What is the elution order for the following compounds on the same TLC plate? In the following choices the first one means being eluted from the TLC first, then 2nd one etc in that order. What is the elution order for the following compounds on the same TLC plate? In thefollowing choices the first one means being eluted from the TLC first, then 2nd oneetc in that order.ОНH;CCH3НО.CH3АBCDOA,D,C,BB,C,D,AD,B,C,AD,A,C,BВ,А, С,D

The correct option is as follows:

What is the elution order for the following compounds on the same TLC plate? In the following choices the first one means being eluted from the TLC first, then 2nd one etc in that order. LOH H;C. CH3 НО CH3 A В C D O A,D,C,B B,C,D,A D,B,C,A D,A,C,B O B,A,C,D

What is the elution order for the following compounds on the same TLC plate? In the following choices the first one means being eluted from the TLC first, then 2nd one etc in that order. LOH H;C. CH3 НО CH3 A В C D O A,D,C,B B,C,D,A D,B,C,A D,A,C,B O B,A,C,D

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter36: Aldehydes And Ketones

Section: Chapter Questions

Problem 8Q

See similar textbooks

Related questions

Q: Internal standard. A mixture containing 12.8 mM analyte (X) and 44.4 mM standard (S) gave…

Q: If a mixture was prepared by diluting 7.0 mL of the Blue#1 solution with water to a final volume of…

A: you have to use equation M1V1 = M2V2 15M(7)= M2 (12ml) and., M2 = 8.75 M b = 0.1044 k= - 0.0351

Q: oles of I-(x 10) noles of Pb2+ (x 10-5) noles of Pb2+ (X 10-5)

A: 1) 5 mL of 0.012 M Pb(NO3)2 gives 0.012 *5mmol= 0.06 mmol of Pb2+.

Q: cyclopentane pyrrolidine tetrahydrofuran area A = 100 intensity area B = 70 area C= 180 retention…

A: Gas chromatogram a mixture of three compounds pyrrolidine, tetrahydrofuran and cyclopentane.

Q: one: Topic Molecular Spectroscopy (16 marks) You were given an unknown mixture that contains two…

A: Step 1: Calculate the absorbance of the mixture at each wavelength (510 nm for salt A and 575 nm for…

Q: OMe OMe OH HO HO- HO OMe H+ ong HO- HO OMe Pre-practical "MUST DO" to be included in your lab-book:…

A: The objective of the question is to understand the pre-practical steps to be included in the…

Q: A spectrophotometer method for the quantitative analysis of Pb2+ in blood uses Cu2+ as an internal…

A: given : SASIS = 0.8320.351= 2.37 CA = concentration of analyte = 1.75 CIS = concentration of…

Q: Solvent Front Highest point of the dye Lowest point of the dye Rf Value Baseline Chromatogram A 15.0…

Q: One method for the quantitative determination of the concentration of constituents in a sample…

A: Given: The relative areas are 16.4, 45.2 and 30.2. The relative detector responses are 0.60,…

Q: A student weighed out 0.150 g of protein powder and dissolved it in 100 mL of water (Solution 1).…

A: In the solution, the solute concentration is decreased on the mixing of the more amount of the…

Q: DIfference between different types of UV spectrometers based on their advantages and disadvantages

A: Answer - UV spectroscopy or UV–visible spectrophotometry refers to absorption spectroscopy or…

Q: Cuvette 1 2 3 4 Dye Percent Concentration Dye (MM) 100% 75% 50% 25% T 1 Yellow Dye Red Dye…

A: Let us assume the total dye solution after dilution have volume of 100 mL. Initial concentration of…

Q: urses/ 2951 2. A linear standard curve of KMnO4 is prepared from a set of standard solutions by…

A: The objective of this question is to determine the slope of the standard curve of KMnO4 and use it…

Q: lassify the statements based on whether they describe the method of standard addition, the method of…

Q: For determining the %w/w of salicylamide and caffeine in an unknown sample using acetaminophen as an…

A: The objective of this question is to show the choice of wavelength in HPLC analysis should be based…

Q: A peak clutes from a column at 29.1 min, with a width at half height of 13.8 s. How many theoretical…

A: The number of theoretical plates is a measure of the efficiency of a chromatographic column & is…

Q: Find the transition time of 20g naphthalene with the surrounding temperature as 30oC.Let the boiling…

A: The aim of this question is to explain the transition time of the phase change of a substance. the…

Q: What is ln(A) be with reference to ln(A) vs. time graph? What would 1/A be with reference to 1/A vs.…

A: ln(A) is basically natural logarithmic function of A i.e logarithmic function with base as e. i.e…

Q: 2. What potential problem can a student have when an R₁ = 0 is obtained for an unknown sample on a…

A: THIN LAYER CHROMATOGRAPHY (TLC) is used for identification of unknown compounds, here compound move…

Q: 2 Determine the weight % composition of the sample of Cut 3 from the gc trace you ran Peak Area for…

A: The objective of this question is to calculate the weight percentage composition of Cyclohexane and…

Q: Explain why TLC cannot be used for some volatile low molecular weight substances such as toluene.

A: Thin layer chromatography, a thin layer is pressed over the chromatographic plate. A drop or small…

Q: You are measuring the concentration of an unknown protein sample, and the absorbance at 595 nm (or…

A: A standard curve is generated using concentration and absorbance of the known solutions.

Q: Determine the slope of the linear regression line for a standard curve of concentration versus…

A: The slope of the linear regression line for a standard curve of concentration versus absorbance is…

Q: Different from GCMS, why is an interface needed when coupling HPLC with MS?

A: In addition to the liquid chromatography and mass spectrometry devices, an LC-MS system contains an…

Q: An ASA tablet was boiled in 1.0 M NAOH solution following the procedure in this experiment. The…

A: A numerical problem based on tools in analytical chemistry that is to be accomplished.

Q: What is the value of [S] with v = 0.5Vmax?

Question

What is the elution order for the following compounds on the same TLC plate? In the following choices the first one means being eluted from the TLC first, then 2nd one etc in that order.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

what is the elution for the following compounds on the same tlc plate. Indicate which is eluted from the highest Rf to the lowest Rf
Here's an IR spectrum. Which of the suggested chemical structures is it consistent with? LOD TRANSMITTANCE D 4000 Select one: HO NH₂ OH 3000 2000 NAVENUMBERI-L 1500 1000 m 500
Which parameter between "solvent polarity function" and dielectric constant show better correlation with the peak positions? (cyclohexane, dioxane, acetonitrile, ethanol, ethylene glycol)
Write notes on the most important absorptions and fragmentations found in the following spectra and use the information to suggest the best possible structure. (Molecular formula: C8H1602, M =144)...
4. NMR: (8 pts) Look at the given molecules and answer the following questions H H Compound A Compound B Compound C OH H Compound D How many different chemical environments (number of peaks) would you expect to see in the 'H NMR for each molecule? A = B = C = D: = Predict how many sub peaks per multiplet would be seen in the signal for the indicated hydrogen due to spin-spin splitting? A = B = C = D = How many H of that particular type (integration) would you expect to see at the indicated hydrogen? A = B = C = D= =
Assign the hydrogens in C7H14O to this structure
Is this anisole? How?
15. NO AI USE
Please help me with this, I am trying to prepare for my final exam next week and I am just completely lost
Lable the peaks of diphenylmethanol (product of benzophenone) and explain why each peak is the way it is Thank you
12. Why do the two methyl groups indicated in the figure below give a single peak integrating for 6 protons rather than two peaks integrating for 3 protons? H3C H3C + .CH3 OH 4-hydroxy-4-methylpentan-2-one OD. The two methyl groups are spin spin coupling with each other. OA. 60MHz NMR have a low resolution so cannot easily resolve the two peaks. B. The molecule is chiral. OC. Both of the methyl groups are in the same chemical environment.
4. IR stretching frequency of C=O in acetic acid is 1720 cm. But, The same in Benzoic acid appears at 1680 cm 1. Explain. 0 11 0 CH₂ / C HO OH acetic acid Benzoic acid