Two solid cylindrical rods support a load of P = 32 kN as shown. Rod (1) has a diameter of 14 mm, and the diameter of rod (2) is 12 mm. Determine the axial stress in rod (1). 3.8 m 4.6 m (1) 5.6 m O 169.0 MPa 139.6 MPa 125.8 MPa O 104.5 MPa O 182.6 MPa B U 3.3 m

Q: Two vertical rods one of steel and the other of copper are each rigidly fixed at the top and 50cm…

A: To obtain the solution to the above given question, we must the three equations of statics which are…

Q: The rectangular bar shown is connected to a support bracket with a 24 mm diameter pin.  The width of…

A: Given Data The diameter of pin is:d=24mm=24×10-3 m The width of the rectangular bar is:b=70…

Q: Pipe (2) is supported by a pin at bracket C and by tie rod (1). The structure supports a load P at…

A:

Q: Bar (1) has a cross-sectional area of 0.75 in.². If the stress in bar (1) must be limited to 39 ksi,…

A: Correct answer: (b) 17.55 kips

Q: Two solid cylindrical rods support a load of P = 39 kN, as shown. Rod (1) has a diameter of 16 mm…

A:

Q: = Two solid cylindrical rods AB and BC are welded together at B and loaded as shown. Take di = 30…

A:

Q: An axial load P is applied to the rectangular bar shown. The cross-sectional area of the bar is 455…

A: (a) The normal stress is 54.67 MPa. (b) The shear stress is 75.25 MPa.

Q: The member consists of the steel rod AB that is screwed into the end of the bronze rod Find the…

A:

Q: mm. When subject to pressure, the hoop stress in

A:

Q: A steel bar ABCD consists of three sections: AB is of 20 mm diameter and 200 mm long, BC is 25 mm…

A:

Q: 2. An aluminum rod is 1.5 m long. For aluminum, Young's Modulus is E = 70 GPa. An axial force of 3…

A:

Q: Three steel plates, each 16 mm thick and width of 300 mm are joined by two 20 mm rivets as shown.…

A: The tensile stress in the rivet system is calculated by the formula given below as- σt=Pw-dt The…

Q: A 2-meter concrete column (Ec=30 GPa) is reinforced with six 25-mm diameter steel bars (Es=200 GPa)…

A:

Q: An axial centric force of magnitude P= 410 kN is applied to the composite block shown by means of a…

A: Given data,  h= 10 mm. Eb=105 GPa  Ea= 70 GPa.  P= 410kN.

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.