Answered: You receive an order for 750 mL of 27%…

You receive an order for 750 mL of 27% dextrose solution. You have available D50W, 1000 mL. How many mL of D50W and sterile water are needed to complete the order? *

Biochemistry

9th Edition

ISBN:9781319114671

Author:Lubert Stryer, Jeremy M. Berg, John L. Tymoczko, Gregory J. Gatto Jr.

Publisher:Lubert Stryer, Jeremy M. Berg, John L. Tymoczko, Gregory J. Gatto Jr.

Chapter1: Biochemistry: An Evolving Science

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: McConkey Agar has been requested by a hospital that is investigating cases of suspected Salmonella…

A: Mcconkey agar is a media for gram negative bacteria.

Q: What is the minimal concentration (MIC) for disinfectant number 1? Just write the corresponding…

A: Minimum Inhibitory Concentration is defined as the least concentration of a substance that does not…

Q: Find the amount of dehydrated medium needed to prepare 15 BUTTS, 20 SLANTS, and 25 BUTT-SLANTS.

A: Slants, Butt-slants, and butts are different types of media prepared for bacterial growth. Slants…

Q: The physician's order reads "furosemide 15 mg IV now" You have a vial of furosemide that contains 20…

A: Medication errors can be dangerous and expensive for patients. The safe administration of drugs…

Q: What is the purpose of doing the silver nitrate test? Write the chemical equation involved here

A: Introduction: Silver nitrate is an inorganic compound and its formula is AgNO3 with a molar mass…

Q: Choose the one answer that fits best. Which of the following statements regarding the proper…

A: Micropipettes are used in the laboratory to transfer very little quantity of liquid. Parts of Micro…

Q: The order is for Moxam 5 gm IM every 8 hours. On hand is 10 gram of Moxam with the following…

A: Medication order is the terms used to define the directions for a drug needed to be given to the…

Q: What volume of 50 ppm nitrate stock solution would you use to prepare 50 ml of 1ppm, 2 ppm, 3 ppm…

A: Perhaps the most typical task in any analytical lab is preparing a solution with a known…

Q: 4 mL of 10% TCA solution was added to 1 mL of serum and after mixing, it was waited for two minutes…

A: Calibration graphs are used to estimate the concentration of unknown sample by plotting it against…

Q: How much of 10,000x SYBR safe would you add to 50 ml to make a final concentration of 1x?

A: The stock solutions can be diluted to obtain a lower concentration. Preparing stock solution…

Q: The chart below represents the results (absorbance readings) of your Bradford Assay. Use the data…

A: The Bradford protein assay is a quick and accurate spectroscopic analytical procedure used to…

Q: The doctor ordered Claforan 1400mg IM every 12 hours. The directions for the 2 gm vial state: Add…

A: The doctor ordered Claforan 1400mg IM every 12 hours. The directions for the 2 gm vial state: Add…

Q: Prepare 50 plates of Sheep's Blood Agar using 100mm petri dish. Add 10% of blood to the media.…

A: Sheep Blood Agar Base was formed to be compatible with sheep blood and to improve organism…

Q: You will be given 1 mL of a 2.0 mg/mL solution of bovine serum albumin (BSA) and 1 mL of a 2.0 mg/mL…

A: Dilution in biochemistry is used to lower and get the desired concentration of solute solution by…

Q: What volume of Water for Injection, BP to be added to a vial containing 1000 mg of drug A to produce…

A: The pharmaceutical sector is a very significant field nowadays since the discovery of new…

Q: Using 25 µL of a patient's serum, how much diluent would be needed to create a 1:2 dilution? ul

A: Firstly, we convert the 25ul into ml . i.e. 25 ul = 0.03 ml Then, there will be the multiplication…

Q: Refer to the chromatograph (Figure 1) below and answer the questions that follow: What is the…

A: Affinity chromatography is a separation technique that takes advantage of the ligand specificity…

Q: When conducting a flame test for sodium iodide, is the result positive or negative?

A: An ionic compound is one that is formed between a metal or metalloid and a non-metal. A Flame test…

Q: A dosage of 10mg is ordered. The solution strength is 2mg in 1 ml. How many ml will be administered?…

A: As concentrated drugs may have adverse effects. To reduce these effects in general, the drugs at low…

Q: A 250 mL IV solution contains 25,000 units of heparin. The desired dosage is 8 units/kg/hr. The…

A: Answer: 500 units

Q: A prescription asked for a 500 mL 12% dextrose solution. How would you prepare the prescription if…

A: Dextrose solution is an IV mix of water and sugar (dextrose). It is administered to patients…

Q: The commercial hydrogenation of vegetable oil often leads to a trans acid. Explain this statement.

A: Fat hydrogenation is the process of combining fat typically vegetable oils with hydrogen in order to…

Q: Using 25 μL of serum, how much diluent would be needed to create a 1:2 dilution? ______ μL

A: The process of reducing a solute concentration by adding solvent to a solution is referred to as…

Q: 100 mL of 2.5 X NaOH solution from 50X NaOH solution

A: Given Values: Stock solution concentration (NaOH) = 50 X Final Solution concentration (NaOH) = 2.5 X…

Q: What does translucent spot mean with regards to lipid? Identify the control for this test. 1. Oil…

A: Introduction Oils and fats are a reliable source of energy. A certain amount of human body weight…

Q: cholesterol determination

A: Cholesterol: It is a waxy, fat like substance which is essential for the normal functioning of the…

Q: Calculate the appropriate volume (in µL) of 3X loading buffer that should be added to 24.0 µL of a…

A: Dilution factor (DF) can be expressed both as the ratio of concentrations and as ratio of volumes.…

Q: From a 50% solution of dextrose, make 500 ml of a 5% solution

A: In your role as a nurse, your objective is to ensure the safety of patients and the correct…

Q: What is the purpose of the sodium thiosulphate in the testing of treated water?

A: Testing of wastewater and treated water both demand a standardized process to be followed to obtain…

Q: You have a 6 M solution of stock A. You do the following serial dilutions: Add 1 ml of stock A to…

A: Dilution is calculated by stock volume to the final volume. Solution = Stock volume/ (stock volume+…

Q: You have a sample at 50 ng/ul and you would like to load 400ng of this sample on a lane of an…

A: Agarose gel electrophoresis is a technique to study the features of genetic material and proteins.…

Q: A stock solution was diluted in two steps. In a first step, 0.5 ml was diluted with 9.6 mL buffer.…

A: Formula - Dilution = initial volume / final volume Final concentration = initial concentration ×…

Q: Calculate the appropriate volume (in µL) of 9X loading buffer that should be added to 46.0 µL of a…

A: Agarose gel electrophoresis is a laboratory technique that is used for the separation of nucleic…

Q: Using 10 μL of a patient's serum, how much diluent would be needed to create a 1:10 dilution? ______…

A: Dilution is the technique of lowering the concentration of a solute in a solution by merely adding…

Q: a physician prescribed an antibiotic to be mixed in white petrolatum to produce a 25% antibiotic…

A: Ointment preparations with antibiotics in petrolatum are useful for local external…

Q: A patient is to receive Tazidine by intramuscular injection. A 10.0-mL vial contains 1 gram of dry…

A: Tizanidine is an antibiotic available in the combination of tazobactam and ceftazidime. This drug…

Q: Using 25 uL of a patient's serum, how much diluent would be needed to create a 1:2 dilution? ______…

A: Blood is found in the human body's capillaries/veins/arteries, which are blood vessels that flow…

Q: If you transferred 15 mL of an undiluted sample into 35 mL of diluting fluid, what dilution have you…

A: Two similar expressions of the variation in concentration that occurs in a liquid material after…

Q: Demonstrate the procedure for arriving at the answer. A. It is necessary to carry out baths with…

A: A) Given that We need to dilute 1.5ml of amitraz in 1 litre water. Total volume of tank is 50…

Q: A dosage of 3 mcg/kg/min has been ordered for an 87.4 kg adult. The solution has a strength of 50…

A: Many medicines are administered incorrectly in the healthcare setting, and miscalculation is one…

Q: How do you make 70 ml of a 60% solution??

A: The making of solutions of different concentrations can be achieved with the help of principle…

Q: If I am making 500ml of a solution with 0.625ml ITS, 0.0035ml Linoleic acid, 20ml Nu-serum, 0.75g…

A: A homogeneous mixture of two or more substances is referred to as a solution in chemistry when the…

Q: Why must alcohol be diluted with water to about 70 % percent before it could be used as an effective…

A: 70% isopropyl alcohol is most commonly used as disinfectant and killing all surface microorganisms.…

Q: The order is for 1000ml of 5% D/W, 1000ml of Ringers Lactate, 500ml of NS to run over a 36 hour…

A: The nurse physically controls the IV rate when an electronic device is not being used. The nurse…

Question

You receive an order for 750 mL of 27% dextrose solution. You have available D50W, 1000 mL. How many mL of D50W and sterile water are needed to complete the order? *

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

What is your overall dilution factor if you complete 3 serial dilutions using a 100-fold dilution each time? (Show your work)
An order was received for 3000 mg of powder medication to be reconstituted with 15 mL for use. The final concentration will be 120 mg/mL. What is the powder volume contained in the vial?Group of answer choices
what is the is the dilution factor when you add 2 mL ssample of 8 mL diluent?
The order is for Streptomycin 1gm IM. You have a 5gm vial of Streptomycin . The label states to add 9ml of sterile water to yield 400mq / m * l How many ml will you give?
A certain amount of white solid was dissolved in enough water and gives a colorless solution. A portion of the solution was added with 15% solution of alpha-naphthol solution and a few drops of conc. H2SO4 forming a violet-colored ring. Another portion was added with drops of Seliwanoff’s reagent and showed no change after being warmed in a bath. Another portion was added with equal amounts of Fehling’s A and B reagent giving a red precipitate in a blue solution after warming in a bath. a) Cite an experimental result confirming that the solid is a carbohydrate b) Is the solid starch, fructose or glucose? Support your answer.
If you had a cell suspension of 2.5 x 10^4 cells/mL and plated 100uL into each well (4 wells), how many cells were added per well?
A patient is prescribed Cipro for an upper espiratory tract infection. The oral suspension is labelled 200 mg/5 mL and the patient needs to take 800 mg every 12 hours for 7 to 15 days. How many ug are in each dose? How many mL must the patient take in each dose? How many g of Cipro is the patient taking every 24 hours? What is the molarity of the Cipro oral suspension? MW Cipro=331.35 g/mole
a sample was diluted by placing a 0.1 mL of dilutent and 1 mL of this dilution was pour-plated. After incubation, 150 colonies appeared. what is the CFU/mL in the original culutre?
The doctor ordered Pepcid 20mg. You have a vial labeled Pepcid 40mg/5ml. How many ml will you give?