Principles of Instrumental Analysis
7th Edition
ISBN: 9781305577213
Author: Douglas A. Skoog, F. James Holler, Stanley R. Crouch
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Question
Chapter 16, Problem 16.14QAP
Interpretation Introduction
Interpretation:
The number of interferograms that have to be collected and averaged if goal is to obtain an
Concept introduction:
Interferometry refers to the technique of superposition of the
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
A solution with a known concentration equal to 3.4 mM gave an absorbance reading of 0.820 in a spectrophotometer. Assuming that there is a linear relationship between concentration and absorbance up to a concentration of 4.0 mM, what would the absorbance reading be for a solution with a concentration 2.2 mM?
Suppose a student is preparing a set of standard solutions for use in a spectrophotometric study. If percent transmittance,
%T, were measured in the standard solutions before the color had a chance to fully develop, the measured value would be
compared with solutions that have allowed the color to fully develop.
The validation process comprises four main steps that are : hardware validation, software validation, method validation and system suitability. To evaluate a spectrophotometer’s accuracy by measuring absorbance, a solution of 60.06 mg/L K2Cr2O7 in 0.0050M H2SO4 was carefully prepared together with a 0.0050 M H2SO4 as a reagent blank. If the spectrometer’s signal is properly calibrated, it has been reported that this solution should provide an absorbance of 0.640 +- 0.010 at wavelength 350 nm. Which one of the validations mentioned above had been involved in this process? Explain your choice
Chapter 16 Solutions
Principles of Instrumental Analysis
Knowledge Booster
Similar questions
- What are the main components of a spectrophotometer? Choose all that applies. radiation source sample compartment/holder monochromator detectorarrow_forwardBased on the data in the table, determine the original concentration of Na+ and its uncertainty in the unknown sample. Report the uncertainty with three significant figures.arrow_forwardN 2arrow_forward
- Atomic emission spectroscopy and the method of standard addition are used to determine the Na+ concentration and its uncertainty in an unknown sample. Increasing amounts of a 1.75 ug/mL standard Na+ solution are added to a series of volumetric flasks containing 15.00 mL of the unknown solution. The volumetric flasks are then diluted to a final volume of 200.0 mL. Atomic emission spectroscopy is then used to measure the emission intensity of each solution. Unknown volume Standard volume Final volume Emission (mL) (mL) (mL) intensity 15.00 0.00 200.0 351.0 15.00 5.00 200.0 494.0 15.00 10.00 200.0 642.0 15.00 15.00 200.0 807.0 15.00 20.00 200.0 948.0 Based on the data in the table, determine the original concentration of Nat and its uncertainty in the unknown sample. Report the uncertainty with three significant figures. concentration: ug/mL µg/mLarrow_forward3.35 mm to cm-1arrow_forwardWhat is the absorbance of a solution if it had 79.5% transmittance?arrow_forward
- A student mixed 5.00mL of 0.0020M Fe(NO3)3, 3.00mL of 0.0020M KSCN, and 3.00mL of distilled water. The mixture reacted to form a reddish solution indicating that FeSCN2+ was formed, according to the equation below. An absorbance of 0.21 was measured for this solution in a Spectrophotometer set at a wavelength of 447nm. Fe³+ (aq) + SCN (aq) FeSCN2+ (aq) A calibration curve was used to find the equilibrium concentration of the product of this reaction: y = 1895x + 0.027 Calculate the equilibrium concentration of the Fe³+ Report your answer to 4 sig figsarrow_forward1-Describe the principle of optical rotation method and refraction method. Which one is better for detecting the concentration of glucose solution? 2-What is the basic principle of eliminating interference absorption by dual-wavelength spectrophotometry?arrow_forward3arrow_forward
- The maximum number of spectra that can be recorded per second by ToF-MS is limited by the time taken by the slowest ions to go from the source to the detector. If the slowest ion took 45.6 microsecond to travel, at what frequency could you record spectra if a new extraction cycle were begun each time this heaviest ion reached the detector? 30000 spectra/s 10000 spectra/s 11000 spectra/s 500 spectra/s 22000 spectra/sarrow_forwardExplain the principles of UV-Vis Spectrometerarrow_forwardA student creates a sports drink by dissolving 5.0 g of powder in 250 mL of water. The green colour of the drink is due to the presence Green Dye X, which has a lambdamax of 630 nm. A calibration curve (absorbance versus concentration) at lambdamax is created for varying concentrations (mM) of Green Dye X which has the equation y = 26.8x. If 1.0 mL of the sports drink is diluted to 10. mL with water, then the absorbance is measured to be 0.340, what is the mass percent of Green Dye X in the drink powder if the molecular weight is 418.4 g mol-1?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Principles of Instrumental AnalysisChemistryISBN:9781305577213Author:Douglas A. Skoog, F. James Holler, Stanley R. CrouchPublisher:Cengage LearningPrinciples of Modern ChemistryChemistryISBN:9781305079113Author:David W. Oxtoby, H. Pat Gillis, Laurie J. ButlerPublisher:Cengage Learning
Principles of Instrumental Analysis
Chemistry
ISBN:9781305577213
Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch
Publisher:Cengage Learning
Principles of Modern Chemistry
Chemistry
ISBN:9781305079113
Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler
Publisher:Cengage Learning