The reason for the increase in the volume of solution and the decrease in the volume of water is to be determined. Concept introduction: The solution is a homogeneous mixture of two or more substances. It can exist in any of the phases. Saltwater, rubbing alcohol, bleach, and air are some examples of solutions. It has two components: solute and solvent. The solute is the substance that is present in smaller quantity and gets itself dissolved in the other substance. The solvent is the substance that is present in a larger amount and it dissolves solute in itself. The characteristics of the solution are as follows: 1. It is a homogeneous mixture of two or more substances. 2. The particles of solute can never be seen by the naked eye. 3. It does not allow the light beam to scatter. 4. It is stable. 5. The components of the solution cannot be separated by filtration. 6. It is composed of one phase only.

Question

Want to see the full answer?

Answer 1

Question

Chapter 13, Problem 13.143P

Interpretation Introduction

Interpretation:

The reason for the increase in the volume of solution and the decrease in the volume of water is to be determined.

Concept introduction:

The solution is a homogeneous mixture of two or more substances. It can exist in any of the phases. Saltwater, rubbing alcohol, bleach, and air are some examples of solutions. It has two components: solute and solvent. The solute is the substance that is present in smaller quantity and gets itself dissolved in the other substance. The solvent is the substance that is present in a larger amount and it dissolves solute in itself.

The characteristics of the solution are as follows:

1. It is a homogeneous mixture of two or more substances.

2. The particles of solute can never be seen by the naked eye.

3. It does not allow the light beam to scatter.

4. It is stable.

5. The components of the solution cannot be separated by filtration.

6. It is composed of one phase only.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

There is an instrument in Johnson 334 that measures total-reflectance x-ray fluorescence (TXRF) to do elemental analysis (i.e., determine what elements are present in a sample). A researcher is preparing a to measure calcium content in a series of well water samples by TXRF with an internal standard of vanadium (atomic symbol: V). She has prepared a series of standard solutions to ensure a linear instrument response over the expected Ca concentration range of 40-80 ppm. The concentrations of Ca and V (ppm) and the instrument response (peak area, arbitrary units) are shown below. Also included is a sample spectrum. Equation 1 describes the response factor, K, relating the analyte signal (SA) and the standard signal (SIS) to their respective concentrations (CA and CIS). Ca, ppm V, ppm SCa, arb. units SV, arb. units 20.0 10.0 14375.11 14261.02 40.0 10.0 36182.15 17997.10 60.0 10.0 39275.74 12988.01 80.0 10.0 57530.75 14268.54 100.0…

A mixture of 0.568 M H₂O, 0.438 M Cl₂O, and 0.710 M HClO are enclosed in a vessel at 25 °C. H₂O(g) + C₁₂O(g) = 2 HOCl(g) K = 0.0900 at 25°C с Calculate the equilibrium concentrations of each gas at 25 °C. [H₂O]= [C₁₂O]= [HOCI]= M Σ M

What units (if any) does the response factor (K) have? Does the response factor (K) depend upon how the concentration is expressed (e.g. molarity, ppm, ppb, etc.)?