Water at 40 degrees C is flowing from A to B through the system shown below. Determine the volumetric flow rate of the water if the vertical distance between the surfaces of the two reservoirs is 10 m. The elbows are standard. ( roughness for the ductile iron pipe = 0.061 mm or 0.0024 in)

Q: pipes in parallel, the total friction head loss equals to the individual friction head loss in each…

A:

Q: ron pipes and conducts water at 20 ° C from eservoir "A" to reservoir "B", the levels of which are…

A:

Q: The flowrate between tank A and tank B shown in the figure below is to be increased by 25% (i.e.,…

A: Write the given data.The pipe left of point C is considered as pipe 1, the right of point C is…

Q: Water is flowing through a horizontal pipe of diameter 200 mm at a velocity of 3 m/s. A circular…

A: We have, Diameter, d=200 mm=0.2 m,     V=3 m/s Diameter of circular plate, d1=150 mm=0.15 m (as…

Q: The flowrate between tank A and tank B shown in the figure below is to be increased by 15% (i.e,…

A: Release through Pipe when pressure slope is realized number cruncher utilizes Dischargeq=-π8μR4×P…

Q: Turpentine is flowing at 0.63 m3/s in the fabricated tube shown below.If the pressure before the…

A:

Q: The three-tanks system in figure are interconnected as shown. Compute the flowrate in each pipe,…

A: To find discharge in all pipes

Q: The pumper truck shown in the figure below is to deliver 1.6 fts to a maximum elevation h of 61 ft…

A: To find : determine the power that the pump must add to the water. Given : flow rate Q=1.6 ft3/s…

Q: A 300mm * 150 mm venturimeter is inserted in a vertical pipe carrying water flowing in upward…

A:

Q: Water enters a motor through a 500-mm-diameter pipe under a pressure of 15 kPa. It leaves through a…

A:

Q: The hydroelectric turbine shown in the figure passes 500 m³/sec of water across a head of 200 m.…

A: Given:  Q = 500 m3/s  H = 200 m Maximum Power output of the system is given by  Pmax = ρgQH

Q: A vented 50-gallon cylindrical reservoir (diameter = 18 inches) is used to supply ambient…

A: Given: Here is the given image, To determine: The required height (m) of water in the reservoir…

Q: Q.4) A 75 mm diameter galvanized iron pipe, having a roughness of ε = 0.2 mm, is used to carry water…

A:

Q: Water flows in a pipe of 1-in. diameter at a temperature of 70°F. The pressure values at points 1…

A: To findDetermine the direction of flow.What is the minimum discharge above which the flow will not…

Q: Freshwater at a temperature of 10°C flows at a rate of 0.10 m3/sec through the piping system…

A: Determine the value of the absolute roughness of the galvanized iron pipe.

Metrology of surface finish

In general terms, the application of scientific principles in the study of measurements is known as metrology. When speaking about measurement, it could be of time, length, microstructures, grain structures, internal crystal discontinuities, surface roughness, measurements of angles, height, width, and so on. While coming to the domain of mechanical engineering, metrology is considered the science of measurements of surface finish, length, surface texture, and angles.