Component: The items from toolbox which appear in a program’s graphical user interface are referred as components. The GUI components are also referred as control and widgets. Some of the common GUI components are listed below: Button – Button is a component which causes action to occur at that time of user click that button. Label – Label is place which displays the text. Text box – Text box is an area to type the single line input from user. Check box – Check box is a component which is like a box that can be checked or unchecked. Radio button – Radio button is a component which can be either select or deselect the button. Combo box – Combo box is a component which is displays the list of item in drop-down format. List box – List box is a component display the list of items. Slider – Slider is a component which enables the user to choose a value by moving slider.

Question

Want to see the full answer?

Answer 1

Question

Chapter 15, Problem 4SA

Program Plan Intro

Component:

The items from toolbox which appear in a program’s graphical user interface are referred as components.

The GUI components are also referred as control and widgets.

Some of the common GUI components are listed below:

Button – Button is a component which causes action to occur at that time of user click that button.

Label – Label is place which displays the text.

Text box – Text box is an area to type the single line input from user.

Check box – Check box is a component which is like a box that can be checked or unchecked.

Radio button – Radio button is a component which can be either select or deselect the button.

Combo box – Combo box is a component which is displays the list of item in drop-down format.

List box – List box is a component display the list of items.

Slider – Slider is a component which enables the user to choose a value by moving slider.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

15 points Save ARS Consider the following scenario in which host 10.0.0.1 is communicating with an external SMTP mail server at IP address 128.119.40.186. NAT translation table WAN side addr LAN side addr (c), 5051 (d), 3031 S: (e),5051 SMTP B D (f.(g) 10.0.0.4 server 138.76.29.7 128.119.40.186 (a) is the source IP address at A, and its value. S: (a),3031 D: (b), 25 10.0.0.1 A 10.0.0.2. 1. 138.76.29.7 10.0.0.3

6.3A-3. Multiple Access protocols (3). Consider the figure below, which shows the arrival of 6 messages for transmission at different multiple access wireless nodes at times t=0.1, 1.4, 1.8, 3.2, 3.3, 4.1. Each transmission requires exactly one time unit. 1 t=0.0 2 3 45 t=1.0 t-2.0 t-3.0 6 t=4.0 t-5.0 For the CSMA protocol (without collision detection), indicate which packets are successfully transmitted. You should assume that it takes .2 time units for a signal to propagate from one node to each of the other nodes. You can assume that if a packet experiences a collision or senses the channel busy, then that node will not attempt a retransmission of that packet until sometime after t=5. Hint: consider propagation times carefully here. (Note: You can find more examples of problems similar to this here B.] ☐ U ப 5 - 3 1 4 6 2

Just wanted to know, if you had a scene graph, how do you get multiple components from a specific scene node within a scene graph? Like if I wanted to get a component from wheel from the scene graph, does that require traversing still? Like if a physics component requires a transform component and these two component are part of the same scene node. How does the physics component knows how to get the scene object's transform it is attached to, this being in a scene graph?