The two 11-kg slender rods are pin connected and released from rest at the position 8 = 60°. Neglect the mass of the roller at C. (Figure 1). Figure 2 m A B k = 20 N/m 2 m 1 of 1 > Part A If the spring has an unstretched length of 1.5 m, determine the angular velocity of rod BC, when the system is at the position 0 = 0°, measured counterclockwise. Express your answer using three significant figures. Enter positive value if the angular velocity is counterclockwise and negative value if the angular velocity is clockwise. 5. ΑΣΦ | Η | vec WBC = Submit Provide Feedback Request Answer ? rad/s Next >

The two 11-kg slender rods are pin connected and released from rest at the position 8 = 60°. Neglect the mass of the roller at C. (Figure 1). Figure 2 m A B k = 20 N/m 2 m 1 of 1 > Part A If the spring has an unstretched length of 1.5 m, determine the angular velocity of rod BC, when the system is at the position 0 = 0°, measured counterclockwise. Express your answer using three significant figures. Enter positive value if the angular velocity is counterclockwise and negative value if the angular velocity is clockwise. 5. ΑΣΦ | Η | vec WBC = Submit Provide Feedback Request Answer ? rad/s Next >

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The small end rollers of the 6.2-lb uniform slender bar are constrained to move in the slots, which lie in a vertical plane. At the instant when e = 30°, the angular velocity of the bar is 2.6 rad/sec counterclockwise. Determine the angular acceleration of the bar, the reactions at A and B, and the accelerations of points A and B under the action of the 5.1-lb force P. Neglect the friction and mass of the small rollers. The angular acceleration is positive if counterclockwise, negative if clockwise. The acceleration of A is positive if downward, negative if upward. The acceleration of B is positive if down the slot, negative if up the slot. The reaction at A Is positive If to the right, negative If to the left. The reaction at 8 Is positive If up and to the right, negative If down and to the left. L= 5.2 ft 107 P= 5.1 lb Answers: Jad/sec? F = Fg =
The system is at rest with the spring unstretched when theta = 0. the 5.3 kg uniform slender bar is then given a slight clockwise nudge. The value of b is 0.45 m. (a) if the bar comes to momentary rest when theta = 58, determine the spring constant k. (b) for the value k = 65 N/m, find the magnitude of the angular velocity of th ebar when theta = 38 degrees.
The 18-kg rod AB is pin-connected at A and subjected to a couple moment of M =15 N- m The rod is released from rest when the spring is unstretched at 0 = 30°. As the rod rotates, the spring always remains horizontal, because of the roller support at C. (Figure 1) Determine the rod' s angular velocity, measured clockwise, at the instant 0 = 60°. Express your answer using three significant figures. Enter positive value if the angular velocity is clockwise and negative value if the angular velocity is counterclockwise. vec rad/s k = 40 N/m 0.75 m M = 15 N- m
The 10-kg uniform cylinder is pin supported at its center O. The square isacted upon by a constant force F = 10N and a constant couple moment M = 10 Nm.If the disk starts from rest, determine1) The reactions at the pin O and the angular acceleration of the disk2) The number of revolutions it must take to attain an angular velocity of 10 rad/s
draw fbd and kd
The 2.28-kg uniform slender bar rotates freely about a horizontal axis through O. The system is released from rest when it is in the horizontal position 0 = 0 where the spring is unstretched. If the bar is observed to momentarily stop in the position 0 = 66°, determine the spring constant k. For your computed value of k, what is magnitude of the angular velocity of the bar when 0 = 48°. B 0.85 m 0.85 m 2.28 kg 0.29 my Answers: k = i N/m ω- rad/s 1
At the instant shown, the spring is un-deformed. Determine the change in potential energy if the 20 kg disk (with radius of gyration kG = 0.5 m) rolls 2 revolutions without slipping. k= 200 N/m 3 m/s datum 0.3 m M = 2 Nm 30° O 1791 J O -1791 J O 1051 J O 1421 J O E) None of the above
The 3.8 kg block is descending at a rate of 1.2 m/s when the hydraulic cylinder BC exerts a force F=500 N on the brake arm. Determine the number of radians the wheel will rotate before the system comes to rest. The wheel has a mass of 25 kg and a radius of gyration about its center kO=300 mm. The coefficient of kinetic friction between the brake arm and the wheel is 0.25.
1- The bucket is hoisted by the rope that warps around a drum wheel. If the angular displacement of the wheel is 9 =(3t2-7t) rad, where t is in seconds, determine the velocity and acceleration of the bucket when t= 5 sec
The system is made up of the 1-m, 6.7-kg uniform rod AB and the two uniform disks (each of 0.10 m radius and 2.2 kg mass). If the system is released from rest when 0- 55", when rod AB has just become horizontal, determine the angular velocity of rod ABin rad/s. Assume the disks roll without slipping. Your answer must include 2 places after the decimal point. Please pay attention: the numbers may change since they are randomized. Take g= 9.81 m/s?. 1m
The uniform 80 kg slender rod is at rest in the position shown when P = 450 N is applied. Determine the value of angular velocity, w2 the rod if L1 = 5.5 m and L2 = 6.5 m. A L L2 L1 B
0₁ Oy || 5 Kronk is asked to pull the lever. He applies a force of 20 N, causing the 8 kg lever to have an angular rad velocity of 3 || 6 8 . Determine the angular acceleration of the lever and the reaction forces at O. Assume the lever is a slender rod and that the lever was originally propped up to be level horizontally. The prop was removed at the instant Kronk applied the force. α = 5 Kronk applies the force at a length 7 and the lever has length 1 = 0.2 m. Use negative if CW 1 N N 1 rad 8² F (0) -CCW