(a)
Interpretation:
Based on the information given in the question statement, the three liquids, kerosene, linseed oil and water has to be listed in order of increasing density.
Concept Introduction:
Density:
The ratio of mass of a sample to its volume is said to be the density.
(b)
Interpretation:
If
Concept Introduction:
Refer to part (a).
(c)
Interpretation:
If
Concept Introduction:
Refer to part (a).
Trending nowThis is a popular solution!
Chapter 1 Solutions
Chemistry: The Molecular Science
- Chemistry (b) A sampling plan is necessary to ensure that a laboratory sample is truly a representative of the entire population. (i) Describe the goals of the sampling plan. "It is possible to determine whether the population is homogeneous or heterogeneous if a single sample is collected and analyzed." Comment on this statement. (ii)arrow_forward1. (a) How many kilometers/min does a car go if it goes 52 miles/hour? (b) What number of inches is 0.09 miles? (c) What number of μm are in 1.116 cm?arrow_forwardQUESTION 2 (a) 0.250 ug/um³ mg/mL (Show your calculations) What method did you use to perform the calculation? (b) 37 °C = K = oF (Show your calculations) (c) In an experiment, a student determined the mass of iron in an unknown biological sample. From the experiment, the student found 49.90 mg of iron. (i) What type of balance do you think the student used? (ii) In general, what are the two common methods of measuring mass in the laboratory? and (iii) If the % experimental error was 0.20%, What was the actual mass of the iron in the sample? (Assume that the actual mass was larger than the mass determined by the student). Show your calculations. (d) Consider a 15.0-g sample of a potassium salt. This compound is 32.86% by mass of potassium. Calculate the number of potassium ions present in this sample.arrow_forward
- A pediatrician writes a prescription for “diphenhydramine 7.5 mg PO Q 6 hours × 7 days” for a child who experienced an allergic reaction. If each teaspoon of the commercially available syrup contains 12.5 mg of diphenhydramine, what volume of syrup should be dispensed, in milliliters? Round UP to the nearest 5-mL increment.arrow_forward(b) Now suppose you measure 15.00 mL of the Methyl Orange stock solution using a 250-mL Class B graduated cylinder, then you add deionized water up to the 100.0 mL line. What is the concentration uncertainty of the diluted solution in mg/L?arrow_forward10. Give the number of the diagram below that represents a particulate view of (a) a mixture of gaseous neon with liquid bromine (bromine is a diatomic molecule) (b) a liquid element (c) a homogeneous gaseous mixture 1 O 2 DOO DOO 3 4 5arrow_forward
- Calculate these masses.(a) What is the mass of 6.00 cm3 of mercury, density = 13.5939 g/cm3?(b) What is the mass of 25.0 mL octane, density = 0.702 g/cm3?arrow_forwardIn 2009, a team from Northwestern University and WesternWashington University reported the preparation of a new“spongy” material composed of nickel, molybdenum, andsulfur that excels at removing mercury from water. The densityof this new material is 0.20 g/cm3, and its surface area is1242 m2 per gram of material. (a) Calculate the volume of a10.0-mg sample of this material. (b) Calculate the surface area fora 10.0-mg sample of this material. (c) A 10.0-mL sample of contaminatedwater had 7.748 mg of mercury in it. After treatmentwith 10.0 mg of the new spongy material, 0.001 mg of mercuryremained in the contaminated water. What percentage of themercury was removed from the water? (d) What is the final massof the spongy material after the exposure to mercury?arrow_forward2. a) The ingredients contained in grape Kool-Aid can be approximated as: water (H2O, density = 1.000 g/mL), sugar (sucrose, solid at room temperature, C12H22011), citric acid (solid at room temperature, CsHsO7), and grape flavouring (methyl anthranilate, liquid at room temperature, CaH9NO2, density = 1.168 g/mL). (The blue and red dyes used to produce the purple colour are present in such small quantities that they can be ignored.) A sample of grape Kool-aid having a final total volume of 500 mL can be prepared from: 485 mL of water, 32.0 g of sugar, 5.00 g of citric acid, and 3.50 g or grape flavouring. Calculate the molarity and molality of grape flavouring in this mixture (assume that only water is the solvent).arrow_forward
- Convert 3.25 × 103 terameters (Tm) into nanometers (nm).arrow_forwardplease see attached imagearrow_forwardDistilling a red liquid physically separates it into a red solid and a clear, colorless liquid. The red liquid is (A) an element. (B) a compound. (C) a pure substance. (D) a solution.arrow_forward
- Introductory Chemistry: An Active Learning Approa...ChemistryISBN:9781305079250Author:Mark S. Cracolice, Ed PetersPublisher:Cengage Learning