The reason for the higher solubility of hydrogen chloride gas than propane gas in spite of its lower boiling point in water is to determined. Concept introduction: Solubility is the chemical property of any substance due to which it dissolves in other substances. It is measured in terms of the maximum amount of solute that can be dissolved in the given amount of solvent. It depends on the intermolecular forces between the molecules. The stronger the intermolecular forces, the higher will be the solubility. Boiling point is the temperature at which the vapor pressure of the liquid becomes equal to the atmospheric pressure and the liquid changes to vapors. It depends on the number of carbon chains present in the molecule, branching, functional groups present in the molecule.

Question

Want to see the full answer?

Answer 1

Question

Chapter 13, Problem 13.6P

Interpretation Introduction

Interpretation:

The reason for the higher solubility of hydrogen chloride gas than propane gas in spite of its lower boiling point in water is to determined.

Concept introduction:

Solubility is the chemical property of any substance due to which it dissolves in other substances. It is measured in terms of the maximum amount of solute that can be dissolved in the given amount of solvent. It depends on the intermolecular forces between the molecules. The stronger the intermolecular forces, the higher will be the solubility.

Boiling point is the temperature at which the vapor pressure of the liquid becomes equal to the atmospheric pressure and the liquid changes to vapors. It depends on the number of carbon chains present in the molecule, branching, functional groups present in the molecule.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

There is an instrument in Johnson 334 that measures total-reflectance x-ray fluorescence (TXRF) to do elemental analysis (i.e., determine what elements are present in a sample). A researcher is preparing a to measure calcium content in a series of well water samples by TXRF with an internal standard of vanadium (atomic symbol: V). She has prepared a series of standard solutions to ensure a linear instrument response over the expected Ca concentration range of 40-80 ppm. The concentrations of Ca and V (ppm) and the instrument response (peak area, arbitrary units) are shown below. Also included is a sample spectrum. Equation 1 describes the response factor, K, relating the analyte signal (SA) and the standard signal (SIS) to their respective concentrations (CA and CIS). Ca, ppm V, ppm SCa, arb. units SV, arb. units 20.0 10.0 14375.11 14261.02 40.0 10.0 36182.15 17997.10 60.0 10.0 39275.74 12988.01 80.0 10.0 57530.75 14268.54 100.0…

A mixture of 0.568 M H₂O, 0.438 M Cl₂O, and 0.710 M HClO are enclosed in a vessel at 25 °C. H₂O(g) + C₁₂O(g) = 2 HOCl(g) K = 0.0900 at 25°C с Calculate the equilibrium concentrations of each gas at 25 °C. [H₂O]= [C₁₂O]= [HOCI]= M Σ M

What units (if any) does the response factor (K) have? Does the response factor (K) depend upon how the concentration is expressed (e.g. molarity, ppm, ppb, etc.)?