29 Hosts 21 hosts LAN Segment 1 LAN Segment 2 192.168.1.0/24 WAN Link 1 oter WAN Link 2 WAN Link 4 WAN Link 3 Find the Network address, subnet mask and broadcast address of the network LAN Segment 3 LAN Segment 4 12 hosts 8 8 hosto

Q: A host or router's IP address and its subnet mask make up the two halves of the addressing scheme.…

A: In this question we are given that IP address and the subnet mask make up to two halves of address…

Q: Why do the size and format of physical addresses differ depending on the network?

A: Introduction: A physical address (also known as a real address or a binary address) is a memory…

Q: What is the purpose of a router in a network, and which OSI layer does it primarily operate at?

A: Purpose of a Router in a NetworkA router serves as a device that forwards data packets between…

Q: What is Double VLAN tagging (Q-in-Q), and why might it be necessary in certain network…

A: Double VLAN tagging, also referred to as Q, in Q or Qin is a networking technique used to enhance…

Q: the two levels of addresses required to deliver a packet to a host are

A: the two levels of addresses required to deliver a packet to a host are

Q: To reach a host or router, a packet requires two levels of addressing. What are they?

A: Switching of packets: Packet switching is a way of arranging data transferred across a digital…

Q: Errors in the DHCP protocol may be controlled using what method?

A: Given: DHCP (Dynamic Host Configuration Protocol) is a network protocol that allows you to: In DHCP,…

Q: Please describe how a packet is routed, assuming it must traverse at least one router.

A: When a packet is transmitted from a source to a destination device over a network, it often needs to…

Q: All of the terms subnet, prefix, and BGP route must be defined and compared.

A: Intro Subnet: A subnet is a segment of the main network. Subnetting is the process of splitting a…

Q: List three things that two routers must agree on in order to establish an EIGRP neighbour adjacency.…

A: Introduction: We must state the three items that two routers must agree on in order to construct an…

Q: AN technique gives physical po

A: Below VLAN technique gives physical ports addresses?

Q: A host or router's IP address and its subnet mask make up the two halves of the addressing scheme.…

A: Packet Transfer: Packet switching is a mechanism in telecommunications for arranging data that is…

Q: Configure the gateway address for your LAN routers. Record the addresses and subnet mask for your…

A: Hi there, Please find your solution below, I hope you would find my solution useful and helpful.…

Q: How the packet is reassembled?

A: INTRODUCTION: By following the sequence numbers on both sides, you may construct the stream in the…

Q: Describe how a packet will be processed at a router that is configured with ACLs (Access Control…

A: Users and systems may be permitted or refused access to an object or system resource using an access…

Q: Describe packet loss at input ports and how it might be eliminated.

A: To be determine: Brief about Packet loss at input ports and how it might be eliminated

Q: At the network layer, the datagram and virtual circuit ways of sending packets are discussed. Which…

A: Definition: Datagram switching and the virtual circuit are the two methods used to transmit data…

Q: "forward lookup zone" of a DNS and what does it do

A: Given : What precisely is the "forward lookup zone" of a DNS and what does it do?

Q: Explain the GSM call flow from a network subscriber calling a different network subscriber .

A: Let's see first about the call flow? Call-flow The call flow is the process by which the network…

Q: Borders routers run Intra and Inter AS routing protocols. A True B False

A: Bоrder  Gаtewаy  Рrоtосоl  (BGР)  is  а  stаndаrdized  exteriоr  gаtewаy  рrоtосоl  designed  tо…

Q: What is router reflector and why it is required?

A: Introduction: What is a router reflector and why it is required?

Q: The terms subnet, prefix, and BGP route should be defined and compared.

A: The Answer is in given below steps

Q: In the event that the target network address is unknown to the router, what would happen?

A: Given: What happens if a router gets a packet with a destination network address that it doesn't…

Q: list the tcp/ip protocol suite layer that preforms each of the following: defintion of a signal's…

A: definition of a signal's electrical characteristics Layer 1 of the tcpip: The physical layer defines…

Q: Key purp se layers

A: Dear Student, The answer to your question is given below -

Q: What is the difference between the transmission time and packet?

A: Transmission time, also known as propagation time or latency, is a fundamental concept in the field…

Q: It is your responsibility as a university network administrator to choose the suitable NAT…

A: Intro A network administrator is the person inside an organization who is in charge of administering…

Q: At the network layer, the datagram and virtual circuit ways of sending packets are discussed. Which…

A: Data may be sent from one user to another using one of two methods: Datagram switching or the…

Q: By convention only, either the first usable address or the last usable address in a network is…

A: IP addressing and network management have certain conventions and best practices to facilitate…

Q: What is the purpose of VLAN tagging, and how does it work in the context of network traffic?

A: VLAN tagging, also known as Virtual LAN tagging, is a concept in computer networking.Its purpose is…

Q: The ARP protocol should be shared with a friend. Mention the layer at which it operates, as well as…

A: Given The ARP protocol should be shared with a friend. Mention tha layer at which it operates, as…

Q: It is your obligation as a university network administrator to select the appropriate NAT setup. To…

A: Intro A network administrator is the person inside an organization who is in charge of administering…

Q: Timeout period ---> RTT for the retransmitted packet. why? explain briefly.

A: 1.RTT TIMEOUT: RTT ( Round Trip Time) is an important metric in determining the health of a…

Q: At the network layer, the datagram and virtual circuit ways of sending packets are discussed. Which…

A: Data may be sent from one user to another using one of two methods: datagram switching or the…

Q: list the tcp/ip protocol suite layer that preforms each of the following: end to end flow control

A: Open System Interconnection(OSI) model is used to standardize how a computing or telecommunication…

Q: Delivery of a packet to a host or router requires two levels of addresses. Name them

A: Packet Switching: In telecommunications, packet switching is a method of grouping data that is…

Networking Model

Networking is a method of linking two or more devices in order to share data, give technical support, and communicate. It refers to the communication between connected computing devices such as desktops, laptops, smartphones, servers, and tablets and also Internet of Things (IoT) devices such as cameras, doorbells, door locks, and various sensors.

Design of the Network System

For a medium and a large scale business around the globe computers and networking plays a major role. With the access of these digital components hardware, all the necessities are interconnected and thus business runs smoothly. As the daily consumption rate of a product is increasing day by day thus the networking factor or the network design of a business is also becoming more complex. 

Networking

Networking refers to the communication shared between a group of computers. A group of computers connected to each other for the purpose of sharing resources and information is called a computer network. The first computer network was ARPANET, which stands for Advanced Research Projects Agency Network.