Question：what if the the student did not pre-heat the gravity filtration apparatus？what affect will take place on this sample？ 3Hot gravity filtration is atechnique used to separateliquids from activated charcoaland insoluble impurities. Theapparatus must be maintainedhot so that the compound ofinterest (acetanilide) stays in65°C65°CO°C65°C65°CAdd activatedcharcoal and filter itHeat up yourDissolve your solidin the hot solventsolventout of the solutionsolution.45ITCool down theEnjoy yournewly formedcrystalsPlace the solutionsolution to roomin an ice bath fortemperaturefurther coolingto add notes= NotesComments!!

According to the question, the student did not pre-heat the gravity filtration apparatus. We need to…

Answered: what if the the student did not…

Science

Chemistry

what if the the student did not pre-heat the gravity filtration apparatus？what affect will take place on this sample？

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: 6. In Part A, suppose that after delivery several drops of the water cling to the inner wall of the…

A: suppose that after delivery several drops of the water cling to the inner wall of the pipet…

Q: f the cells were spread out into a thin layer that was a single cell thick, what would be the total…

A: The values are provided in question= 1.35 kg Number of cells of brain = 4.11*1011 The density of…

Q: Properties mention 4 of instrumental methods a Instrumental Methods

A: 1. Instrumental method - X-Ray Properties - Radiation Diffraction 2. Instrumental method -…

Q: Select the correct answer a.The rate of filtration is proportional to the pressure difference across…

Q: n measuring the surface tension of a liquid (drop weight method), 20 drops of the liquid (r=0.2cm)…

A: olume = Area x Height , Mass = Volume x Density , Force = Mass x Acceleration V = P r2 H…

Q: Calculate the mean, and median for each set of data. a. 6.37, 6.33, 6.41, 6.80 b. 6.37, 6.33,…

A: Given data part(a) : 6.37,6.33,6.41,6.80 part(b) : 6.37,6.33,6.41,6.93…

Q: how we use effiusion in vacuum techniques? how we use effiision in vacuum device? please explain to…

A: In this question, we have to find out the correct answer of given problem by the help of the…

Q: article size and g d on three variah

A: The synthetic precipitation can be used. The transformation course into strong over substance can be…

Q: How many grams of AgCI will be formed when 60 ml of 0.500 MAGNO: is completely reacted according to…

A: Given, 60mL of 0.500M AgNO3

Q: 5. You are heating a mixture of (flammable) cyclohexane and toluene in a round bottomed flask. What…

A: Mixture: A mixture can be defined as the substance which will be made by more than one various kinds…

Q: Why is a pipette more accurate than a burette?

A: Burette is a long glass cylinder with a stopcock at the bottom to release the liquid. Pipette has a…

Q: Calculate the Rf for a spot which travels 3.77 cm from the baseline while the solvent travels 8.33…

A: Given, Distance traveled by the substance = 3.77 cm Distance traveled by the solvent front = 8.33…

Q: Which of the following description(s) are improperly used related to the process of filtration?…

A: Filtration is the process in which solid particles in a liquid are removed by the use of a filter…

Q: The excluded volume is included in (Select all that applies) VL VT Vi VS

Q: 4. Suppose you took the test tube out of the boiling water bath for -30 seconds as you forgot to…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Analysis of Oil-in-Water deposit" which is related to oil spill

A: Given " Analysis of Oil-in-Water deposit" which is related to oil spill.

Q: What kinds of information can be gathered by ultracentrifugation?

A: Ultracentrifugation is a specialized technique used to spin samples at exceptionally high speeds.

Q: Report Questions 1. Do the experimental results support or disprove your hypothesis? Explain your…

A: The objective of this question is to experimental results support the hypothesis that the…

Q: Design a barn for milk cows, numbering 85 cows, with an open-type design and the presence of a…

A: Ans. Based on the given specifications, here is a design for a barn for 85 milk cows with an…

Q: Explain two separation techniques how may be feasible for H2O vs Ethanol. One can be an industrial…

A: Separating alcohol from water may be done in a number of different ways. Heating the mixed liquid is…

Q: High-pressure ATR is used to analyze very hard sample. True False

A: Attenuated total reflection (ATR) spectroscopy is an analysis technique that utilizes the surface of…

Q: A tire pressure gauge reads 33.0 pounds per square inch . How many kPa is this? Remember that…

Q: Mean, standard deviation, Coefficient variable, and 95% confidence limits of HCl molarity’s *…

A: In the realm of chemical analysis, the determination of molarity plays a crucial role in…

Q: Derive a compression factor equation

A: Compression factor: It is defined as the ratio of molar volume of a gas to the molar volume of an…

Q: We separated a mixture of sodium carbonate and calcium chloride using Gravity Filtration.…

A: A question based on analytical separation that is to be accomplished.

Q: a) By how much should the student expect their sample measurements to increase by? Why? b) Will…

A: (a) In spectrophotometry, the absorbance is directly proportional to the concentration of analyte…

Q: Gibbs free energy in chemistry is symbolized G. It is related to the enthalpy (H) and entropy (S)…

Q: Graph the following data Temperature (°c) ( x axis) Pressure (torr) ( y axis) 550 25 678 40 800 65…

A: y = 6.357x + 550.0 R2 = 0.9945

Q: Using the data collected in Table 2, construct a plot in Excel according to the directions in your…

A: The rate of a reaction or a process can be determined by plotting a graph of concentration or amount…

Q: The reaction of 50 mL of Cl₂ gas with 50 mL of CH4 gas via the equation: Cl₂(g) + CH4(g) → HCl(g) +…

A: From, Avogadro's law We know that equal volumes of gases have an equal number of moles under the…

Q: where did the mean ratio emerge from?

Q: A tire pressure gauge reads 33.0 pounds per square inch . How many kPa is this? Remember that…

A: Given, 33.0 Psi Convert to = _____KPa ?

Q: Convert 287 KPa to atm

A: force per unit area is called pressure P = FA Units : Pascal , atm , barr, torr, mmHg, cmHg…

Q: Determine the appropriate Air Quality Standard for your contaminant. Indicate which standard you are…

A: You've done a lot of mistakes i feel. Firstly re read its written that treat pure oxygen and…

Q: Two samples with narrow molecular weight distributions are prepared of a new polymer. Some…

A: To determine the value of parameters K and a, a calibration with samples is required of known…

Q: A homogeneous mixture of hydrogen and oxygen separation methods

A: a homogeneous mixture has same uniform composition. Best homogeneous mixture of hydrogen and…

Q: Name three (3) other types of samples that can be analyzed in a typical acidimetric process.Explain

A: Acidimetry, is a quantitative analysis method where the direct or residual titrimetric analysis of…

Q: Describe two ways to fold a filter paper to be used for filtration. Include diagrams for the…

A: Technically speaking, filtration is the act of removing suspended solids from a liquid by forcing…

Q: C. 2. Questions The molecular weight of potassium permanganate is 158 and that of methylene blue is…

Q: Compare anticipatory and reactive standards.

A: Anticipatory and reactive standards are two approaches to establishing standards for safety,…

Q: 2 3 4 6 7 8 100 QUESTION 4 How much sample should be loaded into the capillary tube for a Melting…

A: 4) We have to answer how much sample should be loaded into the capillary tube for a Melting Range…

Q: A student determines the molar mass of acetone, CH3COCH3, by the method used in this experiment. The…

A: As you have posted multiple parts of the question and have not specified which part you want us to…

Q: give the specifications of flue gas analysis stack or flare?

A: A flare stack or gas flare is an elevated vertical stack or chimney found on oil wells and oil rigs…

Q: Question: The following data measures how quickly Heg) diffuses in gas chromatograph detector as…

A: From given data tables :-

Question

Question：what if the the student did not pre-heat the gravity filtration apparatus？what affect will take place on this sample？

3
Hot gravity filtration is a
technique used to separate
liquids from activated charcoal
and insoluble impurities. The
apparatus must be maintained
hot so that the compound of
interest (acetanilide) stays in
65°C
65°C
O°C
65°C
65°C
Add activated
charcoal and filter it
Heat up your
Dissolve your solid
in the hot solvent
solvent
out of the solution
solution.
4
5
IT
Cool down the
Enjoy your
newly formed
crystals
Place the solution
solution to room
in an ice bath for
temperature
further cooling
to add notes
= Notes
Comments
!!

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

4. In which step does the liquid in the system become a low-pressure gas? a. Step 1: Compressor b. Step 2: Condenser Coil C. Step 3: Expansion Valve Step 4: Evaporator Coil d.
Which one is answer ?
In the precipitation method, the final particle size and growth rate depend on three variables. Explain
What will happen to MP (effect and range) if one uses a melting point tube with too large a diameter?
Mean, standard deviation, Coefficient variable, and 95% confidence limits of HCl molarity's *0.08883M * 0.08743M * 0.08790M
Why is polystyrene cup useful for carrying out for thermochemistry experiment with solution ?
1. Using Excel, set up a spreadsheet with the following data and prepare a graph which includes a linear regression analysis with the trendline displayed on the graph: Time(sec) Temp (°C) 30.0 27.3 60.0 40.2 90.0 53.7 120.0 67.4 150.0 79.8 180.0 91.3
Question 1 a)Draw and explain the pressure -temperature diagram of wet gas reservoirs. b) The hydrocarbon dew point is a function of the gas composition as well as the pressure and the temperature. What problems it could cause in the next units of fluid processing, if it is high? Need both don't copy from other sources I will downvote if so.
Question #3: A slender, homogeneous bar B weighing 193 lb has an angular velocity of 2 rad/s clockwise and an angular acceleration of 8 rad/s2 clockwise when in the position shown in the figure below. The wall at B is smooth, but the wall at A has a coefficient of sliding friction of 0.1. Find the value of the downward force P and the reaction forces at A and B at the instant shown in the figure.
Describe the procedure involved in flame test. Subject: Analytic chemistry
What is the control variable, independent variable, dependent variable for the filtration process.
Why should you heat the sample to constant mass?