Two gage marks are placed exactly 10 in. apart on a 1⁄2-in.-diameter aluminum rod with E = 10.1 x 106 psi and an ultimate strength of 16 ksi. Knowing that the distance between the gage marks is 10.009 in. after a load is applied, determine (a) the stress in the rod, (b) the factor of safety, (b) the corresponding normal stress in the wire.

Q: A plate having a width of 400 and a thickness of 20mm is to be connected to two plates with…

A:

Q: steel tube. Total axial deformation is 1 hat is the compressive load, P? Assume: uter dia. =1" nner…

A: Given data :Length of member (L)=20inAxial deformation = 0.5inModulus of elasticity of the steel is…

Q: For the what should be the mini mum tigure show n, dia meter OF the rivets attached as shown TF the…

A: bolted connection - nominal diameter - the actual diameter of the sunk ok the bolt is called the…

Q: afe strength of a 5/16 in. fillet weld if it's actual length is 3 1/2 in. and the allowable unit…

A:

Q: The steel assembly is constructed with a 0.25-inch-diameter pin at C and with 0.5-inch- diameter…

A: Given  ,  Tult , pin = 22 ksi                   σult = 58 ksiAlso , FOS =  σult σall =  Tult  Tall…

Q: The following image shows a front and side view of the column connection. The bolts have a diameter…

A:

Q: 1-66 Figure P1-69 shows a bolt subjected to a tensile load. One failure mode would be, if the…

A:

Q: Six rivets are used in the connection shown in the figure. If both P=50kN, what is the minimum…

A:

Q: A 12.5-mm round structural steel rod is loaded in tension to fracture. The 200-mm gage length of…

A: ASKED: To compute the average strain for the steel rod.   Given, Gage length of the rod (L) = 200 mm…

Q: The two wooden boards are connected by a 0.9 in. diameter bolt. Washers are installed under the head…

A:

Q: The steel shafts are connected together using a fillet weld as shown in the figure below. (Figure 1)…

A: T = 63 N. m

Q: direction lead on the roof - 50%-2 (23) 3³/2/1/1000 =18.29 KN alculate Reaction support 1 22 Wisse 2…

A:

Q: The lap joint is connected together using a 32 mm diameter bolt. Determine the permanent shear…

A: Given data in question Load 750 kN Diameter 32 mm To find out  Permenant strain

Q: Five plates with thickness t are bolted together by a bolt with diameter d. Which of the following…

A:

Q: Evercise:- A cylindrical rod 100 mm diameter of 12 mm long with is subjected to a 30000 N. Assuming…

A: Given,Initial length of the rod, say L = 100 mmInitial diameter of the rod, say D = 12 mmTensile…

Dependence on mechanical properties

The mechanical properties of materials are those structures that include the reaction to the load used. Metal switching features determine the scope of the usefulness of the content and establish the expected service life. Machine structures are also used to help distinguish and identify material objects. The most common mechanical properties considered are strength, ductility, stiffness, impact resistance, and resilience to fractures.