Which of the following would occur, it the IP addres and Subnet mask are correctly configured but the default gatevay address is wrongly configured on the hosts? Oa A host can communicate with the hosts in both the local and remote networks Ob A host cannot communicate with the hosts in both the local and remote networkes Oe A host can communicate with the hosts in the remote network but cannet communicate with the hosts in local network Od A host can communicate with the hosts in the local network but cannot communicate with the hosts in remote notwork

Which of the following would occur, it the IP addres and Subnet mask are correctly configured but the default gatevay address is wrongly configured on the hosts? Oa A host can communicate with the hosts in both the local and remote networks Ob A host cannot communicate with the hosts in both the local and remote networkes Oe A host can communicate with the hosts in the remote network but cannet communicate with the hosts in local network Od A host can communicate with the hosts in the local network but cannot communicate with the hosts in remote notwork

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Assume Host C has a Web server listening on port 80. Assume A and B are the web hosts. Is every request routed via the same Host C socket? If the server employs permanent connections and requests are routed via two separate sockets, all sockets have port 807. Discuss and defend
Part1: This question has 12 requests so I will send it in 6 parts: 1- Configure hostnames on the routers according to the Lab Topology diagram. 2- Configure IP addresses on R1 according to the Lab Topology diagram
q18- When the destination network is not listed in the routing table of a Cisco router, what is possible action that the router might take? Select one: A. The router forwards the packet to the interface indicated by the source address. B. The router forwards the packet toward the next hop indicated in the ARP table. C. The router discards the packet. D. The router sends an ARP request to determine the required next hop address.
All clients computers ae configured to receive IP addresses from thr DHCP server. However, clients on subnet B cannot access clients on subnet A.What is the most likely cause of this problem?a.IPV6 is disabledb. The IP address for the DNS Server is not available in scope optionc. The IP address is not available in DHCP scoped. Server option is disabled
In the context of DHCP what is the purpose of an IP helper address? a. The gateway for the computers in the segment b. Used to map private addresses in public ones for the purpose of accessing the outside c. Allows routers to forward DHCP requests to the segment where the server can be found d. It is a temporary IP address used by end-devices to issue requests to the DHCP server
What is Elliptic Curve Cryptography (ECC) and how does it work? Explain how the ECC version of the Diffie-Hellman key exchange method works.
QUESTION 25 Suppose there are two routers between a source host and a destination host. Then an IP datagram sent from the source host to the destination host will travel over six interfaces. True False QUESTION 26 An 802.11 can re-associate with a new AP in the subnet while not changing its IP address. True False
B6. Given the topology below, use RIP version 2 protocol and write the commands to advertise IBRI router networks. Router rip Network 192.168.10.0/25 Network 192.168.1.0/26 Network 192.168.1.0/30 Seo/0/1 192.168.1.128/26 Sur Router O Se0/0/0 Fa0 Gigo/0 © Se0/0/1 192.168.1.0/25 IBRI Router PCO 192.168.1.192/30 Se0/0/0 Sohar Router Colleges of Annlied Sciences ITNW3101 Intro to Routing and Switching FL18 Final Exam Page 8 of15 Pages
Being a Network administrator, you are provided with the IP Address 22.0.0.0/8 you have the 1024 hosts requirements for your two departments. Find the subnet IDs of two depts, subnet mask, valid Host IPs and Broadcast IP of departments?
List the classes of IPv4 addresses and their default subnet masks. In the final column list the number of host addresses per IP address and network addresses. IPv4 CLASS & ADDRESSES Default Subnet Mask Total Number of Network Addresses Possible (one number) Total Number of Host/Node Addresses Per Network Address (one number)
Enable OSPF on the routers in the provided Packet Tracer file as follows: • All three routers use OSPF Process ID 77 and Area 0 • R3 is the DR • R2 is the BDR • R1 is a DROTHER • G0/0/1 on R2 is included in the OSPF area but does not send out OSPF LSAs • When complete, save your Packet Tracer file as FL-OSPF-Multi.pka (i.e., my file would be CM-OSPF-Multi.pka)
help me please corect answear Find the subnet mask and the broadcast IP for these given IPs: 10.0.0.0, the subnet number is 16, and the host is 14 per network. 192.168.0.0, the subnet number is 4 172.16.0.0, the host number is 6