Water enters a motor through a 255-mm-diameter pipe under a pressure of 14 kPa. It leaves through a 1134-mm-diameter exhaust pipe with a pressure of 4 kPa. A vertical distance of 2.5 m separates the centers of the two pipes at the sections where the pressures are measured. If 346 liters of water pass the motor each second, compute the horsepower supplied to the motor.

Q: to pump water from lower reservoir to upper reservoir, a centrifugal pump is used. if the length of…

A: Given:Suction head=3 mdelivery head=30 m

Q: Piston Pum 0.12 m saline 0.3 m

A: The work done in a piston cylinder assembly can be determined using the formula given below as-…

Q: A horizontal pipe is full of flowing water.  At location A the velocity is 1.5 m/s and  the…

A: The Pressure of the water at B is 133.43 kN/m3.Explanation:Given:v1 = Velocity at location A = 1.5…

Q: The diameter of a pipe carrying  oil(s=0.92) changes gradually from 400 mm at A to 600  mm at B.…

A: Specific gravity of oil, SGo=0.92Diameter at A, DA=400 mm=0.4 mDiameter at B, DB=600 mm= 0.6…

Q: A pump delivers water, density =1000kg/m3, at a volume flow rate of 0.004256 m3/sec.  If the head…

A: Given:Water density, ρ=1000 kg/m3Volume flow rate of water, Q=0.004256 m3/secHead developed by the…

Q: Water is flowing in a pipe with a velocity of 2 m/s and a pressure of 2.5 bar. The nozzle which is…

A: Given data P1=2.5 barV1=2 m/secV2=20 m/sec

Q: A vertical pipe is shown in figure 1 below. The pipe tapers from 50 mm in diameter to 25 mm in…

A: Given, Q=2 L/min=2×10-360 m3/s=3.333×10-5 m3/s d1=50 mmd2=25 mm hl=kv22-v122g z1-z2=1.5 m

Q: A plugged dishwasher sink with the dimensions of 2 ft 1.5 ft 1 ft is being filled with water from a…

A:

Q: The diameter of an open-topped tank 1.5 m high increases uniformly from 4.2 m at the base to 6 m at…

A:

Q: Assume the water in the first tank maintains its height and pressure. The valve is opened and after…

A: Solution: Given Data: P=200 kPaρ=1000 kg/m3D=5 cmPatm=100 kPa   To Find: Mass flow rate through the…

Q: A vertical reducing bend carries 0.455 m^3/s of water at a pressure of 148kPa entering the bend at…

A: Given-Information:-  Q= 0.455 m3/sp1 = 148 kpadA = 0.6 mdB = 0.3 mF = 35670 Nθ = 45° To-Determine:-…

Q: 1. Water flows through a venturi meter. At the constricted section where the area is 24cm², the…

A: Given data:-Area at section 2-2, a2=24cm2=0.0024m2Pressure at section 2-2,…

Q: Eight cubic feet of water flow per second downward through this pipe line. When the upper pressure…

A:

Q: Water is flowing in a pipeline at 64 li/sec. If the diameter of the pipeline is 120 mm, calculate…

A:

Q: The diameter of an open topped tank 1.5 m high increases uniformly from 4.2 m at the base to 6 m at…

A:

Q: The discharges from the pipe is 0.142 m3/s of water into a reservoir at a point 1.85 m below the…

A: Given:diameter at point A, da 0.254 mdiameter at discharge, d=30.5 cm or 0.305 mDischarge, Q=0.142…

Q: Water flows steadily through the system shown below. The 4-in. section leads to a throat, followed…

A: Consider the diagram shown below for the given system as shown below. From the continuity equation,

Q: The level of mercury in the manometer has the reading shown in fig, Determine the velocity of the…

A:

Q: Water enters a motor through a 500-mm-diameter pipe under a pressure of 15 kPa. It leaves through a…

A:

Q: A cast iron pipe (roughness =0.26 mm or 0.010 inches) having a diameter of 100 mm is used to fill…

A:

Q: The hydroelectric turbine shown in the figure passes 500 m³/sec of water across a head of 200 m.…

A: Given:  Q = 500 m3/s  H = 200 m Maximum Power output of the system is given by  Pmax = ρgQH

Q: Water at 40 degrees C is flowing from A to B through the system shown below. Determine the…

A: Given data as per question Lz=30m1 in=0.0254 m​D1=4 in=0.1016m​D2=6 in=0.1524 m​PA=PB=Atmospheric…

Q: A vented 50-gallon cylindrical reservoir (diameter = 18 inches) is used to supply ambient…

A: Given: Here is the given image, To determine: The required height (m) of water in the reservoir…

Q: 1a. Water flows into a tee fitting at a flow rate of 0.02 m3 /s. A pipe is connected to B. The…

A:

Q: Following the pump, the pressure in a 6-inch inner smooth pipe conveying water is 20 pounds per…

A: SOLUTION : Given Data: Inside diameter of the pipe (d) = 6 inch = 0.1524 m Pressure (ΔP) = 20 psia =…

Q: QUESTION 4 A vertical pipe is shown in figure 1 below. The pipe tapers from 50 mm in diameter to 25…

A:

Q: The flow rate of the water flowing through the venturi, which has a wide section of 4.91x10^-4 m, is…

A:

Q: ne of 50 mm diameter and 4.5 km length con t difference of water level is 12 m. A branch pipe…

A:

Q: Following the pump, the pressure in a 6-inch inner smooth pipe conveying water is 20 pounds per…

A:

Q: Eight cubic feet of water flow per second downward through this pipe line. When the upper pressure…

A: Pressure gauge in section 1, P1=25 lb/in2. P1=25(144)=3600 lb/ft2. Discharge, Q=8 ft3/s A1=π4(1)2=π4…

Q: Water flow steadily at the rate of 10 gpm through a horizontal tee and discharges to the atmosphere.…

A:

Q: Consider the water flowing through the pipe shown in (Figure 1). The height of the water column in…

A: Given, Height of pitot tube, h=12inHeigh of peizometer= 3inDiameter of pipe at cross section…

Q: A water tank with a capacity of 1500 L is desired to be completely filled in about 1.5 hours. The…

A: To find: The power input (in kW) to the pump. Given: The capacity of the tank is V=1500 lt. Tine…

Q: Let the pressure gradient in the pipe be 1500 Pa/m and the diameter of the pipe be 4.0 mm. What is…

A: Given : dP/L = 1500 pa/m d = 4 mm = 0.004 m

Q: A fire hydrant supplies water under a pressure of 190 kPa. A 100-mm-diameter hose is connected to it…

A:

Q: The diameters of a pipe at the sections 1 and 2 are 0.1 m and 0.15 m respectively Find the discharge…

A: Given data⇒ Diameter of pipe at section 1 is d=0.1 m Diameter of pipe at section 2 is D=0.15 m…

Q: A pipe with a radius of 9 mm is attached to a nozzle. If the velocity of flow in the pipe is 2 m/s,…

A:

Q: A cylinder with a diameter of 0.5 m and a height of 1.8 m is shown below. The water flows through a…

A: