Water with density pwater = 1000 kg/m³ flows out in the atmosphere, trough two openings in a tank, situated at h, = 1 m and h, = 2 m. If the diameter d, = 0.15 m, determine the diameter d, in such way, that the flowrate Q trough the two openings will be equal. Consider that the level of water is kept constant. Pa hi d1 h2 d2

Water with density pwater = 1000 kg/m³ flows out in the atmosphere, trough two openings in a tank, situated at h, = 1 m and h, = 2 m. If the diameter d, = 0.15 m, determine the diameter d, in such way, that the flowrate Q trough the two openings will be equal. Consider that the level of water is kept constant. Pa hi d1 h2 d2

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q2) Several water pipes intersect at the junction box illustrated in Figure. Determine the force required to keep the junction box in place. Assume water at 4°C. 250 mm Q₁ = 0.2 m³/s P₁ = 480 kPa 350 mm 300 mm QIVA = 0.3 m³/s /P = 400 kPa 30° Q=0.1 m³/s Pc = 450 kPa 50⁰ 200 mm 60° Q = 0.4 m³/s PD = 350 kPa
Water flows steadily through the elbow, placed horizontally on the surface shown in figure. Determine the force kN needed to hold the elbow in place. (NOTE: Pwater = 1000 kg/m) -5m 45 cm -30kPa P-250 Pa 25 cm A-170 AP K-15 ms 20 cm
As shown in the figure below, a cylindrical tank with a hole in the bottom and an air vent in the top is being filled with water. Given the following: Dtank = 4 ft hill = 8 ft NOG height of water in tank when tank is filled Qin = 10 gal/min %3D NOT UPL TO CHE diameter of hole Find: volumetric flowrate into tank EGG EXAM into the tank in slugs/second OT UPS XAM O NOT U EXAM (c) The rate at which the water level in the tank is mass flowrate (in slugs/second) of the water (b) The mass flowrate (in slugs/second) out of the tank UPLOAD TO CHE NOT UPLOAD when the water level reaches the fill height DO NOT UPL rising (in inches/minute) when the water level NOT UPL PLOAD TO CHEGG NOT UPLOAD TO CHEGG EXAM TO CHEGG EXAM OD TO CHEGG UP reaches the filled height то снE LOAD vent Dtank DO DO DO NOT UPLOADTO EXAM EX DO 0 DONOT UPLOA T Dhole G EXAM TO CNGO UPLOA hole mdotout
5. What is the minimum diameter at section (1) in the pipe below to avoid cavitation at that location? Take D₂= 15 cm. Neglect friction head loss in the pipe. Water 5 m (1) (2)
a circular opening of diameter 300 mm impinges on a rigid wall as shown in the figure. Neglect all minor losses and assume the water level in the tank to remain constant. The net horizontal force experienced by the wall is kN. Density of water is 1000 kg/m3. Acceleration due to gravity g= 10 m/s. %3D Stationary rigid wall 6.2 m Jet Circular opening of diameter 300 mm
Water is transported from reservoir A to reservoir B by a pump. The diameter of pipe D1 is greater that the diameter of pipe D2 (D1>D2). The reservoir B is elevated from the ground at Z units. Draw the hydraulic gradient line and energy gradient line for the system. D2 A D1 Pump
Consider two tanks filled with water. The first tank is 8 m high and is stationary, while the second tank is 2 m high and is moving upward with an acceleration of 5 m/s^2. Calculate the pressure of each tank at the bottom.
Q4: water flows steadily through the large tanks shown in figure below. Determine the water depth, ha. (30 mark) (1) hA 0.03 -m diameter (2) |(3) hg = 2 m 0.05 - m diameter (4) B
The pump is used to transfer fluid from one location to another of different height. At inlet and outlet atmospheric conditions are present. The pipe diameter increases after the pump outlet. Determine all the surviving terms of energy equation after simplification. FUM kinetic energy, potential energy, pipe losses none pipe losses, potential energy, pressure increase pressure increase, pipe losses, potential energy kinetic energy, pressure increase, pipe losses OOO
Water flows through a pipe at 15 L/s as shown. If the gage pressure of 12.5 kPa, 11.5 kPa and 10.3 kPa are measured for P1, P2 and p3, respectively, what are the head loss between 1-3 in meters.
A viscous fluid flows in two different pipes. Pipe 1 has a length L1, and Pipe 2 has a radius L2. If both pipes have the same diameter and L1 > L2, choose the correct statement about the pressure difference of the fluid in Pipe 1 and Pipe 2. The fluid in Pipe 1 has larger pressure difference. The fluid in Pipe 2 has larger pressure difference. The pressure difference of the fluid is the same in Pipe 1 and Pipe 2. It cannot be determined in which pipe the fluid has larger pressure difference.