Using the definition of the static friction and the first condition of equilibrium, show that the coefficient of static friction in method A is the ratio of the weight of the pan plus its contents to the weight of the carrier of the pan plus its contents to the weight of the carrier plus its content. Note: Show your free body diagrams.

Q: A bicyclist is riding due south on a straight road. A 20 mile per hour wind is blowing in the…

A: The bicyclist is heading straight towards south  A 20mile wind is blowing , 20deg east of north…

Q: The three diagrams below show a block of massm being pulled or pushed at constant acceleration a,…

A:

Q: please kindly box the answers that i will input

A: From the given figure, Fg perpendicular=Fgcosθ=mg cosθ and Fg ∥=Fgsinθ = mg sinθ The friction force…

Q: A block of mass m = 160 kg rests against a spring with a spring constant of k= 770 N/m on an…

A:

Q: A projectile is launched from point A with the initial conditions shown in the figure. Determine the…

A:

Q: Ex. 15 : S.H.M. The restoring force acting on it, when position is 3 N. Write down the differential…

A: To find- Differential equation of linear S.H.M Given- Mass of body (m)=2 kg Restoring force(F)=3N…

Q: At time t = 0 a small ball is projected from point A with a velocity of 174 ft/sec at the angle 64°.…

A: The answer for this question has solved below...

Q: Momo with mass m is sliding down an inclined plane that makes an angle D relative to the horizontal.…

A:

Q: Two cylinders S and T of unit length rest against smooth supports as shown in the figure. Each…

A:

Q: The landing gear on a commercial aircraft experiences an impulse load upon landing. Assuming six…

A: A) Calculate the time taken before the landing gear reaches the given load cycles. t=Load cycles…

Q: Consider a box of length 2L, where L = 1 m.  The bowstring is made up of two cords of natural length…

A:

Q: A force Facts in the direction forming a angle = 2°. with the surface of horizontal support of the…

A: Given,  The force acting with angle . The horizontal plane is is rough. The coefficient of static…

Q: Consider the following hanging mass system for the following problems. Part A Before answering the…

A:

Q: in figure (Direction of force may be along ative x-axis). All of the contact surfaces de of force…

A: Given: To explain the correct option among the given options with the figure as,

Q: Consider the information in the image below. Following the usual force problem procedure (using a…

A: Friction is resistance against the motion. Friction is of three types, Static friction, Kinetic…

Q: A block of mass m = 0.63 kg attached to a spring with force constant 129 N/m is free to move on a…

A: Given: Mass of block (M) = 0.63 kg spring force constant (k) = 129 N/m stretch spring distance (A) =…

Q: Two uniform 66.1-gg marbles 2.16 cmcm in diameter are stacked as shown in the figure (Figure 1) in a…

A:

Q: At southern latitude 1 (refer to Figure 1), under the influence of Corlolls force, a projectile of…

A: The mass of the projectile is given as, m The initial speed of the projectile is given as, vo The…

Q: If coefficient of friction is 0.27, determine the maximum weight of the rectangular block before it…

A:

Q: Show all work clearly and neatly. Beginning with this problem, you must use the Problem Solving…

A: a) Let the velocity of the combine car and truck system after the collision be v.Apply conservation…

Q: A rod is positioned along the z-axis such that one of its ends is at z = L, and the other one is at…

A:

Q: A mass weighing 5 lb stretches a spring 3 inches. Suppose that the mass is given an additional 8…

A: Given,  weight = 5 lb, L = initial displacement = 3 in = 3/12 = 1/4 feet Fdampening = Viscous…

Q: Two forces, F, = 290 N and F, = 655 N act on the pipe shown. F, has direction cosine angles: a = 48…

A: The unit vector is called the direction vector which has the same direction as the given vector. It…

Q: A cube of side / rests on a rough floor. It is subjected to a steady horizontal pull F, exerted a…

A:

Q: Problem: A 50-kg box silides down an inclined plane made up of varlous materials. The plane is…

A: As per the requirement I will solve part D and  E only. Given mass of the block  m=50kg determined…

Q: Get the resultant in x and y. Also the θ. Show the complete and step by step solution. It is a…

A:

Q: 1) Return to your data table above and continue to collect data for those points for when the scale…

A: Solution Given below:

Q: One of the most frequently used devices for batch fermentations is the stirred tank. The power that…

A: Here we use rayleigh's method; As we know, for dimensional analysis of your choice that the power…

Q: Center of mass by integrals. Find the center of mass of a uniform wire that subtends a circular arc…

A: Given a arch with radius of curvature is "a".rcosθ , y=rsinθ,

Q: FIGURE BELOW shows a man standing at the end of the diving board, which is supported by two springs…

A:

Q: A block of mass m is sliding over an inclined plane and is connected by a cable to a solid of…

A: The objective of the question is to establish a relationship between the viscosity of the oil and…

Q: Consider an infinitely long l-beam. There is a Gaussian distribution w(x) acting over the entire…

A: Given: Let us consider the given wx=e-xm-12 kNm

Q: B 0.500 m 0.400 m T 0.200 m d A 0.300 m

A: All matter possesses inertia, which is a quantitative measure of its properties. When a force is…

Q: A box A is on an inclined plane which has the configuration shown in the figure below. On another…

A:

Q: A machine has an 700 g steel shuttle that is pulled along a square steel rail by an elastic cord.…

A: Here is the explaination in the given image

Q: For the system forces showed, calculate the magnitude of the resulting force from the forces F, P,…

A:

Q: After an unfortunate accident at a local warehouse, in which a jib crane collapsed and injured a…

A: The forces are shown below

Q: If the total work done on the system is 1.2658 J, determine the final velocity of the block (by…

A: Given, work done W = 1.2658 J From the concept of work energy theorem, we              Work =…

Q: Initially, the system of objects shown in the figure below is held motionless. The pulley and all…

A: Given that all the contacts and pulley are frictionless. (a) Let T is the tension in the string. If…

Q: Find the systems that provide the features given in the following. Explain sufficiently why it…

A:

Q: R= 35 N Q = 25 N 50 P = 20 N 30 50 S= 45 N

A:

Q: for all the physical quantities in the final answers. Problem1: The two bars can deform elastically.…

A: Draw the free-body diagram of point B. Now we can apply Lami's rule. It states, “When three forces…

Q: A block of mass m is placed on a rough surface inclined relative to the horizontal. The incline…

A:

Q: 2. A 1500000 kg undersea research chamber is spherical: = with an external diameter of 6.8m. It is…

A:

Newton’s Third Law of Motion

The horse pulls the cart and the cart pulls the horse in response as per Newton third law. So the big question is, “Don’t the two forces cancel each other? How does the cart accelerate?”