Answered: The principal forces at a point p of an… | bartleby

Related questions

Question

The principal forces at a point p of an elastic body are o(¹)-50N/cm²,
o(2)=-50N/cm² and 3)-75N/cm². Find the stress vector t(n), the
normal stress on, and the shear stress or for a plane that is equally
inclined with respect to the principal axes.
P
B

Expert Solution

Step by step

Solved in 4 steps with 11 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

In a standard tensile strain test, a 20 mm diameter aluminum rod is subjected to a tensile force of P = 30KN. If μ = 0.35 (Poisson's ratio) and E = 70 GPa (Young's modulus), determine: a) The elongation of the rod in a calibrated length of 150 mm and b) The change in the diameter of the rod
2.23. A steel is found to yield in uniaxial tension at a stress Sy = 205 MPa and in torsion at a shear stress Ty =116 MPa. Which of von Mises' and Tresca's theories is the most consistent with this experimental data.
A uniform rod has mass m and length L. One end of the rod is attached to a fixed point O by a hinge and an additional force F is applied to the other end of the rod in the direction shown, perpendicular to the rod. Given that the rod is in mechanical equilibrium, what is the magnitude of the applied force F, expressed as a numerical multiple of mg, where g is the magnitude of the acceleration due to gravity? Express your answer to 3 decimal points.
Prob. 4.4-6. (a) determine the maximum tensile stress, the maximum compressive stress, and the maximum shear stress; and (b) show the stresses determined in Part (a) on properly oriented stress elements (e.g., see Fig. 4.14). In solving these problems, make the sense of the stresses consistent with the sense of the torque T shown on the generic torsion member figure. T= 400 N m, d = 40 mm, and d = 0₁ 32 mm. =relative twist angle 45° (b) FIGURE 4.14 A pure- shear element, and the associ- ated maximum-normal-stress element.
Structural member AB is to be supported by a strut CD. Determine the smallest length CD may have, and specify where D must be located for a strut of this length to be used. Take x= 120 mm. 60 mm D. y 20 mm E The smallest length CD may have is mm. The coordinates of point Dare ( and Imm.
A thin rectangular plate is uniformly deformed, as shown. Determine the shear strain yy at P. Assume a = 1010 mm, b = 890 mm, c = 1.4 mm, and d = 1.1 mm. R Answer: Shear strain yry prad.
By finding the curl, determine which of the following forces are conservative: (a) F = ix +jy + kz (b) F = iy - jx + kz* (c) F = iy + jx + kz' 4.2 _3
Find the centroid of the homogeneous lamina. Assume r = 4. 2r- 2r (x, y) = X (Hint: The moments of the union of two or more nonoverlapping regions equ regions.) (Use symbolic notation and fractions where needed. Give your answer as poi