BASIC BIOMECHANICS
8th Edition
ISBN: 9781259913877
Author: Hall
Publisher: RENT MCG
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 13, Problem 8AP
A man carries a 3 m, 32-N board over his shoulder. If the board extends 1.8 m behind the shoulder and 1.2 m in front of the shoulder, how much force must the man apply vertically downward with his hand that rests on the board 0.2 m in front of the shoulder to stabilize the board in this position? (Assume that the weight of the board is evenly distributed throughout its length.) (Answer: 48 N)
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
With the shoulder flexed at 30°, the moment arm of the deltoid muscle is 2.0 cm. Solve
for the force exerted by the deltoid muscle at the glenohumeral joint give the following
assumptions:
The deltoid is the only active muscle at the glenohumeral joint
The weight of the humerus is 48 N.
The center of gravity of the humerus is located 30 cm from the shoulder center of
rotation
STATIC EQUILIBRIUM EQUATIONS
CONSIDERING ONLY THE DELTOID MUSCLE
Fo
MA =
18 Cn
COR
B=55".
0-30°
RaF 30 cm
FG = 24 N
Please help with the pictures given a sketch for each bullet point and with the calculations.
5 of 10
Which of the following exercises would be an example of a Stabilization-Focused exercise for the shoulders?
Standing cable row
Bench press
Single-leg dumbell overhead press
shoulder press machine
Next ▶
Chapter 13 Solutions
BASIC BIOMECHANICS
Ch. 13 - Why does a force directed through an axis of...Ch. 13 - Why does the orientation of a force acting on a...Ch. 13 - A 23-kg boy sits 1.5 m from the axis of rotation...Ch. 13 - Prob. 4IPCh. 13 - Two people push on opposite sides of a swinging...Ch. 13 - Prob. 6IPCh. 13 - Prob. 7IPCh. 13 - Prob. 8IPCh. 13 - A 10-kg block sits motionless on a table in spite...Ch. 13 - Prob. 10IP
Ch. 13 - A 35-N hand and forearm are held at a 45 angle to...Ch. 13 - A hand exerts a force of 90 N on a scale at 32 cm...Ch. 13 - A patient rehabilitating a knee injury performs...Ch. 13 - A worker leans over and picks up a 90-N box at a...Ch. 13 - A man carries a 3 m, 32-N board over his shoulder....Ch. 13 - A therapist applies a lateral force of 80 N to the...Ch. 13 - Tendon forces Ta and Tb are exerted on the...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, bioengineering and related others by exploring similar questions and additional content below.Similar questions
- Two lifter's knees are of interest at a specific moment in their lifts. In both lifts, the knee extensor torque is 100 Nm, requiring quadriceps tendon/patella ligament forces of 1000 N (about 220 Ibs). Despite equivalent knee torques and quadriceps forces, patellofemoral joint forces are higher on the knees of lifter A. Briefly explain why. Edit View Insert Format Tools Table 12pt v Paragraph v BIUAarrow_forwardGiven the following ankle and knee coordinates calculate the partial internal knee angle to 1 decimal place Ankle z 0.129 m Ankle x 0.37 m Knee z 0.409 m Knee x 0.522 m Answer: re to search 8: T G B N W 8 M 9 O Pa P 4 3°C℃ Partly cloudyarrow_forwardIf a person has a vertical force of 10.25N with a nylon strap of a 2.5cm of width and length of 10cm in the trapezius muscle, how much time does the person need to feel pain in the muscle? How much time is needed to injure or damage the muscle? Must show every mathematical process.arrow_forwardTotal compressive knee forces range between O 1-2 %BW O 2-4 %BW 3-5 %BW 0.5-1.5 %BWarrow_forward2. a) Label the system provided below, including the reference frame, moment arms and vector forces with the information provided. Internal moment arm = 4cm +0.04m External moment arm relative to the segment weight = 25cm 0.25m External moment arm relative to the load weight = 45cm 40.45m Segment weight = 50 N Load weight = 100 N Lower leg segment angle relative to horizontal plane = 45° Quadriceps tendon angle = 45° Axis of rotation MF SW LW 2b) Using the figure in 2a., calculate the external torque of the system relative to the normal component of segment and load weights listed above. 2c) Calculate the amount of both the tangential component of the muscle force and the muscle force itself required to keep this system in a state of static equilibrium.arrow_forward< The three main forces that act on the patella are shown on the diagram of the knee joint below. These forces are the quadriceps muscle force (FQ), the patella ligament force (FPL), and the patellofemoral joint reaction force (FPF). The angles a and ẞ are with respect to a line that is perpendicular to FPF. Assuming a = 15°, ẞ = 20°, and FQ = 3725 N, use equations for static equilibrium to calculate (a) FPL, and (b) FPF. (Hint: To solve this problem consider using a coordinate system that is aligned with the principal axes of the patella instead of the usual vertical and horizontal axes). (c) Many people assume FQ and FPL are always equal in magnitude but this is only true under certain circumstances. Under what conditions are FQ and FPL equal in magnitude? Fo FPF FP B GriffithUNIVERSITY Queensland Australiaarrow_forwardCompare your results for the 3 conditions (see figure 1 above): Extend hand with no weight Extend hand with weight Flex hand with weightarrow_forwardA) Describe the difference between strength and power during a squat. Provide a quantitative example that illustrates the difference. B) During a squat, the weight you have on your shoulders has a certain amount of gravitational potential energy. As you squat down and come to a stop at the bottom of the squat, some of that energy is lost. Where does it go?arrow_forwardFor each of the activities shown, describe the movement using the proper terminology. Describe the movement in stages, using: the axis the plane the terms of movementarrow_forwardIf your biceps brachii muscle attaches to your forearm 2 inches below your elbow, the distance from the elbow to the palm of your hand is 18 inches, and you lift a 20 pound weight, how much pull must your muscle exert to achieve elbow flexion? If your biceps brachii muscle attaches to your forearm 2 inches below your elbow, the distance from the elbow to the palm of your hand is 18 inches, and you lift a 20 pound weight, how much pull must your muscle exert to achieve elbow flexion? hhharrow_forwardGIVE 3 EXERCISES THAT CAN BE CONSIDERED AS A LOCOMOTOR MOVEMENT WITH ABDUCTION AND ADDUCTION MOVEMENT. WHY?arrow_forwardExplain the answer biomechanicallyarrow_forwardarrow_back_iosSEE MORE QUESTIONSarrow_forward_ios
Recommended textbooks for you
- Anatomy & PhysiologyBiologyISBN:9781938168130Author:Kelly A. Young, James A. Wise, Peter DeSaix, Dean H. Kruse, Brandon Poe, Eddie Johnson, Jody E. Johnson, Oksana Korol, J. Gordon Betts, Mark WomblePublisher:OpenStax CollegePrinciples Of Radiographic Imaging: An Art And A ...Health & NutritionISBN:9781337711067Author:Richard R. Carlton, Arlene M. Adler, Vesna BalacPublisher:Cengage Learning
Anatomy & Physiology
Biology
ISBN:9781938168130
Author:Kelly A. Young, James A. Wise, Peter DeSaix, Dean H. Kruse, Brandon Poe, Eddie Johnson, Jody E. Johnson, Oksana Korol, J. Gordon Betts, Mark Womble
Publisher:OpenStax College
Principles Of Radiographic Imaging: An Art And A ...
Health & Nutrition
ISBN:9781337711067
Author:Richard R. Carlton, Arlene M. Adler, Vesna Balac
Publisher:Cengage Learning
GCSE PE - ANTAGONISTIC MUSCLE ACTION - Anatomy and Physiology (Skeletal and Muscular System - 1.5); Author: igpe_complete;https://www.youtube.com/watch?v=6hm_9jQRoO4;License: Standard Youtube License