What type of weld can be made using the nozzle walking technique?
Q: 130 lb woman balances on the heel of her right shoe which is 1 in radius. How much pressure does she…
A:
Q: The velocity distribution for laminar flow between parallel plates is given by = =1- where h is the…
A: Given,velocity distribution u=umax1-3yh2umax=0.05 m/s h=0.11 mmμ=0.00114 Ns/m2
Q: If a 110 ft steel measuring tape with a cross section of 0.008 in² is stretched with a force of 20…
A: When the tape is stretched with the help of the force, the length of the tape will increase.…
Q: plate aur condenser har 2. À parallel cua Ix10*m² beliuin the tuo plates is t mm - Find ils capacily…
A: To find-Capacity of condenser, (C)Given-Area (A)=2×10-4 m2K=1 (air)Seperation between plates (d)=1…
Q: 1 Calculate the change in veleeity given the following initial end final veloeity vecters. Seele:…
A: As per the given velocity vectors the the change in velocity is given by: final velocity minus…
Q: In part (b), do I need to take over the relative permittivity of AIR, that mean C new =…
A:
Q: What is the magnitude of the maximum stress that exists at the tip of an internal crack having a…
A: See below
Q: Why will a vacuum pump not operate for a well that is more than 10.3m deeper?
A: a vacuum pump not operate for a well that is more than 10.3m deeper
Q: It would be easiest to pull the two halves of the evacuated Madeborg sphere apart if they were…
A: we know the fact less the air pressure, the less force is required to pull the two halves of the…
Q: force of 4.5N. calculate the pressure exerted by the pin on the board if the area of contact of the…
A: Solution:We know that:Pressure=ForceArea⇒P = FAApplying vlues we get:⇒P=4.5 N1.8×10-7 m2⇒P=2.5×107 W…
Q: 7). is related to the change pressure divided by the change in length of the sample. (a) Poisson's…
A:
Q: Question 2) Man with mass of 75 Kg standing on the one leg has a 0.8 m shaft of bone with average…
A: Given data: The mass of man is m=75 kg. Length of bone is l=0.8 m. Area of cross-section is A=5…
Q: at the gravitational potential is the same on both si at the shock front.
A: Given: To explain the constant b changes and the Bernoulli's law is applied as,
Q: An impermeable membrane (See figure above) is placed at the bottom of a U-tube, then equal amounts…
A: Given, height on both side is 16.7cm specific gravity of oil = 0.735
Q: An impermeable membrane (See figure above) is placed at the bottom of a U-tube, then equal amounts…
A: ρogho=ρwghwhohw=ρwρo=10.843=1.186total height on both side…
Q: The factor on which viscosity depends is Velocity difference between two adjacent layers .a The…
A: Given:
Q: A cylinder with a bore diameter of 4.5 inches and a rod diameter of 1.5 inches is to be used in a…
A: Given: The bore diameter of the cylinder is 4.5 inches. The rod diameter is 1.5 inches. The force…
Q: Pls help ASAP
A: Concept: There are three forces that act on the jumper while bungee jumping they are, Force due to…
Q: film becomes independent of "z" and of constant wall thickness.
A: here we are going to take Pressure gradient ∂p/∂z= 0, because atmosphere offers no shear resistance…
Q: You are working at the machine shop and Scott asks you to increase the strength of two previously…
A: Given that : There are two pieces of metal The circular cross section area 17.5 mm in diameter The…
Q: a lake has a depth of 500 m the bulk modulus of water is 2 into 10 raise to 9 calculate the…
A: The objective of the question is to calculate the fractional compression of water at a depth of 500…
Q: Question 3 1 pts A certain organ pipe has one open and one closed end, and a fundamental frequency…
A: step 1 : An organ pipe has one end open and other end closed The fundamental frequency f1=110 Hz…
Q: Consider an organ pipe of length 0.600 m. Determine the wavelength, 2, and frequency, f, of the…
A: Length of organ pipe open at both ends (L) = 0.6 m speed of sound in air (v) = 344 msnumber of…
Q: We have a light pole given below. -Assume the weight of the lamp is 200kg.(concentrated load) and…
A: Given: Weight of the lamp (w) = 200 kg Distance between Centre of gravity to pole Centre = 2m wind…
Q: 14. When an object is placed 60 cm from a converging lens, a real image is formed. When the object…
A:
Q: Suppose you need to calculate the work required to pump oil in a tank to the surface of the tank.…
A: Given :- circular top is 15 feet radius = 5 feet height = 13ft oil level is 8 ft oil weighs= 50…
Q: The pressure exerted on the floor by a person’s shoe heel varies in direct proportion to his or her…
A:
Q: An impermeable membrane (See figure above) is placed at the bottom of a U-tube, then equal amounts…
A: Given : ρoρw=0.89 (ρo is density of oil, ρwis density of water) h=10.6cm As…
Q: ame the tool used to remove certain size dents in rigid tubing? Explain how it works?
A: Introduction: Before installing a line assembly in an aircraft, inspect the line carefully. Remove…
Q: A person weighing 75kg is standing on a three-legged stool. The stool momentarily tilts so that the…
A: The pressure exerted by an object is defined as the perpendicular force exerted by the object on an…
Q: For a sand rock, length 5 cm, cross section area 4 cm², water flow through the rock, viscosity of…
A: The permeability is a measure of rock at which the rock sand will permit the passage of fluids. The…
Q: 1. A photon emitted from a source has a frequency of 2.00x107 Hz is. Calculate the energy of one…
A: In this case, the frequency of a photon is emitted from a source. From the energy expression, we…
Q: A person weighing 75kg is standing on a three-legged stool. The stool momentarily tilts so that the…
A: The weight on the foot will be W=mg=75kg9.8m/s2=735N
Q: Stress marks on the edge of a radial crack near the point of impact are: Question 17 options:…
A: Stress marks are visible signs of strain on a material due to an applied force. In the context of a…
Q: The surface tension of soap solution es 0.035 N/m. The evergy needed to increase. the rading of…
A: We need to compute the energy required to increase radius of bubble (E)=?The data provided is given…
Q: Is gasoline can be considered inelastic? Why
A: Gasoline has very few substitute. So, it is always in demand.
- What type of weld can be made using the nozzle walking technique?
Mostly the nozzle walking technique can be used on GTA groove welds in plate or pipe.
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
