Two 3/8 x 6-in. plates are fastened by four 3/4-in-diameter rivets. Use P = 25 kips. find What is the maximum value of the normal stress on the plate? What is the shearing stress between the plates and the rivets? What is the bearing stress between the plates and the rivets?

Q: Draw the V&M diagrams and calculate the largest permissible value of P for the beam and loading…

A: Allowable normal stress in tension=-80MPa Allowable normal stress in Compression=-140MPa To find…

Q: Two gage marks are placed exactly 10 in. apart on a 1⁄2-in.-diameter aluminum rod with E = 10.1 x…

A: Given E = 10.1 × 106 psiUltimate strength = 16 ksiDistance between gage marks =10.009 inDiameter =…

Q: The rigid beam is supported by the two bars shown in a horizontal position before the load P is…

A:

Q: : What torque can be applied without exceeding the shearing stress of 65 MPa in the bolts? Bolt…

A:

Q: THE PLATE SHOWN IN THE FIGURE IS FASTENED TO THE FIXED ΜΕMBER BY FIVE 10- MM- DIAΜΕ TER RIVETS.…

A:

Q: SITUATION. A steel plate ABCD of thickness t Smm is subjected to uniform stresses E2000Pa, y 13…

A:

Q: 1. A stepped cyllindrical bar carries axial forces as shown. What is the maximum value of P for…

A: To determine the maximum value of P such that the tensile stress, 100MPa and compressive stress,…

Q: Determine the state of stress at point B on the cross section of the post at section a-a. Indicate…

A: solution attached below

Q: Part A If the bolt is subjected to a compressive force of P = 21.9 kN, determine the magnitude of…

A: Length of bronze and steel rod is same.The change in length of steel is equal to the change in…

Q: The bronze bar 3.08 m long with a cross-sectional area of 629 mm2 is placed between two rigid walls.…

A:

Q: Problem 4 The solid cylinders AB and BC are bonded together at B and are attached to fixed supports…

A:

Q: The assembly consists of a bronze tube and a threaded steel bolt. The pitch of the thread is 1/32…

A: To determine the final stress in the bolt and the tube.   Given, Pitch of the thread (s) = 1/32 in…

Q: Problem 1: The assembly below will be used for each problem. Lengths, diameters, and materials are…

A: A composite bar is given in above question comprised of three different materials having different…

Q: The plate has original dimensions 40 e strains Ex, Ey, and €₂?

A: We knowεx=σxE-μEσy+σz

Q: Determine the stress in each of the two vertical rods if the temperature rises 50 °C after the load…

A:

Q: If P=13000 N, d=22mm and t=33mm, determine the bearing stress between the rivets and plate, in MPa?

A:

Q: The staves or vertical members of the wooden tank are held together using semicircular hoops having…

A: The thickness of steel hoops = 0.5 inch Depth of steel hoops = 2 inch Internal Gauge Pressure = 2psi…

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.