The given reaction occurs in single step or not has to be explained. Concept Introduction: The relationship between rate and initial concentration of reactant is described by rate law. It is an experimentally determined equation and cannot be found out theoretically from the stoichiometry of the reactants and products. r a t e = k [ c o n c e n t r a t i o n o f t h e r e a c tan t ] m Where, k is the rate constant and m is the order of the reaction. If one or two species react directly to form products through a single step then it is called an elementary reaction or a single step reaction. Multistep reaction involves the combination of two or more elementary steps.

Question

Want to see the full answer?

Answer 1

Question

Chapter 11.6, Problem 11.10CE

Interpretation Introduction

Interpretation:

The given reaction occurs in single step or not has to be explained.

Concept Introduction:

The relationship between rate and initial concentration of reactant is described by rate law. It is an experimentally determined equation and cannot be found out theoretically from the stoichiometry of the reactants and products.

rate=k[concentration of the reactant]m

Where, k is the rate constant and m is the order of the reaction.

If one or two species react directly to form products through a single step then it is called an elementary reaction or a single step reaction. Multistep reaction involves the combination of two or more elementary steps.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Strain Energy for Alkanes Interaction / Compound kJ/mol kcal/mol H: H eclipsing 4.0 1.0 H: CH3 eclipsing 5.8 1.4 CH3 CH3 eclipsing 11.0 2.6 gauche butane 3.8 0.9 cyclopropane 115 27.5 cyclobutane 110 26.3 cyclopentane 26.0 6.2 cycloheptane 26.2 6.3 cyclooctane 40.5 9.7 (Calculate your answer to the nearest 0.1 energy unit, and be sure to specify units, kJ/mol or kcal/mol. The answer is case sensitive.) H. H Previous Next

A certain half-reaction has a standard reduction potential Ered +1.26 V. An engineer proposes using this half-reaction at the anode of a galvanic cell that must provide at least 1.10 V of electrical power. The cell will operate under standard conditions. Note for advanced students: assume the engineer requires this half-reaction to happen at the anode of the cell. Is there a minimum standard reduction potential that the half-reaction used at the cathode of this cell can have? If so, check the "yes" box and calculate the minimum. Round your answer to 2 decimal places. If there is no lower limit, check the "no" box.. Is there a maximum standard reduction potential that the half-reaction used at the cathode of this cell can have? If so, check the "yes" box and calculate the maximum. Round your answer to 2 decimal places. If there is no upper limit, check the "no" box. yes, there is a minimum. 1 red Πν no minimum Oyes, there is a maximum. 0 E red Dv By using the information in the ALEKS…

In statistical thermodynamics, check the hcv following equality: ß Aɛ = KT