The total number of protons coupled to the proton that gave rise to the signal shown is to be determined. Concept introduction: The nmr signal of a particular proton may be split into a number of peaks by nearby protons. These are typically protons that are present three bonds away from the proton of interest. If these (coupled) protons are structurally similar, then the number of peaks into which the signal is split equals n+1 where n is the number of coupled protons. When a proton is coupled to more than one type of structurally distinct protons, the splitting pattern cannot be predicted by the n+1 rule. Each structurally distinct coupled proton independently splits the signal. In effect, the splitting by one type is superimposed on the splitting by the other.

Question

Want to see the full answer?

Answer 1

Question

Chapter 16, Problem 16.61P

Interpretation Introduction

Interpretation:

The total number of protons coupled to the proton that gave rise to the signal shown is to be determined.

Concept introduction:

The nmr signal of a particular proton may be split into a number of peaks by nearby protons. These are typically protons that are present three bonds away from the proton of interest. If these (coupled) protons are structurally similar, then the number of peaks into which the signal is split equals n+1 where n is the number of coupled protons.

When a proton is coupled to more than one type of structurally distinct protons, the splitting pattern cannot be predicted by the n+1 rule. Each structurally distinct coupled proton independently splits the signal. In effect, the splitting by one type is superimposed on the splitting by the other.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Q1: Answer the questions for the reaction below: ..!! Br OH a) Predict the product(s) of the reaction. b) Is the substrate optically active? Are the product(s) optically active as a mix? c) Draw the curved arrow mechanism for the reaction. d) What happens to the SN1 reaction rate in each of these instances: 1. Change the substrate to Br "CI 2. Change the substrate to 3. Change the solvent from 100% CH3CH2OH to 10% CH3CH2OH + 90% DMF 4. Increase the substrate concentration by 3-fold.

Experiment 27 hates & Mechanisms of Reations Method I visual Clock Reaction A. Concentration effects on reaction Rates Iodine Run [I] mol/L [S₂082] | Time mo/L (SCC) 0.04 54.7 Log 1/ Time Temp Log [ ] 13,20] (time) / [I] 199 20.06 23.0 30.04 0.04 0.04 80.0 22.8 45 40.02 0.04 79.0 21.6 50.08 0.03 51.0 22.4 60-080-02 95.0 23.4 7 0.08 0-01 1970 23.4 8 0.08 0.04 16.1 22.6

(15 pts) Consider the molecule B2H6. Generate a molecular orbital diagram but this time using a different approach that draws on your knowledge and ability to put concepts together. First use VSEPR or some other method to make sure you know the ground state structure of the molecule. Next, generate an MO diagram for BH2. Sketch the highest occupied and lowest unoccupied MOs of the BH2 fragment. These are called frontier orbitals. Now use these frontier orbitals as your basis set for producing LGO's for B2H6. Since the BH2 frontier orbitals become the LGOS, you will have to think about what is in the middle of the molecule and treat its basis as well. Do you arrive at the same qualitative MO diagram as is discussed in the book? Sketch the new highest occupied and lowest unoccupied MOs for the molecule (B2H6).