The rectangular bar shown is connected to a support bracket with a 24 mm diameter pin.  The width of the rectangular bar is 70 mm and its thickness is 15 mm.  The bearing stress in the bar cannot exceed 120 MPa.  Determine the maximum value of Pmax that can be supported based solely on consideration of the bearing stress in the bar.  Note:  This question is not asking about any stresses in the support bracket...just bearing stress in the rectangular bar.

Q: Fig structure carrying weight. The uniform bar AB weighs 1.1.4.4 shows a 300 N and carries a 500 N…

A:

Q: A 12 inches square steel bearing plate lies between an 8 inches diameter wooden post and a concrete…

A:

Q: A compression load of P = 55 kips is applied to a 3 in. by 3 in. square post, as shown. Determine…

A:

Q: 10. The homogeneous bar ABC that weighs 5000 Ib is supported by a smooth pin at C and a cable that…

A:

Q: 1.4 Axial loads are applied to the compound rod that is composed of an aluminum segment rigidly…

A: The normal stress (either tensile or compressive) developed in a member when it is subjected to an…

Q: Problem 07.007 - Internal forces on members of a bow - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL…

A:

Q: Stepped bar ABC is fabricated out of aluminum and supported by a fixed support at C as shown. The…

A:

Q: A steel pipe 120 mm external diameter and 60 mm internal diameter is subjected to an internal…

A:

Q: 2.46 A timber column, 8 in. by 8 in. in cross section, is reinforced on all four sides by steel…

A:

Q: A link is loaded as shown, it is attached with two bolts with a diameter of and its thickness is 0.1…

A: The diameter of bolt is The width of link is The thickness of link is The normal stress on link is

Q: Determine the normal stress perpendicular to plane AB and the shear stress parallel to plane AB

A: Determine the normal stress perpendicular to plane AB and the shear stress parallel to plane AB.

Q: Find the safe value of the axial load P in a circular column consists of circular 125mm wooden post…

A: Given data: The working stress for wood, σw=15 MPa. The working stress for concrete, σc=18 MPa. The…

Q: 3. A mild steel rod supports a tensile load of 50 kN. If the stress in the rod is limited to 100…

A: Given Data: Tensile load, P=50 kN Stress, σ=100 MPa

Q: A 1-m long copper bar is placed between two rigid, unyielding walls, as shown, with only one end…

A: The stress developed in the bar.Given:The length of the bar is .The temperature rise is .Obtain…

Q: The rectangular bar is connected to the support bracket with a 17-mm diameter pin. The bar width is…

A: Diameter of the pin: 17 mmWidth of the rectangular bar: w = 85 mmThickness of the rectangular bar:…

Q: 1- A cylindrical rod with a diameter of 20 mm and length of 100 mm is simultaneously subjected to a…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.