A three-phase line, which has an impedance of ( 2 + j 4 ) Ω per phase, feeds two balanced three-phase loads that are connected in parallel. One of the loads is Y-connected with an impedance of ( 30 + j 40 ) Ω per phase, and the other is Δ -connected with an impedance of ( 60 − j 45 ) Ω per phase. The line is energized at the sending end from a 60-Hz, three-phase, balanced voltage source of 120 3 V (rms. line-to-line). Determine (a) the current, real power. and reactive power delivered by the sending-end source: (b) the line-to-line voltage at the load: (C) the current per phase in each load: and (d) the total three-phase real and reactive powers absorbed by each load and by the line. Check that the total three- phase complex power delivered by the source equals the total three-phase power absorbed by the line and loads.
A three-phase line, which has an impedance of ( 2 + j 4 ) Ω per phase, feeds two balanced three-phase loads that are connected in parallel. One of the loads is Y-connected with an impedance of ( 30 + j 40 ) Ω per phase, and the other is Δ -connected with an impedance of ( 60 − j 45 ) Ω per phase. The line is energized at the sending end from a 60-Hz, three-phase, balanced voltage source of 120 3 V (rms. line-to-line). Determine (a) the current, real power. and reactive power delivered by the sending-end source: (b) the line-to-line voltage at the load: (C) the current per phase in each load: and (d) the total three-phase real and reactive powers absorbed by each load and by the line. Check that the total three- phase complex power delivered by the source equals the total three-phase power absorbed by the line and loads.
A three-phase line, which has an impedance of
(
2
+
j
4
)
Ω
per phase, feeds two balanced three-phase loads that are connected in parallel. One of the loads is Y-connected with an impedance of
(
30
+
j
40
)
Ω
per phase, and the other is
Δ
-connected with an impedance of
(
60
−
j
45
)
Ω
per phase. The line is energized at the sending end from a 60-Hz, three-phase, balanced voltage source of
120
3
V
(rms. line-to-line). Determine (a) the current, real power. and reactive power delivered by the sending-end source: (b) the line-to-line voltage at the load: (C) the current per phase in each load: and (d) the total three-phase real and reactive powers absorbed by each load and by the line. Check that the total three- phase complex power delivered by the source equals the total three-phase power absorbed by the line and loads.
In the zone refining of silicon, an RF-heater is used to remove trace amounts of impuritiesfrom the silicon. If the silicon has the impurity of 10^14 Co (k = 8*10^-6) what is the purityof the crystal after one pass of the zone refiner? After two passes? Plot concentration as afunction of crystal length from 0 to 8ft (total length of the crystal). The width of the moltenzone is 5”.
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.