We have a transformer designed to operate at 60 Hz. The voltage ratings are 4800 V rms and 240 V rms for the primary and secondary windings, respectively. The transformer is rated for 10 kVA. Now, we want to use this transformer at 120 Hz. Discuss the factors that must be considered in setting ratings appropriate for operation at the new frequency. (Keep in mind that for best utilization of the material in the transformer, we want the peak flux density to be nearly at saturation for both frequencies.)

Q: A single phase transformer has turns ratio of 4. The resistance and reactance of the primary winding…

A:

Q: A 50 Hz 1-phase transformer has a turn-ratio of 6. The resistances are 0.90 ohm and 0.03  ohm and…

A: Given data : Resistance and reactance on the HV side R1=0.90Ω,  X1=0.03Ω Resistance and reactance on…

Q: The flux linking of winding 2 if the current in the winding 1 is -4 A, and the current in winding 2…

A:

Q: Find the elements of the equivalent circuit relative to the secondary of a single-phase transformer.…

A: Transformer is the static device it work on the principle of faraday law of mutual inductance. It…

Q: The core of a three phase, 60 Hz, 11000/750 V delta/star, 310 kVA, core-type transformer operates…

A:

Q: Explain the operation of a single phase transformer at no-load. Draw the phasor diagram and…

A: Transformer is a static device which transfers power from one circuit to another circuit without…

Q: 6. A single-phase, 225-kVA, 460/120-V transformer has 6% impedance and 96% efficiency. Find its…

A: In this question we need to find series R and X of the given transformer

Q: C3 (ii). The primary and secondary winding of an transformer has 95 turns and 20 turns,…

A: Note :- As C3 (ii) & (iii) are not linked with each other. Both have different questions. So as…

Q: Q5:Choose the correct answer from the given alternatives (answer five only) 1.In an ideal…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 1.10. An equivalent circuit of a transformer is given in Figure P1.10. If the load impedance is 200+…

A: Given circuit is,Voltage at the load 200+j300 is 1200⁰ volts,Asked to find the,Supply voltage?Power…

Q: The circuit diagram of a wye wye transformer is shown below. It has a neutral to ground resistor in…

A: A wye-wye transformer, also known as a star-star transformer, is a type of three-phase transformer…

Q: From the short circuit test and open circuit test in #19 and #20, the equivalent circuit of a…

A:

Q: ou are employed in transformer fabrication unit. You have to design core of transformer. With regard…

A: Transformer: Transformer is an electrical static device works on the principle of electromagnetic…

Q: 3. A 3200/400 single-phase transformer has winding resistance and reactance of 30 and 132…

A: In this question,  We need to determine the equivalent terms in primary side and secondary side.

Q: 6) A transformer takes 100V at primary and gives 50V at secondary, its turn ratio equals ... ....…

A: Primary voltage =100V secondary voltage= 50V

Q: For the 13-kVA, 1540/220-V transformer shown in Figure (2): a) Calculate the full-load voltage…

A: Given, E1 = 1540 VE2 = 220 V Z1 = 4.4 + j6.5 ΩZ2 = 0.042 + j0.048 Ω Where, R1 = 4.4 ΩR2 = 0.042 Ω…

Q: The parameters of the transformer equivalent circuit are given bellow, Primary winding turns =1150.…

A:

Q: 55 V / 220 V, 50 Hz single phase transformer, high voltage (secondary) windings are left idle and…

A: Winding resistance of the secondary referred to the primary, R2'=0.015 Ω

Q: 1. A transformer transforms. (a) frequency (b) voltage (c) current (d) voltage and current. 2. Which…

A:

Q: A method for determining the equivalent network of a nonideal transformer consists of two tests: the…

A: Given data Open circuit test; V=4600 V rms, I=0.7 A rms and P=200 W Short circuit test; V=5.2 V and…

Q: A 3000V/4400V, single-phase transformer takes a no-load current of 0.5A and the iron loss is 200W.…

A: We will solve this question by using the no-loaad conditions of the transformer.

Q: A single phase transformer has a voltage transformation ratio of 0.4. The resistance and reactance…

A:

Q: a) Define what the term "permeability" means. Explain why this is an important parameter in…

A:

Q: A single-phase transformer (assumed to be ideal) with the rated values are given in the figure, is…

A: Two winding transformer rating given S=11KVA Voltage ratings 2200/220V After change in auto…

Q: The resistance and reactance of the primary winding of a 440/110 V single phase transformer are 4.4…

A:

Q: Q2) put ( v) or (x) for the following and correct the wrong : 1-the connection Delta-Delta is the…

A: As per the guidelines given, We can only provide the solution of the first three questions in…

Q: A 3-phase transformer, ratio 33/6.6-kV, A/Y, 1-MVA has a primary resistance of 8.5 ohms per phase…

A: 3 phase,E1=33kv,E2=6.6kv,Rating of transformer=1MVA,Primary resistance=8.5ohms,Secondary…

Q: The cross-sectional area of a transformer limb is 80 cm2 and the volume of the transformer core is…

A: Given parameters are: The cross-sectional area of a transformer limb,Ac=80cm2=80×10-4m2 The volume…

Q: THE PERCENTAGE RESISTANCE AND REACTANCE OFA1-F TRANSFORMER ON LOAD ARE 3% AND 6 %…

A:

Q: Find the elements of the equivalent circuit relative to the secondary of a single-phase transformer.…

A:

Q: an ideal transformer circuit is shown in Figure Q4(a). Its primary and secondary turns are 400 and…

A:

Q: A 150 kVA, 2500/250 V, 50 Hz, single phase transformer has a no-load current of 0.75 A and a core…

A:

Q: Iron loss in a transformer: a) is dependent on load current. Ob) is a function of the resistance of…

A: Answer: is a function of eddy current and hysteresis effects in the transformer core. Explanation:…

Q: Draw an equivalent circuit for a real transformer. Briefly discuss the reason that each element…

A: Given: To draw an equivalent circuit for a real transformer and its elements is described as:

Q: the no load current I0 is in phase with the magnetic flux

A:

Q: 1- A 50 Hz, 1-ph transformer has a turn ratio of 6. The resistances are 0.92 and 0.032, and the…

A:

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.