EBK PHYSICS FOR SCIENTISTS AND ENGINEER
9th Edition
ISBN: 9780100460300
Author: SERWAY
Publisher: YUZU
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 12, Problem 12.50AP
Why is the following situation impossible? A worker in a factory pulls a cabinet across the floor using a rope as shown in Figure P12.36a. The rope make an angle θ = 37.0° with the floor and is tied h1 = 10.0 cm from the bottom of the cabinet. The uniform rectangular cabinet has height ℓ = 100 cm and width w = 60.0 cm, and it weighs 400 N. The cabinet slides with constant speed when a force F = 300 N is applied through the rope. The worker tires of walking backward. He fastens the rope to a point on the cabinet h2 = 65.0 cm off the floor and lays the rope over his shoulder so that he can walk forward and pull as shown in Figure P12.36b. In this way, the rope again makes an angle of θ = 37.0° with the horizontal and again has a tension of 300 N. Using this technique, the worker is able to slide the cabinet over a long distance on the floor without tiring.
Figure P12.36 Problems 36 and 44.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
A uniform spool is suspended from a vertical wall by a string attached to the spool’s thin axle. The axle is horizontal, as shown below.
The wall is smooth, so it exerts no frictional force on the spool. The tension in the string is 2.6 N. What is the weight of the spool?
a
1.2 N
b
1.0 N
c
0.5 N
d
2.4 N
e
2.6 N
It's exciting watching the construction and renovation happening in Uptown
Columbus! On one construction site, you notice that a uniform beam of length 13.6
m and mass 47.9 kg is attached to a wall by a cable. The angle between the cable
and the beam is 59.5°. The beam is free to pivot about the point where it attaches to
the wall. What is the tension in the cable, if the beam is not moving?
Your Answer:
Answer
A 12-kg, 1.0-m-long uniform beam is attached to a wall by a cable. The beam is free to pivot at the point where it attaches to the wall. However, it remains motionless.
What is the magnitude of the tension force in the cable?
Chapter 12 Solutions
EBK PHYSICS FOR SCIENTISTS AND ENGINEER
Ch. 12 - Consider the object subject to the two forces of...Ch. 12 - Consider the object subject to the three forces in...Ch. 12 - A meterstick of uniform density is hung from a...Ch. 12 - For the three parts of this Quick Quiz, choose...Ch. 12 - The acceleration due to gravity becomes weaker by...Ch. 12 - A rod 7.0 in long is pivoted at a point 2.0 m from...Ch. 12 - Prob. 12.3OQCh. 12 - Two forces are acting on an object. Which of the...Ch. 12 - Prob. 12.5OQCh. 12 - A 20.0-kg horizontal plank 4.00 in long rests on...
Ch. 12 - Prob. 12.7OQCh. 12 - In analyzing the equilibrium of a flat, rigid...Ch. 12 - A certain wire, 3 m long, stretches by 1.2 mm when...Ch. 12 - The center of gravity of an ax is on the...Ch. 12 - A ladder stands on the ground, leaning against a...Ch. 12 - Prob. 12.2CQCh. 12 - (a) Give an example in which the net force acting...Ch. 12 - Prob. 12.4CQCh. 12 - Prob. 12.5CQCh. 12 - A girl has a large, docile dog she wishes to weigh...Ch. 12 - Prob. 12.7CQCh. 12 - What kind of deformation does a cube of Jell-O...Ch. 12 - What are the necessary conditions for equilibrium...Ch. 12 - Why is the following situation impossible? A...Ch. 12 - Prob. 12.3PCh. 12 - Prob. 12.4PCh. 12 - Your brother is opening a skateboard shop. He has...Ch. 12 - A circular pizza of radius R has a circular piece...Ch. 12 - Prob. 12.7PCh. 12 - Prob. 12.8PCh. 12 - Prob. 12.9PCh. 12 - Prob. 12.10PCh. 12 - A uniform beam of length 7.60 m and weight 4.50 ...Ch. 12 - A vaulter holds a 29.4-N pole in equilibrium by...Ch. 12 - A 15.0-in uniform ladder weighing 500 N rests...Ch. 12 - A uniform ladder of length L.and mass m1 rests...Ch. 12 - A flexible chain weighing 40.0 N hangs between two...Ch. 12 - A uniform beam of length L and mass m shown in...Ch. 12 - Figure P12.13 shows a claw hammer being used to...Ch. 12 - A 20.0-kg floodlight in a park is supported at the...Ch. 12 - Prob. 12.19PCh. 12 - Review. While Lost-a-Lot ponders his next move in...Ch. 12 - John is pushing his daughter Rachel in a...Ch. 12 - Prob. 12.22PCh. 12 - One end of a uniform 4.00-m-long rod of weight Fg...Ch. 12 - A 10.0-kg monkey climbs a uniform ladder with...Ch. 12 - A uniform plank of length 2.00 m and mass 30.0 kg...Ch. 12 - A steel wire of diameter 1 mm can support a...Ch. 12 - The deepest point in the ocean is in the Mariana...Ch. 12 - Assume Youngs modulus for bone is 1.50 1010 N/m2....Ch. 12 - A child slides across a floor in a pair of...Ch. 12 - Evaluate Youngs modulus for the material whose...Ch. 12 - Assume if the shear stress in steel exceeds about...Ch. 12 - When water freezes, it expands by about 9.00%....Ch. 12 - A 200-kg load is hung on a wire of length 4.00m,...Ch. 12 - A walkway suspended across a hotel lobby is...Ch. 12 - Review. A 2.00-m-long cylindrical steel wire with...Ch. 12 - Review. A 30.0-kg hammer, moving with speed 20.0...Ch. 12 - A bridge of length 50.0 m and mass 8.00 104 kg is...Ch. 12 - A uniform beam resting on two pivots has a length...Ch. 12 - Prob. 12.39APCh. 12 - The lintel of prestressed reinforced concrete in...Ch. 12 - Prob. 12.41APCh. 12 - When a person stands on tiptoe on one foot (a...Ch. 12 - A hungry bear weighing 700 N walks out on a beam...Ch. 12 - The following equations are obtained from a force...Ch. 12 - A uniform sign of weight Fg and width 2L hangs...Ch. 12 - A 1 200-N uniform boom at = 65 to the vertical is...Ch. 12 - Prob. 12.47APCh. 12 - Assume a person bends forward to lift a load with...Ch. 12 - A 10 000-N shark is supported by a rope attached...Ch. 12 - Why is the following situation impossible? A...Ch. 12 - A uniform beam of mass m is inclined at an angle ...Ch. 12 - Prob. 12.52APCh. 12 - When a circus performer performing on the rings...Ch. 12 - Figure P12.38 shows a light truss formed from...Ch. 12 - Prob. 12.55APCh. 12 - A stepladder of negligible weight is constructed...Ch. 12 - A stepladder of negligible weight is constructed...Ch. 12 - (a) Estimate the force with which a karate master...Ch. 12 - Two racquetballs, each having a mass of 170 g, are...Ch. 12 - Review. A wire of length L, Youngs modulus Y, and...Ch. 12 - Review. An aluminum wire is 0.850 m long and has a...Ch. 12 - Prob. 12.62APCh. 12 - A 500-N uniform rectangular sign 4.00 m wide and...Ch. 12 - A steel cable 3.00 cm2 in cross-sectional area has...Ch. 12 - A uniform pole is propped between the floor and...Ch. 12 - In the What If? section of Example 12.2, let d...Ch. 12 - Figure P12.67 shows a vertical force applied...Ch. 12 - A uniform rod of weight Fg and length L is...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- Mp= L. d ms A horizontal L=1.3 m long mb=15 kg uniform bar is hinged on the left end and pulled at the right end by a cable. The cable makes 29° angle with horizontal. A 18 kg store sign is suspended below the bar at d=0.18 m from the right end. Find the magnitude of tension.arrow_forwardA ladder of lengtharrow_forwardA 15 kg monkey climbs a uniform ladder with weight 1.2 *10^2 N and length L=3.00 m. The ladder rests against the wall and makes an angle of theta= 60.0 degrees with the ground. The upper and lower ends of the ladder rest on frictionless surfaces. The lower end is connected to the wall by a horizontal rope. HInt : Draw a force diagram for the ladder and the normal forces from the ground and wall acting on the ladder. A) find the tension in the rope when the monkey is two-thirds of the way up the ladder. B) The rope is frayed and can support a maximum tension of only 80N. Find the maximum distance that the monkey can climb up the ladder before the rope breaks. C) If the horizontal surface were rough and the rope were removed, how would your analysis of the problem change? What other information would you need to answer parts (a) and (b)arrow_forward
- A uniform ladder 6.9 m long weighing 430 N rests with one end on the ground and the other end against a perfectly smooth vertical wall. The ladder rises at 59.5 o above the horizontal floor. A 800 N painter finds that she can climb 2.65 m up the ladder, measured along its length, before it begins to slip. Normal force exerted on ladder = 1230N Part A: What force does the wall exert on the ladder? F=____N Part B: Find the friction force that the floor exerts on the ladder. F=____Narrow_forwardA 725N person stands a distance d = 0.675 m from the left end of a plank. The plank is supported by 3 wires. Assume the plank is uniform, with length L = 2.00 m and mass 31.5 kg. What is the tension T, on the rope? 40.0° T 2.00 m O 621 N O 491 N O 549 N O 668 N O 420 N commandarrow_forwardA 11.0-kg monkey climbs a uniform ladder with weight w = 1.40 × 102 N and length L = 2.60 m as shown in the figure below. The ladder rests against the wall and makes an angle of 0 = 60.0° with the ground. The upper and lower ends of the ladder rest on frictionless surfaces. The lower end is connected to the wall by a horizontal rope that is frayed and can support a maximum tension of only 80.0 N. Rope (a) Draw a force diagram for the ladder. Choose File no file selected This answer has not been graded yet. (b) Find the normal force exerted on the bottom of the ladder. (c) Find the tension in the rope when the monkey is two-thirds of the way up the ladder. N (d) Find the maximum distance d (along the ladder) that the monkey can climb up the ladder before the rope breaks. (e) If the horizontal surface were rough and the rope were removed, how would your analysis of the problem change? What other information would you need to answer parts (c) and (d)? This answer has not been graded yet.…arrow_forward
- In the figure, a uniform beam of length 13.5 m is supported by a horizontal cable and a hinge at angle θ = 54.8°. The tension in the cable is 423 N. What are (a) the x-component and (b) the y-component of the gravitational force on the beam? What are (c) the x-component and (d) the y-component of the force on the beam from the hinge?arrow_forwardScientists have studied how snakes grip and climb ropes. In one study, they found that an important characteristic of a rope is its “compliance”— that is, how easily the rope, while under tension, can be flexed. As shown how scientists measured a rope’s compliance by attaching it to two strings, each supporting an identical mass m. The strings contort the rope so that its middle section lies at angle θ. For θ = 30° and m = 100 g, what are the tensions T1 and T2 in the upper and middle parts of the rope?arrow_forwardA uniform beam of length L = 1.5 m with a mass of 11 kg is attached to a wall by a cable as shown in the figure. The board is free to pivot at the point where it attached to the wall. What is the tension in the cable? The angle = 26°arrow_forward
- A 18.5 kg door that is 1.02 m wide opens slowly as a pull of constant magnitude 53.3 N is exerted on the doorknob. This applied force, which is always perpendicular to the door, is necessary to balance the frictional torque in the hinges. How large must an applied force of constant magnitude be in order to open the door through an angle of 90.0° in 0.474 s?arrow_forwardA 100-kg cylinder is hung by means of two cables AB and AC that are attached to the top of a vertical wall. A horizontal force P perpendicular to the wall holds the cylinder in the position shown. Determine the magnitude of P and the tension in each cable. 5 m 4m 0.6m B P 100kg 1m 6 marrow_forwardA uniform steel bar of length 10 m is supported at point A and B using two cables as shown in the figure. The bar is hinged at point C and has a weight 500 N. What is the tension (T) force in the cable? 3 T A B 5 m 5 marrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
What is Torque? | Physics | Extraclass.com; Author: Extraclass Official;https://www.youtube.com/watch?v=zXxrAJld9mo;License: Standard YouTube License, CC-BY