Two soil specimens with identical geometric dimensions were subjected to falling head permeability tests in the laboratory under identical conditions. The fall of the water head was measured after an identical time interval. The ratio of initial to final water heads for the test involving the first specimen was 1.25. If the coefficient of permeability of the second specimen is 5-times that of the first, the ratio of initial to final water heads in the tests involving the second specimen is

Two soil specimens with identical geometric dimensions were subjected to falling head permeability tests in the laboratory under identical conditions. The fall of the water head was measured after an identical time interval. The ratio of initial to final water heads for the test involving the first specimen was 1.25. If the coefficient of permeability of the second specimen is 5-times that of the first, the ratio of initial to final water heads in the tests involving the second specimen is

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 50 mm diameter and 90 mm-long silty clay sample was subjected to a falling head permeameter test using a setup similar to the one shown in Figure 6.4b, where the inner diameter of the standpipe was 3.0 mm. The head dropped from 870 mm to 450 mm in 5 minutes. What is the permeability of the sample?
The hydraulic conductivity of a soil sample (3.4 x 10-4 cm/s) has been determined via a permeability test. The water temperature was 28°C at the time of experiment. What is the hydraulic conductivity of the sample at the standard temperature of 20°C?
An in-situ density test on a 542.5 cm³ soil sample was conducted. The total weight of the sample at the site was 801.3 gr. Soil samples of the test were collected and moisture content was determined to be 4.5%. Assuming G, = 2.71 determine: (a) The in-situ unit weight of the soil in kN/m³. (b) The void ratio of the soil. (c) The porosity of the soil. (d) The degree of saturation.
3. A falling head permeability test is performed on a fine gravel soil. The soil sample has a length of 120mm and cross-sectional area of 600mm?.The water in the standpipe flowing into the soil is 0.60m above the top of the sample at the start of the test. It falls 50mm in 30 min. The standpipe has a cross- sectional area of 200mm?. a. Make a sketch of the described condition. b. What is the coefficient of permeability in millimeters per second? c. What is the coefficient of permeability in feet per minute? d. On the basis of the calculated value for k, what is the probable soil type?
The following results were recorded during a Falling head permeability test: Sample diameter = 120 mm Sample length = 140 mm Initial head = 510 mm Final head = 310 mm Standpipe diameter = 6 mm Duration of flow = 3.4 mins Determine the coefficient of permeability for the soil in m/s. Based on the coefficient of permeability estimate the soil type
From the constant head permeability test, the following values are given: Void ratio of specimen 0.46 Length of soil sample 450 mm Constant head difference 700 mm Water collected in a period of 180 seconds Cross-sectional area of soil sample 3.54 x 10-4 m³ 2.26 x 10-3 m² a.) Determine the coefficient of permeability in m/hour. b.) Compute the discharge velocity in mm/s. c.) Compute the seepage velocity in mm/s. d.) If the test was done at 24°C, what is its corrected coefficient of permeability?
A liquid limit test on a clay was performed with the following results. The natural water content of the clay is 38% and plastic limit is 21%. Number of Blows 6 12 20 28 32 Water content (%) 52.5 47.1 42.3 38.6 37.5 What is the liquid limit of this clay? (Use Interpolation) Group of answer choices 39.85% 39.99% 36.74% 38.63% Please answer this asap for upvote. Thanks
In a constant head permeability test in the laboratory as shown in Figure Q2(e), the data is recorded in Table Q2(b). The void ratio of the soil specimen is 0.46. Determine; (i) Hydraulic conductivity, k, of the soil in cm/sec. (ii) Discharge velocity in cm/sec.
Problem Set 2: 4. A sample of gray silty clay has a mass of 126 kg. Laboratory tests results give a moist density (p) of 2.05 g/cm³, a specific gravity of solids (G,) of 2.71, and a moisture content (w) of 15.7%. First determine all entries in the phase diagram. Then determine the void ratio (e), the porosity (n), the degree of saturation (S), the dry density (Pa), the dry unit weight (ya), and the moist unit weight (y). Draw the Phase diagram.
Tina 20 Two soil specimens with identical geometric dimensions were subjected to falling head permeability tests in the laboratory under identical conditions. The fall of water head was measured after an identical time interval. The ratio of initial to final water heads for the test involving the first specimen was 1.25. If the coefficient of permeability of the second specimen in 5 times that of the first, the ratio of initial to final water heads in the test involving the second specimen is
For a constant head laboratory permeability test on a fine sand, the following values are given: Length of specimen, L:6.75 in Diameter of specimen: 4 in Head difference,h: 23 in Water collected in 6 mins: 0.917in³ Void Ratio:0.23 Find the seepage velocity (Vs) in in/min
A liquid limit test on a clay was performed with the following results. The natural water content of the clay is 38% and plastic limit is 21%. Number of Blows 6 12 20 28 32 Water content (%) 52.5 47.1 42.3 38.6 37.5 What is the plasticity index of this clay? (Use Interpolation) Group of answer choices 15.74% 18.99% 18.85% 17.63% Please answer this asap for upvote. thanks