
Concept explainers
(a)
Interpretation:
For the given two reactants and the products under given set of conditions the balanced equation, moles, mole fraction of the reactant, the unreacted amount of given reactant, partial pressure of given compounds should be determined.
Concept Introduction:
Balanced Chemical Equation:
The
(a)

Answer to Problem 106IL
Explanation of Solution
The given reactants
Observing given reactant and products 3 should be included before
Therefore, the balanced chemical equation is
(b)
Interpretation:
For the given two reactants and the products under given set of conditions the moles, of given compounds should be determined.
Concept introduction:
Ideal gas equation:
Any gas is described by using four terms namely pressure, volume, temperature and the amount of gas. Thus combining three laws namely Boyle’s, Charles’s Law and Avogadro’s Hypothesis the following equation could be obtained. It is referred as ideal gas equation.
Under some conditions gases don not behave like ideal gas that is they deviate from their ideal gas properties. At lower temperature and at high pressures the gas tends to deviate and behave like real gases.
Boyle’s Law:
At given constant temperature conditions the mass of given ideal gas in inversely proportional to its volume.
Charles’s Law:
At given constant pressure conditions the volume of ideal gas is directly proportional to the absolute temperature.
Avogadro’s Hypothesis:
Two equal volumes of gases with same temperature and pressure conditions tend to have same number of molecules with it.
The relationship between partial pressure and
(b)

Answer to Problem 106IL
The number of moles of given species is
Explanation of Solution
The number of moles present in the given amount of the substance is calculated as follows,
(c)
Interpretation:
For the given two reactants and the products under given set of conditions the balanced equation, moles, mole fraction of the reactant, the unreacted amount of given reactant, partial pressure of given compounds should be determined.
Concept introduction:
Mole fraction: The mole fraction of denotes the individual presence of the component present in the given chemical reaction.
Consider general equation that contains reactants X and Y then the mole fraction of X is determined as follows,
The relationship between partial pressure and
(c)

Answer to Problem 106IL
The mole fraction for the given species is equal to
Explanation of Solution
Consider the given chemical reaction and calculate the mole fraction of
Before the reaction there are only reactants present in the flask.
(d)
Interpretation:
For the given two reactants and the products under given set of conditions the balanced equation, moles, mole fraction of the reactant, the unreacted amount of given reactant, partial pressure of given compounds should be determined.
Concept introduction:
Mole fraction: The mole fraction of denotes the individual presence of the component present in the given chemical reaction.
Consider general equation that contains reactants X and Y then the mole fraction of X is determined as follows,
The relationship between partial pressure and
(d)

Answer to Problem 106IL
The amount of unreacted oxygen in the reaction flask is equal to
Explanation of Solution
Initial moles of oxygen is
From the given conditions it is clear that
(e)
Interpretation:
For the given two reactants and the products under given set of conditions the of given compounds should be determined.
Concept introduction:
Mole fraction: The mole fraction of denotes the individual presence of the component present in the given chemical reaction.
Consider general equation that contains reactants X and Y then the mole fraction of X is determined as follows,
The relationship between partial pressure and
(e)

Answer to Problem 106IL
The partial pressure exerted by the given gas in the system is
Explanation of Solution
The partial pressure for the gas
(f)
Interpretation:
For the given two reactants and the products under given set of conditions the partial pressure of given compounds should be determined.
Concept introduction:
Mole fraction: The mole fraction of denotes the individual presence exerted by the component present in the given chemical reaction.
Consider general equation that contains reactants X and Y then the mole fraction of X is determined as follows,
The relationship between partial pressure and
(f)

Answer to Problem 106IL
The partial pressure exerted by the excess of oxygen after the reaction is
Explanation of Solution
The partial pressure for the unreacted oxygen is as follows,
Want to see more full solutions like this?
Chapter 10 Solutions
CHEMISTRY+CHEM...HYBRID ED.(LL)>CUSTOM<
- Li+ is a hard acid. With this in mind, which if the following compounds should be most soluble in water? Group of answer choices LiBr LiI LiF LiClarrow_forwardQ4: Write organic product(s) of the following reactions and show the curved-arrow mechanism of the reactions. Br MeOH OSO2CH3 MeOHarrow_forwardProvide the correct IUPAC name for the compound shown here. Reset cis- 5- trans- ☑ 4-6- 2- 1- 3- di iso tert- tri cyclo sec- oct but hept prop hex pent yl yne ene anearrow_forward
- Q6: Predict the major product(s) for the following reactions. Note the mechanism (SN1, SN2, E1 or E2) the reaction proceeds through. If no reaction takes place, indicate why. Pay attention to stereochemistry. NaCN DMF Br σ Ilm... Br H Br H H NaCN CH3OH KOtBu tBuOH NaBr H₂O LDA Et2O (CH3)2CHOH KCN DMSO NaOH H₂O, A LDA LDA Systemarrow_forwardQ7: For the following reactions, indicate the reaction conditions that would provide the indicated product in a high yield. Note the major reaction pathway that would take place (SN1, SN2, E1, or E2) Note: There may be other products that are not shown. There maybe more than one plausible pathway. Br H3C OH H3C CI ... H3C SCH2CH3 CI i SCH2CH3 ཨ་ Br System Settarrow_forwardQ2: Rank the compounds in each of the following groups in order of decreasing rate of solvolysis in aqueous acetone. OSO2CF3 OSO2CH3 OH a. b. CI Brarrow_forward
- ох 4-tert-butyl oxy cyclohex-1-ene Incorrect, 1 attempt remaining The systematic name of this compound classifies the -OR group as a substituent of the hydrocarbon, which is considered the principal functional group. The ether substituent is named with the suffix 'oxy'. The general format for the systematic name of a hydrocarbon is: [prefix/substituent] + [parent] + [functional group suffix] Substituents are listed in alphabetical order. Molecules with a chiral center will indicate the absolute configuration at the beginning of its name with the R and S notation.arrow_forward5. Compressibility (6 points total). The isothermal compressibility is a measure of how hard/easy it is to compress an object (how squishy is it?) at constant temperature. It is др defined as Br=-()=-(200²)T' (a) You might wonder why there is a negative sign in this formula. What does it mean when this quantity is positive and what does it mean when this quantity is negative? (b) Derive the formula for the isothermal compressibility of an ideal gas (it is very simple!) (c) Explain under what conditions for the ideal gas the compressibility is higher or lower, and why that makes sense.arrow_forward19. (3 pts) in Chapter 7 we will see a reaction of halocyclohexanes that requires that the halogen occupy an axial position with this in mind, would you expect cis-1-bromo-3-methylcyclohexane or trans-1-bromo-3-methylcyclohexane to be more reactive in this reaction? Briefly explain your choice using structures to support your answer. Mere-eries-cecleone) The tran-i-browse-3-methylcyclohexionearrow_forward
- Please help me calculate the undiluted samples ppm concentration. My calculations were 280.11 ppm. Please see if I did my math correctly using the following standard curve. Link: https://mnscu-my.sharepoint.com/:x:/g/personal/vi2163ss_go_minnstate_edu/EVSJL_W0qrxMkUjK2J3xMUEBHDu0UM1vPKQ-bc9HTcYXDQ?e=hVuPC4arrow_forwardProvide an IUPAC name for each of the compounds shown. (Specify (E)/(Z) stereochemistry, if relevant, for straight chain alkenes only. Pay attention to commas, dashes, etc.) H₁₂C C(CH3)3 C=C H3C CH3 CH3CH2CH CI CH3 Submit Answer Retry Entire Group 2 more group attempts remaining Previous Nextarrow_forwardArrange the following compounds / ions in increasing nucleophilicity (least to most nucleophilic) CH3NH2 CH3C=C: CH3COO 1 2 3 5 Multiple Choice 1 point 1, 2, 3 2, 1, 3 3, 1, 2 2, 3, 1 The other answers are not correct 0000arrow_forward
- ChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage LearningChemistry: An Atoms First ApproachChemistryISBN:9781305079243Author:Steven S. Zumdahl, Susan A. ZumdahlPublisher:Cengage Learning
- General Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage LearningChemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage LearningChemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage Learning





