The density of lithium cylinder of height 1.2 mm and diameter 15 cm with mass 0.3624 g is to be reported. Concept introduction: The density of any object is obtained when the mass of object in grams is divided by volume of an object in milliliters. So it is denoted by unit: gram per milliliter. Density is directly associated to the mass of an object. The higher the mass of the substance higher will be its density. Density is inversely associated to the volume of a substance. The lower the volume of the substance higher will be its density. Density is associated to how the particles are packed in a substance, which in turn determines its state. The state of a substance defines density. Solids are characterized by the highest and gases by the least density.

Question

Want to see the full answer?

Answer 1

Question

Chapter 1, Problem 1.73SP

Interpretation Introduction

Interpretation:

The density of lithium cylinder of height 1.2 mm and diameter 15 cm with mass 0.3624 g is to be reported.

Concept introduction:

The density of any object is obtained when the mass of object in grams is divided by volume of an object in milliliters. So it is denoted by unit: gram per milliliter.

Density is directly associated to the mass of an object. The higher the mass of the substance higher will be its density. Density is inversely associated to the volume of a substance. The lower the volume of the substance higher will be its density.

Density is associated to how the particles are packed in a substance, which in turn determines its state. The state of a substance defines density. Solids are characterized by the highest and gases by the least density.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

There is an instrument in Johnson 334 that measures total-reflectance x-ray fluorescence (TXRF) to do elemental analysis (i.e., determine what elements are present in a sample). A researcher is preparing a to measure calcium content in a series of well water samples by TXRF with an internal standard of vanadium (atomic symbol: V). She has prepared a series of standard solutions to ensure a linear instrument response over the expected Ca concentration range of 40-80 ppm. The concentrations of Ca and V (ppm) and the instrument response (peak area, arbitrary units) are shown below. Also included is a sample spectrum. Equation 1 describes the response factor, K, relating the analyte signal (SA) and the standard signal (SIS) to their respective concentrations (CA and CIS). Ca, ppm V, ppm SCa, arb. units SV, arb. units 20.0 10.0 14375.11 14261.02 40.0 10.0 36182.15 17997.10 60.0 10.0 39275.74 12988.01 80.0 10.0 57530.75 14268.54 100.0…

A mixture of 0.568 M H₂O, 0.438 M Cl₂O, and 0.710 M HClO are enclosed in a vessel at 25 °C. H₂O(g) + C₁₂O(g) = 2 HOCl(g) K = 0.0900 at 25°C с Calculate the equilibrium concentrations of each gas at 25 °C. [H₂O]= [C₁₂O]= [HOCI]= M Σ M

What units (if any) does the response factor (K) have? Does the response factor (K) depend upon how the concentration is expressed (e.g. molarity, ppm, ppb, etc.)?