A cast iron pipe (roughness =0.26 mm or 0.010 inches) having a diameter of 100 mm is used to fill the empty cylindrical tank with water at 40 degree C. If the power output of the pump is 4.5 kW, determine the depth of h in water in the tank 6 minutes after the pump is turned on. The pipe has a total length of 50 m. Neglect minor losses

Q: A horizontal pipe is full of flowing water.  At location A the velocity is 1.5 m/s and  the…

A: The Pressure of the water at B is 133.43 kN/m3.Explanation:Given:v1 = Velocity at location A = 1.5…

Q: A pump delivers water, density =1000kg/m3, at a volume flow rate of 0.004256 m3/sec.  If the head…

A: Given:Water density, ρ=1000 kg/m3Volume flow rate of water, Q=0.004256 m3/secHead developed by the…

Q: The pumper truck shown in the figure below is to deliver 1.6 fts to a maximum elevation h of 61 ft…

A: To find : determine the power that the pump must add to the water. Given : flow rate Q=1.6 ft3/s…

Q: By applying a force F, a saline solution is ejected from the 10-mm-diameter syringe through a…

A:

Q: Problem 4: During the daytime, water is drawn from an upper reservoir and is run through a turbine…

A: Step 1:Step 2: Step 3: Step 4:

Q: Water enters a motor through a 500-mm-diameter pipe under a pressure of 15 kPa. It leaves through a…

A:

Q: A vented 50-gallon cylindrical reservoir (diameter = 18 inches) is used to supply ambient…

A: Given: Here is the given image, To determine: The required height (m) of water in the reservoir…

Q: 1a. Water flows into a tee fitting at a flow rate of 0.02 m3 /s. A pipe is connected to B. The…

A:

Q: Let the pressure gradient in the pipe be 1500 Pa/m and the diameter of the pipe be 4.0 mm. What is…

A: Given : dP/L = 1500 pa/m d = 4 mm = 0.004 m

Q: An engineer designing a light aircraft is trying to make an estimate of the radius of the propeller…

A:

Metrology of surface finish

In general terms, the application of scientific principles in the study of measurements is known as metrology. When speaking about measurement, it could be of time, length, microstructures, grain structures, internal crystal discontinuities, surface roughness, measurements of angles, height, width, and so on. While coming to the domain of mechanical engineering, metrology is considered the science of measurements of surface finish, length, surface texture, and angles.