Concept explainers
(a)
The mass per unit length of the guitar string.
(a)
Answer to Problem 79PQ
The mass per unit length of the guitar string is
Explanation of Solution
Write the expression for volume of the wire.
Here,
The wire has a circular cross section.
Write the expression for cross sectional area of wire.
Here,
Use equation (II) in (I).
Write the expression for linear mass density of the wire.
Here,
Rewrite equation (I) to find
Use above equation in (IV).
Use equation (II) in (V).
Write the expression for density of the wire.
Here,
Use equation (VII) in (VI).
Write the expression to find radius of the wire.
Here,
Conclusion:
Substitute
Substitute
Therefore, the mass per unit length of the guitar string is
(b)
The tension in the guitar string.
(b)
Answer to Problem 79PQ
The tension in the guitar string is
Explanation of Solution
Write the expression for the fundamental frequency of vibration of the guitar string.
Here,
Write the expression to find the speed of the waves in terms of the tension and mass density of the wire.
Here,
Use above expression in equation (X).
Solve equation (XI) for
Conclusion:
Substitute
Therefore, the tension in the guitar string is
(c)
The tension in the guitar string if the temperature is increased to
(c)
Answer to Problem 79PQ
The tension in the guitar string if the temperature is increased to
Explanation of Solution
Write the expression to find the unstressed length of the guitar string at
Here,
Solve equation (XIII) to find
Write the expression to find the unstressed length at
Here,
Write the equation to find the scale length of the string.
Here,
Solve equation (XVI) for
Conclusion:
Substitute
Substitute
Substitute
Substitute
Therefore, the tension in the guitar string if the temperature is increased to
(d)
The fundamental frequency of guitar string at
(d)
Answer to Problem 79PQ
The fundamental frequency of guitar string at
Explanation of Solution
Write the expression for the ratio of frequency at
Here,
Solve equation (XVIII) for
Conclusion:
Substitute
Therefore, the fundamental frequency of guitar string at
Want to see more full solutions like this?
Chapter 19 Solutions
Physics for Scientists and Engineers: Foundations and Connections
- No chatgpt pls will upvotearrow_forward13.87 ... Interplanetary Navigation. The most efficient way to send a spacecraft from the earth to another planet is by using a Hohmann transfer orbit (Fig. P13.87). If the orbits of the departure and destination planets are circular, the Hohmann transfer orbit is an elliptical orbit whose perihelion and aphelion are tangent to the orbits of the two planets. The rockets are fired briefly at the depar- ture planet to put the spacecraft into the transfer orbit; the spacecraft then coasts until it reaches the destination planet. The rockets are then fired again to put the spacecraft into the same orbit about the sun as the destination planet. (a) For a flight from earth to Mars, in what direction must the rockets be fired at the earth and at Mars: in the direction of motion, or opposite the direction of motion? What about for a flight from Mars to the earth? (b) How long does a one- way trip from the the earth to Mars take, between the firings of the rockets? (c) To reach Mars from the…arrow_forwardNo chatgpt pls will upvotearrow_forward
- a cubic foot of argon at 20 degrees celsius is isentropically compressed from 1 atm to 425 KPa. What is the new temperature and density?arrow_forwardCalculate the variance of the calculated accelerations. The free fall height was 1753 mm. The measured release and catch times were: 222.22 800.00 61.11 641.67 0.00 588.89 11.11 588.89 8.33 588.89 11.11 588.89 5.56 586.11 2.78 583.33 Give in the answer window the calculated repeated experiment variance in m/s2.arrow_forwardNo chatgpt pls will upvotearrow_forward
- 2. Consider the situation described in problem 1 where light emerges horizontally from ground level. Take k = 0.0020 m' and no = 1.0001 and find at which horizontal distance, x, the ray reaches a height of y = 1.5 m.arrow_forward2-3. Consider the situation of the reflection of a pulse at the interface of two string described in the previous problem. In addition to the net disturbances being equal at the junction, the slope of the net disturbances must also be equal at the junction at all times. Given that p1 = 4.0 g/m, H2 = 9.0 g/m and Aj = 0.50 cm find 2. A, (Answer: -0.10 cm) and 3. Ay. (Answer: 0.40 cm)please I need to show all work step by step problems 2 and 3arrow_forwardFrom number 2 and 3 I just want to show all problems step by step please do not short cut look for formulaarrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning