Determine the minimum time to withdraw 50L of kerosene from the cylindrical tank with 147.43 cm long to the can with 20 cm height put in the ground if we use a siphon hose with diameter is 16 mm. take kerosene density 810 kg/m^3?

Determine the minimum time to withdraw 50L of kerosene from the cylindrical tank with 147.43 cm long to the can with 20 cm height put in the ground if we use a siphon hose with diameter is 16 mm. take kerosene density 810 kg/m^3?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: If A reservoir of oil has a mass of 860 kg and volume of 330 L. then the: 4 Specific weight of oil…

Q: 4. The pressure in the ideal gas law must be unit length along any line in the surface 7. weight per…

A: Hi and thanks for the questions. Since you have asked multiple questions, as per our honour code, we…

Q: A cylinder shown in fig. has diameter (25mm) height (300mm) and relative density (R.D=7.85). The…

Q: A cylinder vessel filled with water with a 2m diameter and 5m high. It was rotated with uniform…

Q: A ball of 15 cm diameter fell into a tank of water, 13% of its volume found under water. What is the…

Q: mp while the volumetric e

A: Volume, V= 50 m3 Time, t = 5 min Length, L1 = 5.2 m Length, L2 = 2.2 m Efficiency, ηpump = 95%…

Q: An open vessel contains water up to a depth of 5.29 m and above it an oil of SG = 0.8 %3D for a…

Q: A container is filled with a liquid of density p. The surface of the liquid is at atmo- spheric…

A: The expression is obtained using Bernoulli's principle.

Q: Calculate the condition of gas in pressure = 10 bare and specific volume 175000 cm3/kg

Q: ii. Water is rotated in a pump impeller at a speed of 1500 rpm. The inlet and outlet diameters are…

Q: A 2 m tall barrel is closed on top except for a thin pipe extending 8 m up from the top. When the…

Q: 3. A spaceship lands on a planet where the atmosphere is completely made of water (p = 1000 -g). The…

Q: Find the value of pressure at dpeh of 2.4 m. Take density of water 1000 kg/m3

A: Given data : Acceleration due to gravity=g Depth=h Density of water=ρ Required : Pressure

Q: A cylindrical tank of radius 5 ft and height 9 ft is two-thirds filled with a liquid of weight…

A: Given Radius, R = 5 ft Height, h = 9 ft Density = 62.4 lbs/ft3 Find Work required, W

Q: Calculate the volume (m3) of the tank needed, using the Van der Waals Equation for - 5kg air at…

A: Given:m= 5 KgT=150 KP=2750 KPa

Q: A tanker contained with water is pushed horizontally at constant acceleration of 5.0 m/s?. If the…

Q: 37. For a tank (T = 41 C°, volume = 0.051 m³, the rate change of density = 2.6 kg-m³-s*), through a…

Q: Installing the suitable pump to deliver 300 litres per minute. can you expline this sentence and…

A: It is asked to write the procedure to select a suitable pump for 300 litres per minute 300…

Q: 2. A cylindrical container having cross-section area 100.0 m², which is put on the ground, is filled…

A: The unit of speed is “m/s” not “m/s2”. So in this solution unit of speed taken as “m/s”. Given data:

Q: Billy flew from New York to Cincinnati and had a closed container with a closed outlet to drink…

A: Diameter of the container→DC=5 Cm=0.05 m Height of the container→HC=27 Cm=0.27 m Hence the initial…

Q: Find the altitude in km at which the pressure is 10.51334141 in cm Hg.

A: GivenP=10.51334141 cm Hg =105.1334141 mm Hg

Q: 37. For a tank (T = 41 C°, volume = 0.051 m³, the rate change of density = 2.6 kg-m-s"), through a…

A: Giventemperature T=41oCvolume of tank V=0.051m3rate change of density ρ˙=2.6kg/m3sarea of hole…

Q: Find h when the pressure in tank B is 21 kPa. A Air Air SG = 0.91 h Oil D 1 m B 2 m Water 1.25 m…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: Q2: Two pipes A and B carrying water are conected by a connecting tube as shown in Figure. If the…

Q: Findthe pressure at a depth of 15 m below the free surface of water in a reservoir.

Q: Find h when the pressure in tank B is 21 kPa.

A: Given data: - The pressure in tank B is PB = 21 kPa. The specific gravity of oil is SGoil = 0.91.…

Q: A vessel cylindrical in shape and closed at the top and bottom is 300 mm in diameter, 1 m long and…

Q: 03: Answer ONE Section only. a. Three reservoirs are connected, if pipe (1) and pipe (3) having…

Q: a conical water tank has its top at ground level(considerr this to be the x-axis) and its base 12 ft…

Q: d, is fitted to the outlet pipe of a pump with diameter D. Let h; be the height of the section 0-0…

Q: The gauge pressure in a liquid at a depth of 2.7m is 55.8 kPa. What is the gauage pressure kPa in…

Q: Find the value of x for adaibatic process of air. P^x V = constant

A: For the adiabatic process of air, the value of adiabatic index is 1.4

Q: A tank, shaped like a cone has height 8 meters and base radius 3 meters long. It is placed so that…

A: The height of cone is The radius of base is The density of water is

Q: a vertical wall separates two different fluids in an open tank. The right side of the tank contains…

Q: find the change in volume of 2.5cm^3 of water at at 80c when subjected to a pressure increase of…

Q: Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe…

Q: Take density of fluid = 1000kg/m^3.. Kindly give correct solution and it should be handwritten in…

A: Given Diameter, d = 0.175 m Height, h = 25 mm of Hg = 3333.06 Pa Density = 1000kg/m3…

Q: A water tower supplies water through the plumbing in a house. A 3.50-cm-diameter faucet in the house…

Question

Determine the minimum time to
withdraw 50 L of kerosene from the
cylindrical tank with 147.43 cm long to
the can with 20 cm height put in the
ground if we use a siphon hose with
diameter is 16 mm. take kerosene
density 810 kg/m^3?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Fick’s Law of Diffusion and Mass Transfer

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The vat shown in the accompanying figure contains water to a depth of xo = 1.4 m. Find the work required 4 m 6 m %3D to pump all the water to the top of the vat. 3 Use 9810 N/m as the weight density of water. 3 m NOTE: Enter the exact answer. Work J %3D
Please explain part b and c
2. A 3,000 gallon tanker is carrying industrial alcohol (donaity-48 23 D. /h) finteBurton to the Selene Building. Find the weight (N) of the industrial alcohol if the tanker is67% full. (Round to nearest whole number)
From fig, if the pressure of gas in bulb A is 50cm Hg vaccum and atmosphere pressure =76 cm hg, find height of column H
I need the answer as soon as possible
I need the answer as soon as possible
1. An open trapezoidal tank is accelerated horizontally at 6m/s2 along its length. Its bottom width is 4.20m and its sides are inclined at 3H:4V. If it has a height of 3m, width of 2m and it is filled with water at a height of 2.5m, how much water is spilled out in m3.. 2. A cylindrical shape solid container of sg=0.515 having a diameter of 1.5m and a height of 3.10m is floating in a seawater of sg=1.03. Attached at the bottom of the container is a steel ball of sg= 7.85. If the height of the container projecting above the fluid surface is 0.60m. Determine the diameter in m and weight in KN of the steel ball.
95kPa AIR hc he n A hA An Air tank is connect to a U-tube that contains three separate liquids as follows: (A) mercury, (B) kerosene (C) brine ha = 50 cm hB = 40 cm hc= 30 cm If the atmospheric pressure is 95 kPa, find the pressure in the Air tank.
If you have a closed system that is filled with water on 2bar, the pump is selected for pressure losses due friction of the pipes(1bar) 1/ why don't we have to take pressure losses due height in account? 2/ what is the pressure at 100 m height inside the system? When the pump stops? And when the pump is circulating, prove your answer figure in image
Badly needed Asap.. .I will rate helpful.
Qz: A A liquid of (N = 1:25 Pais.) fills the space of (Sum) shown in figure below. Calculate the forque (T) required to rotate the frustum cone at a constant speed of a (60 rip.u). IT Smm o. 3m 0.7m
Can you guys help me please