At the instant shown, the spring is un-deformed. Determine the change in potential energy if the 20 kg disk (with radius of gyration kG = 0.5 m) rolls 2 revolutions without slipping. k = 200 N/m www 3 m/s datum 0.3 m M = 2 Nm 30 O 1791 J O -1791 J O 1051 J O 1421 J O E) None of the above

At the instant shown, the spring is un-deformed. Determine the change in potential energy if the 20 kg disk (with radius of gyration kG = 0.5 m) rolls 2 revolutions without slipping. k = 200 N/m www 3 m/s datum 0.3 m M = 2 Nm 30 O 1791 J O -1791 J O 1051 J O 1421 J O E) None of the above

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

stion 5 The 20-kg wheel has a radius of gyration ko = 400 mm where O is the center of the wheel. If the wheel is subjected to a moment, M = (2t) N.m, where t is in seconds, determine its angular velocity when t- 4s starting from rest. Assume the wheel is subjected to rotation only (no translation). OA 16.0 rad/s B. 10.0 rads oc 8.0 rad/s 0 5.0 rad/s
The 250 g disk shown spins at the rate w1 = 750 rpm, while axle AB rotates as shown with an angular velocity ω2 of 6 rad/s. Find the Kinetic energy of the disk with this information.
Az 0 Ay 392 F α= 4.425 с At the instant the wire at B snaps, determine the reaction forces at A and the angular acceleration of the 200 kg beam if a force of 200 N is applied at point C. Assume the beam is a slender rod. Point B is located I m away from point A, and the beam has a length 1: 4 m. ON x N X 00 rad $² A UBC Engineering
Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. A uniform slender rod of length L = 900 mm and mass m = 4 kg is suspended from a hinge at C. A horizontal force P of magnitude 75 N is applied at end B. A Ja B C P Determine the corresponding angular acceleration of the rod. The corresponding angular acceleration of the rod is rad/s² O.
The slender 12-kg bar has a clockwise angular velocity of w = 2 rad/s when it is in the position shown Suppose that L = 2.9 m. (Figure 1) Figure 60⁰° 1 of 1 Part A Determine its angular acceleration, measured clockwise. Express your answer using three significant figures. Enter positive value if the angular acceleration is clockwise and negative value if the angular acceleration is counterclockwise. α = Submit Part B NA = Submit Part C 195| ΑΣΦ 41 Determine the magnitude of the normal reaction of the smooth surface A at this instant. Express your answer to three significant figures and include the appropriate units. NB = Submit Request Answer 0 μÅ Value Request Answer μA vec Value Request Answer Units Determine the magnitude of the normal reaction of the smooth surface B at this instant. Express your answer to three significant figures and include the appropriate units. 2 Units ? = ? rad/s² ?
The system is at rest with the spring unstretched when theta = 0. the 5.3 kg uniform slender bar is then given a slight clockwise nudge. The value of b is 0.45 m. (a) if the bar comes to momentary rest when the angle = 58, determine the spring constant k. (b) for the value k = 65 N/m, find the magnitude of the angular velocity of the bar when the angle = 38 degrees. a) k = 70.634 N/m
The radius of the pulley is of inertia is I = 0.1 kg-m2. R = 100 mm The mass stant is k = 135 N/m. m = 5 kg. and its moment The spring conThe system is released from rest with the spring unstretched. What maximum distance does the mass fall before rebounding?
ω F A 2 kg ball with radius 9 cm and radius of gyration of 7 cm is moving to the right at 2 m/s while a 5 N force is applied, accelerating its motion. It is currently backspinning (and therefore slipping) at w = 4 rad/s, with μk = 0.3. Find the acceleration of the balls center and also the angular acceleration of the ball at this instant a = m (positive right) $2 rad απ (positive $2 CCW)
if mass (m)=345kg radius of gyration kG = 0.54 m θ= 200 degree 1) assuming no slipping and when starting from horizontal cable (θ = 0o) the spool moves to the left- determine the minimum tension in the cable (Tmin) that causes the spool to slip. Assumeμk = 0.4 and μs = 0.5.
A drum can rotate about a fixed-point O. The A block is attached to a cord wrapping around the drum. The mass of the drum is md = 100kg and the radius is r = 0.5 m. The radius of gyration of the drum about point O is ko=0.3 m. The mass of the block is mb= 20kg. The block is released from rest. The acceleration due to gravity is g=9.81 m/s2. (1) Calculate the mass moment of inertia of the drum about the point O, IO_______(kgm2) (two decimal places)
The gear is pinned at A and has a mass of 0.3 kg and a radius of gyration of k = 25 mm. The gear rack has a mass of 0.5 kg. (Figure 1) Figure Part A W VE| ΑΣΦ | 4t | vec 8.11 Submit 50 mm If the spring has a stiffness k = 40 N/m and is stretched 50 mm and released from rest, determine the angular velocity of the gear at the instant the spring compresses 20 mm. Neglect friction. Express your answer in radians per second to three significant figures. im Previous Answers Request Answer SMD M-d ? 1 of 1 rad/s
Please and thank