1+ B(T - 0°C)],
The temperature coefficient of resistivity a is based on a reference temperature
the material at To
where
is the resistivity of the material at 0°C. Obtain the value for the coefficient a from this table and then determine the value of the coefficient B for silver.
Po
(°C)-1
Need Help?
Read It
Please Asap
The resistance of the tungsten filament of an incandescent light bulb at 24 degC is 32 Ohms. If the light bulb is connected to a voltage of 130 V a current of 0.3 A flows through the filament. What will be the temperature of the light bulb filament under working conditions? The temperature coefficient of resistance of tungsten is 4.6E-3 1/degC. Your answer must be in degC, other scales are not accepted.
Chapter 27 Solutions
Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (Chs 1-42) Plus Mastering Physics with Pearson eText -- Access Card Package (4th Edition)
Ch. 27 - Prob. 1CQCh. 27 - Prob. 2CQCh. 27 - The electron drift speed in a wire is exceedingly...Ch. 27 - Prob. 4CQCh. 27 - Prob. 5CQCh. 27 - All the wires in FIGURE Q27.6 are made of the same...Ch. 27 - Both batteries in FIGURE Q27.7 are ideal and...Ch. 27 - Both batteries in FIGURE Q27.8 are ideal and...Ch. 27 - The wire in FIGURE Q27.9 consists of two segments...Ch. 27 - Prob. 10CQ
Ch. 27 - ll. The wires in FIGURE Q27.11 are all made of the...Ch. 27 - Which, if any, of these statements are true? (More...Ch. 27 - Prob. 1EAPCh. 27 - Prob. 2EAPCh. 27 - .0 × 1016 electrons flow through a cross section...Ch. 27 - Prob. 4EAPCh. 27 - Prob. 5EAPCh. 27 - Prob. 6EAPCh. 27 - Prob. 7EAPCh. 27 - Prob. 8EAPCh. 27 - Prob. 9EAPCh. 27 - Prob. 10EAPCh. 27 - Prob. 11EAPCh. 27 - The current in an electric hair dryer is 10.0 A....Ch. 27 -
13. When a nerve cell fires, charge is...Ch. 27 - Prob. 14EAPCh. 27 - Prob. 15EAPCh. 27 - Prob. 16EAPCh. 27 - Prob. 17EAPCh. 27 - Prob. 18EAPCh. 27 - Prob. 19EAPCh. 27 - Prob. 20EAPCh. 27 - Prob. 21EAPCh. 27 - Prob. 22EAPCh. 27 - Prob. 23EAPCh. 27 - 24. The two segments of the wire in FIGURE EX27.24...Ch. 27 - A 1.5 V battery provides 0.50 A of current. a. At...Ch. 27 - Prob. 26EAPCh. 27 - Prob. 27EAPCh. 27 - Prob. 28EAPCh. 27 - Prob. 29EAPCh. 27 - Prob. 30EAPCh. 27 - Prob. 31EAPCh. 27 - Prob. 32EAPCh. 27 - Prob. 33EAPCh. 27 - Prob. 34EAPCh. 27 - Prob. 35EAPCh. 27 - Prob. 36EAPCh. 27 - Prob. 37EAPCh. 27 - Prob. 38EAPCh. 27 - Prob. 39EAPCh. 27 - Prob. 40EAPCh. 27 - Prob. 41EAPCh. 27 - Prob. 42EAPCh. 27 - Prob. 43EAPCh. 27 - Prob. 44EAPCh. 27 - Prob. 45EAPCh. 27 - Prob. 46EAPCh. 27 - Prob. 47EAPCh. 27 - Prob. 48EAPCh. 27 - Prob. 49EAPCh. 27 - Variations in the resistivity of blood can give...Ch. 27 - The conducting path between the right hand and the...Ch. 27 - The conductive tissues of the upper leg can be...Ch. 27 - The resistivity of a metal increases slightly with...Ch. 27 - Prob. 54EAPCh. 27 - You need to design a 1.0 A fuse that “blows” if...Ch. 27 - I A hollow metal cylinder has inner radius a....Ch. 27 - A hollow metal sphere has inner radius a, outer...Ch. 27 - The total amount of charge in coulombs that has...Ch. 27 - The total amount of charge that has entered a wire...Ch. 27 - The current in a wire at time t is given by the...Ch. 27 - The current supplied by a battery slowly decreases...Ch. 27 - The two wires in FIGURE P27.62 are made of the...Ch. 27 - What diameter should the nichrome wire in FIGURE...Ch. 27 - An aluminum wire consists of the three segments...Ch. 27 - A wire of radius R has a current density that...Ch. 27 - A 0.60 -mm-diameter wire made from an alloy (a...Ch. 27 - A 20 -cm-long hollow nichrome tube of inner...Ch. 27 - Prob. 68EAPCh. 27 - Prob. 69EAPCh. 27 - Prob. 70EAPCh. 27 - Prob. 71EAPCh. 27 - Prob. 72EAPCh. 27 - Prob. 73EAPCh. 27 - Prob. 74EAPCh. 27 - Prob. 75EAPCh. 27 - Prob. 76EAP
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A platinum resistance thermometer (PRT) is a transducer which measures temperature 0 by means of consequent change of electrical resistance RT between its two terminals. Such a PRT has the following quadratic characteristic: RT=Ro [1+A0+BO^2] The PRT is calibrated so that its resistance is Ro = 100 Q at a reference temperature of 0 = 0°C. The coefficients have the following values: A = +4.0 x 10-3 °C-1 B = -5.0 x 10-6 oc-2 Determine sensitivity of this transducer at temperatures of +50 °C. Select one: O a. 0.45 Q/°C Ob. -0.45 Q/°C -0.35 Ω/ΟC d. 0.4 0/°C O e. 0.35 Q/°C O f. -0.4 0/PCarrow_forwardThe amount of charge flowing through a particular conducting wire is represented by the equation q (t) = at³ + bt? +c, where a = 5 A/s?, b = 3 A/s, and c is an unknown constant. When t = 0.9s, the voltage across the wire is measured to be 12 V. What is the resistance of the wire in Ohms?arrow_forwardDuring an experiment to verify Ohm's law, the voltage supplied and the current through a circuit are measured. [Voltage is measured in Volt (V) and current in Ampere (A)]. V www R A Battery The measured value of the current is I = 2.8 ± 0.1 A and that of the voltage is V = 18 ± 0.4 V. The resistance of the circuit %3D %3D (in Q) can be calculated using the formula, R =V/I, Calculate the, a) Resistance (in Q) = b) Fractional uncertainty in the resistance = c) Absolute uncertainty (in 2) in the resistance=arrow_forward
- A cylindrical conductor has resistance of R0 = 140 Ω. It has length L, radius of the cross section r, and resistivity ρ. Part (a) Express the resistance in terms of L, r, ρ. Part (b) If the resistivity increases by a factor of 5, what would the value of the new resistance be, in ohms? Part (c) If the resistivity was restored to its original value and instead the length of the conductor decreased by a factor of 5, what would the value of the new resistance be, in ohms? Part (d) If the resistivity and length of the conductor were at their original values and the radius of the conductor increased by a factor of 4, what would be the value of the new resistance, in ohms?arrow_forwardA cylindrical conductor has resistance of R0 = 120 Ω. It has length L, radius of the cross section r, and resistivity ρ. Part (a) Express the resistance in terms of L, r, ρ. R0 = P L/π r2 This equation is incorrect Part (b) If the resistivity increases by a factor of 5, what would the value of the new resistance be, in ohms? Rρ =600 Part (c) If the resistivity was restored to its original value and instead the length of the conductor decreased by a factor of 5, what would the value of the new resistance be, in ohms? Rl = Part (d) If the resistivity and length of the conductor were at their original values and the radius of the conductor increased by a factor of 4, what would be the value of the new resistance, in ohms? Rr =arrow_forwardResistance in metals increases with increasing temperature according to the equation, ρ(T) = ρo(1 + α(T - To)) where α is the temperature coefficient of resistivity and ρo is the resistivity at temperature To. For a particular wire α = 9.5 × 10-3 1/°C and the resistivity is ρo = 4.5 × 10-7 Ω⋅m at To = 154 °C. a). Input an expression for the temperature T2 at which the resistance of a wire will be twice as high as at T0. b). If the wire is L = 1 m long with a radius of r = 1 cm, what is its resistance R, in Ω, at 2To?arrow_forward
- The resistance of a material can be calculated with the following equation: R = ρ L A where ρ is the resistivity, L is the length, and A is the cross-sectional area. What is the resistance of an axon’s membrane segment with a length of 1 mm (enter your answer in units of M Ω)?arrow_forwardsq 4. Maximum surface resistance. Consider a square sheet of side L, thickness d, and electrical resistivity p. The resistance measured between opposite edges of the sheet is called the surface resistance: R = pL/ Ld = p/d, which is independent of the area of the sheet. (R is called the resistance per square and is expected in ohms per square, because p/d has the dimensions of ohms.) If we express p by p=m/ne²t, then Rq=m/ndet. Suppose now that the minimum value of the collision time is determined by scattering from surfaces of the sheet, so that Td/v, where v is the Fermi velocity. Thus the maximum surface resistivity is Rmvp/nd²e². Show for a monatomic metal sheet one atom thickness that sq Rħ/e² = 4.1k, where lkn is 10³ ohms. sqarrow_forwardTwo identical resistors of R0 = 98 Ω are connected head-to-tail. Express the resistance R0 of one of the resistors in terms of the resistivity ρ, length L, and the cross section area A. Calculate the total resistance R of the two resistors in ohms.arrow_forward
- In the classic model for electrical conduction, electron mobility u in a metal wire is defined as where v, is the drift velocity of the electrons and E is the electric field in the metal. This parameter is a measure of how freely electrons can travel through a metal when an electric field is applied, such as when the ends of a metal wire are connected to a potential difference. (a) Show that where a is the conductivity of the metal, n is the number density of the charge carriers, and q is the charge on each carrier. (Submit a file with a maximum size of 1 MB.) Choose File no file selected This answer has not been graded yet. (b) B = AVH is often written as AVH - R IB where R, is the Hall coefficient of the metal. Show that the following is true. (Submit a file with a maximum size of 1 MB.) Hyo -n (Choose File no file selected This answer has not been graded yet (c) The table below shows some measured values of Hall coefficients for some elemental materials. What is an average number…arrow_forwardAn electric device draws 7.10 A at 240 V. If the voltage drops by 10 % , what will be the current, assuming nothing else changes? Next, if the resistance of the device were reduced by 10 %, what current would be drawn at 240 V? Express your answer to two significant figures and include the appropriate units.arrow_forwardThe resistivity of gold at room temperature is 2.35 x 10-8 ohm-m. The temperature coefficient alpha = 3.98 x 10-3/K. What will be the resistivity of a piece of gold whose temperature is 150°C above room temperature?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
DC Series circuits explained - The basics working principle; Author: The Engineering Mindset;https://www.youtube.com/watch?v=VV6tZ3Aqfuc;License: Standard YouTube License, CC-BY