The structural formulas for the repeating disaccharides unit of following polysaccharide alginic acid should be determined: Concept introduction: Within biochemistry, a conformational change is a change within the macromolecule’s shape, often induced through the environmental variables. It might alter its shape in reply to the alteration in its environment or the other variables. Each probable shape is recognized as conformation and the transition amid them is known as conformational change.

Question

Want to see the full answer?

Answer 1

Question

Chapter 20, Problem 20.50P

a.

Interpretation Introduction

Interpretation: The structural formulas for the repeating disaccharides unit of following polysaccharide alginic acid should be determined:

Concept introduction: Within biochemistry, a conformational change is a change within the macromolecule’s shape, often induced through the environmental variables. It might alter its shape in reply to the alteration in its environment or the other variables. Each probable shape is recognized as conformation and the transition amid them is known as conformational change.

b.

Interpretation Introduction

Interpretation: The structural formula for the repeating disaccharides should be determined for the polysaccharide pectic acid.

Concept introduction: Within biochemistry, a conformational change is a change within the macromolecule’s shape, often induced through the environmental variables. It might alter its shape in reply to the alteration in its environment or the other variables. Each probable shape is recognized as conformation and the transition amid them is known as conformational change.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

There is an instrument in Johnson 334 that measures total-reflectance x-ray fluorescence (TXRF) to do elemental analysis (i.e., determine what elements are present in a sample). A researcher is preparing a to measure calcium content in a series of well water samples by TXRF with an internal standard of vanadium (atomic symbol: V). She has prepared a series of standard solutions to ensure a linear instrument response over the expected Ca concentration range of 40-80 ppm. The concentrations of Ca and V (ppm) and the instrument response (peak area, arbitrary units) are shown below. Also included is a sample spectrum. Equation 1 describes the response factor, K, relating the analyte signal (SA) and the standard signal (SIS) to their respective concentrations (CA and CIS). Ca, ppm V, ppm SCa, arb. units SV, arb. units 20.0 10.0 14375.11 14261.02 40.0 10.0 36182.15 17997.10 60.0 10.0 39275.74 12988.01 80.0 10.0 57530.75 14268.54 100.0…

A mixture of 0.568 M H₂O, 0.438 M Cl₂O, and 0.710 M HClO are enclosed in a vessel at 25 °C. H₂O(g) + C₁₂O(g) = 2 HOCl(g) K = 0.0900 at 25°C с Calculate the equilibrium concentrations of each gas at 25 °C. [H₂O]= [C₁₂O]= [HOCI]= M Σ M

What units (if any) does the response factor (K) have? Does the response factor (K) depend upon how the concentration is expressed (e.g. molarity, ppm, ppb, etc.)?