What are the possible sources of error when reacting sodium bicarbonate and hydrochloric acid within an evaporating dish over wire gauze over a bunsen burner? We used as much HCl until the sodium bicarbonate in the evaporating dish stopped bubbling (HCl=excess). Procedure of the lab down below.

Chemistry
10th Edition
ISBN:9781305957404
Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste
Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste
Chapter1: Chemical Foundations
Section: Chapter Questions
Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...
icon
Related questions
Question

What are the possible sources of error when reacting sodium bicarbonate and hydrochloric acid within an evaporating dish over wire gauze over a bunsen burner? We used as much HCl until the sodium bicarbonate in the evaporating dish stopped bubbling (HCl=excess). Procedure of the lab down below.

Procedure
1. Flame dry a clean evaporating dish by heating it in the hot part of a burner flame for about 5
minutes. Allow the dish to cool.
2. Find the combined mass of the evaporating dish plus a watch glass. Record this mass in your
list of data
3. Using a microspatula, add 2.50 g sodium hydrogen carbonate (NaHCO3) to the evaporating
dish. Record the total mass in your list of data.
4. Set up the ring stand, ring, and wire gauze as shown in Figure 16-1. Place the watch glass on
top of the evaporating dish and place the dish on the wire gauze.
6. Holding the burner in your hand, gently heat the evaporating dish.
Use a low flame and move the burner back and forth to avoid
spattering. When almost all the liquid is gone, remove the burner and
replace the watch glass on the evaporating dish, leaving a small opening for vapor to escape.
Heat gently again until no liquid remains. Allow the dish to cool.
Figure 16-1
5. Obtain about 5 mL of 6 M hydrochloric acid (HCI) in a clean, dry
test tube. CAUTION: Handle this acid carefully. It can cause painful
burns if it touches your skin. Using a dropper
pipet, slowly add HCl to the NaHCO3 in the evaporating dish, a few
drops at a time. (See Figure 16-2.) Continue adding acid until the
reaction (bubbling) stops. Carefully tilt the evaporating dish back and
forth a couple of times to make sure that the acid has contacted all
the NaHCO3 After making sure that all bubbling has stopped, remove
the watch glass and place it curved side up on the lab bench.
7. Find the combined mass of the watch glass, evaporating dish, and contents (NaCl). Record
this mass in your list of data.
watch glass
evaporating
dish
dropper pipet
Transcribed Image Text:Procedure 1. Flame dry a clean evaporating dish by heating it in the hot part of a burner flame for about 5 minutes. Allow the dish to cool. 2. Find the combined mass of the evaporating dish plus a watch glass. Record this mass in your list of data 3. Using a microspatula, add 2.50 g sodium hydrogen carbonate (NaHCO3) to the evaporating dish. Record the total mass in your list of data. 4. Set up the ring stand, ring, and wire gauze as shown in Figure 16-1. Place the watch glass on top of the evaporating dish and place the dish on the wire gauze. 6. Holding the burner in your hand, gently heat the evaporating dish. Use a low flame and move the burner back and forth to avoid spattering. When almost all the liquid is gone, remove the burner and replace the watch glass on the evaporating dish, leaving a small opening for vapor to escape. Heat gently again until no liquid remains. Allow the dish to cool. Figure 16-1 5. Obtain about 5 mL of 6 M hydrochloric acid (HCI) in a clean, dry test tube. CAUTION: Handle this acid carefully. It can cause painful burns if it touches your skin. Using a dropper pipet, slowly add HCl to the NaHCO3 in the evaporating dish, a few drops at a time. (See Figure 16-2.) Continue adding acid until the reaction (bubbling) stops. Carefully tilt the evaporating dish back and forth a couple of times to make sure that the acid has contacted all the NaHCO3 After making sure that all bubbling has stopped, remove the watch glass and place it curved side up on the lab bench. 7. Find the combined mass of the watch glass, evaporating dish, and contents (NaCl). Record this mass in your list of data. watch glass evaporating dish dropper pipet
Expert Solution
trending now

Trending now

This is a popular solution!

steps

Step by step

Solved in 2 steps

Blurred answer
Knowledge Booster
Solutions
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.
Similar questions
Recommended textbooks for you
Chemistry
Chemistry
Chemistry
ISBN:
9781305957404
Author:
Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste
Publisher:
Cengage Learning
Chemistry
Chemistry
Chemistry
ISBN:
9781259911156
Author:
Raymond Chang Dr., Jason Overby Professor
Publisher:
McGraw-Hill Education
Principles of Instrumental Analysis
Principles of Instrumental Analysis
Chemistry
ISBN:
9781305577213
Author:
Douglas A. Skoog, F. James Holler, Stanley R. Crouch
Publisher:
Cengage Learning
Organic Chemistry
Organic Chemistry
Chemistry
ISBN:
9780078021558
Author:
Janice Gorzynski Smith Dr.
Publisher:
McGraw-Hill Education
Chemistry: Principles and Reactions
Chemistry: Principles and Reactions
Chemistry
ISBN:
9781305079373
Author:
William L. Masterton, Cecile N. Hurley
Publisher:
Cengage Learning
Elementary Principles of Chemical Processes, Bind…
Elementary Principles of Chemical Processes, Bind…
Chemistry
ISBN:
9781118431221
Author:
Richard M. Felder, Ronald W. Rousseau, Lisa G. Bullard
Publisher:
WILEY