Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (Chs 1-42) Plus Mastering Physics with Pearson eText -- Access Card Package (4th Edition)
4th Edition
ISBN: 9780133953145
Author: Randall D. Knight (Professor Emeritus)
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 21, Problem 33EAP
The coefficient of performance of a refrigerator is 5.0. The
compressor uses 10 J of energy per cycle.
a. How much heat energy is exhausted per cycle?
b. If the hot-reservoir temperature is 27°C, what is the lowest
possible temperature in °C of the cold reservoir?
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
A certain coal-fired power plant has a rated power capacity of P = 850 MW. The output of this plant is W = 0.26QH, where QH is the energy input as heat from the hot reservoir.
a. Write an equation for the efficiency of a heat engine in terms of QH and the heat QC exhausted to a low-temperature reservoir.
b. What's the maximum thermal efficiency of the power plant?
c. What's the absolute value of the exhausted heat (QC) each second in MJ for the power plant?
A heat pump moves heat from the chilly 8°C air outside a house to the toastier 21°C air inside. The actual coefficient of performance of the system is 3.2, a typical value.a. If the system adds 11 kJ to the house each second, how much electric energy is required?b. How much energy would it take to add 11 kJ each second if the heat pump ran at the maximum theoretical efficiency?
An engine does 10 J of work and exhausts 15 J of waste heat.a. What is the engine’s efficiency?b. If the cold-reservoir temperature is 20°C, what is the minimum possible temperature in °C of the hot reservoir?
Chapter 21 Solutions
Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (Chs 1-42) Plus Mastering Physics with Pearson eText -- Access Card Package (4th Edition)
Ch. 21 - Prob. 1CQCh. 21 - Rank in order, from largest to smallest, the...Ch. 21 - Prob. 3CQCh. 21 - FIGURE Q21.4 shows the pV diagram of a heat...Ch. 21 - Rank in order, from largest to smallest, the...Ch. 21 - FIGURE Q21.6 shows the thermodynamic cycles of two...Ch. 21 - A heat engine satisfies Wout= Qnet. Why is there...Ch. 21 - Prob. 8CQCh. 21 - Prob. 9CQCh. 21 - Prob. 10CQ
Ch. 21 - Prob. 11CQCh. 21 - Prob. 1EAPCh. 21 - Prob. 2EAPCh. 21 - Prob. 3EAPCh. 21 - Prob. 4EAPCh. 21 - Prob. 5EAPCh. 21 - Prob. 6EAPCh. 21 - The power output of a car engine running at 2400...Ch. 21 - Prob. 8EAPCh. 21 - Prob. 9EAPCh. 21 - Prob. 10EAPCh. 21 - Prob. 11EAPCh. 21 - Prob. 12EAPCh. 21 - Prob. 13EAPCh. 21 - Prob. 14EAPCh. 21 - Prob. 15EAPCh. 21 - Prob. 16EAPCh. 21 - A heat engine uses a diatomic gas in a Brayton...Ch. 21 - At what pressure ratio does a Brayton cycle using...Ch. 21 - Prob. 19EAPCh. 21 - Prob. 20EAPCh. 21 - Prob. 21EAPCh. 21 - Prob. 22EAPCh. 21 - Prob. 23EAPCh. 21 - Prob. 24EAPCh. 21 - Prob. 25EAPCh. 21 - Prob. 26EAPCh. 21 - Prob. 27EAPCh. 21 - A Carnot engine whose hot-reservoir temperature is...Ch. 21 - Prob. 29EAPCh. 21 - A heat engine operating between energy reservoirs...Ch. 21 - Prob. 31EAPCh. 21 - A Carnot refrigerator operating between —20°C and...Ch. 21 - The coefficient of performance of a refrigerator...Ch. 21 - A Carnot heat engine with thermal efficiency 1/3...Ch. 21 - Prob. 35EAPCh. 21 - Prob. 36EAPCh. 21 - A heat engine with 50% of the Carnot efficiency...Ch. 21 - Prove that the work done in an adiabatic process i...Ch. 21 - Prob. 39EAPCh. 21 - Prob. 40EAPCh. 21 - An ideal refrigerator utilizes a Carnot cycle...Ch. 21 - Prob. 42EAPCh. 21 - There has long been an interest in using the vast...Ch. 21 - A Carnot heat engine operates between reservoirs...Ch. 21 - A Carnot engine operates between temperatures of...Ch. 21 - Prob. 46EAPCh. 21 - A Carnot heat engine and an ordinary refrigerator...Ch. 21 - 48. A heat engine running backward is called a...Ch. 21 - 49. A car's internal combustion engine can be...Ch. 21 - Prob. 50EAPCh. 21 - Prob. 51EAPCh. 21 - Prob. 52EAPCh. 21 - Prob. 53EAPCh. 21 - Prob. 54EAPCh. 21 - Prob. 55EAPCh. 21 - Prob. 56EAPCh. 21 - Prob. 57EAPCh. 21 - A heat engine using a monatomic gas follows the...Ch. 21 - Prob. 59EAPCh. 21 - Prob. 60EAPCh. 21 - Prob. 61EAPCh. 21 - Prob. 62EAPCh. 21 - Prob. 63EAPCh. 21 - Prob. 64EAPCh. 21 - Prob. 65EAPCh. 21 - Prob. 66EAPCh. 21 - Prob. 67EAPCh. 21 - Prob. 68EAPCh. 21 - Prob. 69EAPCh. 21 - Prob. 70EAPCh. 21 - A refrigerator using helium gas operates on the...Ch. 21 - Prob. 72EAPCh. 21 - The gasoline engine in your car can be modeled as...Ch. 21 - Prob. 74EAP
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A heat pump has a coefficient of performance equal to 4.20 and requires a power of 1.75 kW to operate. (a) How much energy does the heat pump add to a home in one hour? (b) If the heat pump is reversed so that it acts as an air conditioner in the summer, what would be its coefficient of performance?arrow_forward(a) How much food energy will a man metabolize in the process of doing 35.0 kJ of work with an efficiency of 5.00%? (b) How much heal transfer occurs to the environment to keep his temperature constant? Explicitly show how you follow the steps in the Problem—Solving Strategy for thermodynamics found in Problem-Solving Strategies for Thermodynamics.arrow_forwardA power plant has been proposed that would make use of the temperature gradient in the ocean. The system is to operate between 20.0C (surface water temperature) and 5.00C (water temperature at a depth of about 1 km). (a) What is the maximum efficiency of such a system? (b) If the useful power output of the plant is 75.0 MW, how much energy is absorbed per hour? (c) In view of your answer to part (a), do you think such a system is worthwhile (considering that there is no charge for fuel)?arrow_forward
- (a) How much heat transfer occurs to the environment by an electrical power station that uses 1.251014J of heat transfer into the engine with an efficiency of 42.0%? (b) What is the ratio of heat transfer to the environment to work output? (c) How much work is done?arrow_forward(a) What is the best coefficient of performance for a heat pump that has a hot reservoir temperature of 50.0C and a cold reservoir temperature of 20.0C ? (b) How much heat transfer occurs into the warm environment if 3.60107J of work (10.0kWh) is put into it? (c) If the cost of this work input is 10.0cent/kWh, haw does its cost compare with the direct heat transfer achieved by burning natural gas at a cost of 85.0 cents per therm. (A therm is a common unit of energy for natural gas and equals 1.055108J .)arrow_forwardA certain coal-fired power plant has a rated power capacity of P = 960 MW. The output of this plant is W = 0.39QH, where QH is the energy input as heat from the hot reservoir. a. Write an equation for the efficiency of a heat engine in terms of QH and the heat QC exhausted to a low-temperature reservoir. b. Which would increase the efficiency more, doubling QH or reducing QC by half? c. Calculate the maximum thermal efficiency of the power plant. d. Calculate the absolute value of the exhausted heat (QC) each second in MJ for the power plant.arrow_forward
- A power plant has been proposed that would make use of the temperature gradient in the ocean. They system is to operate between 24.0°C (surface water temperature) and 4.95°C (water temperature at a depth of about 1 km). a. What is the maximum efficiency of such a system? Describe the process that would be used to get this maximum efficiency. b. If the useful power output of the plant is 80.0 MW, how much energy is absorbed per hour?arrow_forwardA NATO base in northern Norway is warmed with a heat pump that uses 7.0°C ocean water as the cold reservoir. Heat extracted from the ocean water warms fluid to 80°C; this warmed fluid is used to heat the building. When the system is working at full capacity, 2000 kW of heat are delivered to the building at the cost of 600 kW of electrie energy. a. What is the actual coefficient of performance of the system? b. What is the theoretical maximum coefficient of performance of the system? а.arrow_forwardA heat pump moves heat from the chilly 8°C air outside a house to the toastier 21°C air inside. The actual coefficient of performance of the system is 3.2, a typical value. a. If the system adds 11 kJ to the house each second, how much electric energy is required?arrow_forward
- A 39% maximum efficient coal-fired power plant needs to produce 600 MW of power. A. To achieve maximum efficiency, if the waste water is dumped into a 13 degree Celsius lake, what temperature must the steam be heated to? B. Since coal contains 27 kJ of energy per gram, how many kg of coal must be burned in a day?arrow_forwardA California geothermal power plant generates 4.3 MW by extracting 24 MW of heat from an underground source at 108°C and then discharging waste heat into the 17°C air.a. What is the actual efficiency of the plant?b. What is the theoretical efficiency?arrow_forwardEach second, a nuclear power plant generates 2000 MJ of thermal energy from nuclear reactions in the reactor’s core. This energy is used to boil water and produce high-pressure steam at 300°C. The steam spins a turbine, which produces 700 MJ of electric power, then the steam is condensed and the water is cooled to 30°C before starting the cycle again.a. What is the maximum possible efficiency of the plant?b. What is the plant’s actual efficiency?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
College PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax College
College PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
Physics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
College Physics
Physics
ISBN:9781938168000
Author:Paul Peter Urone, Roger Hinrichs
Publisher:OpenStax College
College Physics
Physics
ISBN:9781285737027
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
Physics for Scientists and Engineers with Modern ...
Physics
ISBN:9781337553292
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Physics for Scientists and Engineers
Physics
ISBN:9781337553278
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
College Physics
Physics
ISBN:9781305952300
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
The Second Law of Thermodynamics: Heat Flow, Entropy, and Microstates; Author: Professor Dave Explains;https://www.youtube.com/watch?v=MrwW4w2nAMc;License: Standard YouTube License, CC-BY