: Two wires of equal cross-section one made up of aluminium and other of brass are joined end to end. When the combination at wire is kept under tension the elongation in wires are found to be equal. Find the ratio of lengths of two wires. (Y) = 7 x 10¹0 N/m² and AL Y₁ = 9.1 x 10¹0 N/m²).
Q: A steel cube of side length L = 0.5 m is subjected to a shearing force of 5000 N along the top…
A: Length=0.5m Shear force=5000N Shear constant=8.3×10^10N/m2 Shearing angle=?
Q: Find the minimum diameter of an | = 15.1 m long tungsten wire that will stretch no more than 7.00 mm…
A:
Q: What will be the density of sea water at a depth of 1 km, if the density at the surface is 1025…
A: Correct option : (d) 1029.387 kg/m3
Q: Ex. 3: A copper metal cube has each side of length 1m. The bottom edge of cube is fixed and…
A: To find-Lateral displacement (x)=?GIven-Length of each side (L)=1 mTangential force (F)=4.2×108…
Q: A copper wire of length 3 m has a diameter 1 mm. If weight of 10 kg is attached to one end of wire,…
A: We need to compute-(i) Extension produced (l)=?(ii) Lateral contraction=?The data given as-Length of…
Q: 6. A steel rectangular block 1.5 in. wide, 3/4 in. deep and 5 in. long is subjected to an axial…
A:
Q: The maximum height h of a mountain depends on the density of the rock the mountain is made out of ?ρ…
A:
Q: A cable hanging vertically under gravity must support its weight, w = mg, where m is the mass of the…
A: To avoid snapping of the cable, the tensile strength will be equal to the force per unit area. Write…
Q: A steel cable 3.00 cm2 in cross-sectional area has amass of 2.40 kg per meter of length. if 500 m of…
A: Given:- Cross-sectional area = A = 3 cm2 = 3 x 10-4 m2 Mass per unit length = 2.4 kg/m Length of the…
Q: Question 16: A cubical solid aluminium (bulk modulus = -V (dP/dV) = 70 GPa) block has an edge length…
A: Given that, Bulk modulus=-VdPdV=70 GPa Here we know that, B=VdPdV
Q: The maximum compressional stress that a bone can withstand is 1.6 × 108 N/m2 before it breaks. A…
A:
Q: Q. 29: A wire of length (L) and radius (r) is loaded with a weight (Mg). If (Y) and (o) denote the…
A:
Q: A 8-mm-thick rectangular alloy bar is subjected to a tensile load P by pins at A and B, as shown in…
A:
Q: Two wires of equal cross- section one made up of aluminium and other of brass are joined end to end.…
A: To find- Ratio of length of two wires L1L2=? Given- lAL=lbrass=l,MAL=Mbrass=MrAL=rbrass=rYAL=7×1010…
Q: Ex. 65: A steel wire of diameter 1 mm and length 2 m is stretched by applying a force of 2 kg wt.…
A: We need to compute-(i) Increase in length (l)=?(ii)Strain=?(iii) Stress=?The data given as-Diameter…
Q: A research scientist would like to estimate the tensile strength of a newly created synthetic fiber.…
A: SOlution:
Q: Where must the force R be applied so that its external effect on the bar ABC will be the same as the…
A: Given Force F1 = 730 N Force F2 = 310 N
Q: Ex 30 : A wire one meter long and radius 0.05 mm is stretched by a tension of 1 kg weight. Find the…
A: To find-Extension (l)=?Given-L=1 mM=1 kgr=0.05 mm=0.05×10-3 mY=2×1011 N/m2
Q: A farmer making grape juice fills a glass bottle to the brim and caps it tightly. The juice expands…
A: thank you
Q: An object weighs 4.5 x 105 N is supported by steel cable, with cross-sectional area of 6.0 cm 2, the…
A: Given: The weight of the object is 4.5x105 N. The cross-sectional area is 6 cm2. Young's modulus of…
Q: You have a piece of uniformly shaped 5.78 cm long yarn, the diameter of which you can neglect. If…
A: Given : L = 5.78 cm = 0.0578 m Q = 4.69 × 10-10 C
Q: The bell crank is in equilibrium for the forces acting in rods (1) and (2). The bell crank is…
A: Solution:- Using the FBD shown, calculate the reaction forces that act on the…
Q: A bar of length 100 cm is supported at its two ends. The breadth and depth of bar 5 cm and 0.5 cm…
A: We have to find the depression produced in the bar. Area, A=5 mm2=5×10-6 m2, Length, L=100 cm=1 m,…
Q: X A steel beam is placed vertically in the basement of a building to keep the floor above from…
A:
Q: The principal forces at a point p of an elastic body are o(¹)=50N/cm², o(2)=-50N/cm² and…
A: The first principal force is The second principal force is The third principal force is
Q: A bar of length its two ends. The breadth and depth of bar 5 cm and 0.5 cm respectively. A mass of…
A: Using formula of bending of beam we will be able to find the depression produced within the beam
Q: A 1.05-m-long rod of negligible weight is supported at its ends by wires A and B of equal length…
A: This question involves two concepts: (A) Free body diagram and subsequent condition for the static…
Q: A square steel plate has area Im² and thickness 5 cm. The bottom edge is fixed. A tangential force…
A: Shear modulus, also known as Modulus of rigidity, is the ratio of shear stress to shear strain that…
Q: Two exactly similar wires of steel (Y, = 20 x 10" dyne/cm²) and copper (Y, = 12 × 101 dyne/cm²) are…
A: To find- Elongation of copper wire (ec)=? Given- Ys=20×1011 dyne/cm2Yc=12×1011 dyne/cm2ec+es=1 cm
Q: You apply a force of magnitude F1 to one end of a wire and another force F in the opposite direction…
A: Newton's second law of motion relates the net force acting on the object to the acceleration…
Q: Two wires of the same material have their length in the ratio 3 : 2, diameters in the ratio 3 : 2…
A: To find-Ratio of the extensions of wire l1l2= ?Given-Lengths of two wires are in ratio…
Q: The radius of a copper 4 mm. What force is required to stretch the wire by 20% of its length,…
A: To find-Force required (F)=?Given-Elastic limit is not exceeded.Radius of copper wire (r)=4 mm…
Q: Ex. 14: The frame of brass plate of an outer door design has 1.60 m square and thickness 1 cm. the…
A:
Q: Two wires A and B are of the same length. Their diameters are in the ratio 1:2 and the Young's…
A: We need to compute-Ratio of elongations produced eAeB=?The data given as-Length of wire A=Length of…
Q: A wire made of the same material (Y= 12X1010Pa) is cut into two parts, we label it as wire I and…
A: Given data: The Young's Modulus of the wire, Y=12×1010 Pa. Wire I is 3 times as long and half the…
Q: Problem 8 3-13. A bar having a length of 5 in. and cross-sectional area of 0.7 in² is subjected to…
A: The length of the bar is .The cross section area of the bar is The axial force acting on the bar is…
Q: The weight of the homogeneous rod is 500N and its length is 5m Find the angle of inclination of the…
A: Given that: W=500 N l=5 m
Q: A fishing rope of length (74+ 50) m has the diameter (74 + 5) mm. When a weight of (74 +200) N is…
A: i. The cross-sectional area of the rope is given by,
Q: A rigid bar of mass M is supported symmetrically by three wires each of length l. Those at each end…
A:
Q: Two different plates A and B of size A-(60 cm x 60 cm) and B=(60 cm x 30 cm) slide over a plane…
A: Given: Dimension of A= 60 cm×60 cm Dimension of B= 60 cm×30 cm Angle of inclination θ=300 Thickness…
Step by step
Solved in 2 steps