The top has a mass of 1 kg and radius of gyration of k, = 25 mm about its axis of symmetry. The top spins and precesses about the ball-and-socket joint at point O. It's transverse radius of gyration about point O is k = 63 mm. The spin velocity is ws = 150 rad/s. • Under these conditions. determine the two possible precession velocities op of the top. Determine the kinetic energy of the top for each of the two possible precession velocities.

The top has a mass of 1 kg and radius of gyration of k, = 25 mm about its axis of symmetry. The top spins and precesses about the ball-and-socket joint at point O. It's transverse radius of gyration about point O is k = 63 mm. The spin velocity is ws = 150 rad/s. • Under these conditions. determine the two possible precession velocities op of the top. Determine the kinetic energy of the top for each of the two possible precession velocities.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A cicular dise of 100 kg mass and Im diameter is supported between two bearings on a shaft of negligible weight as shown in Fig. These bearings are supported by vertical thin cords. When the dise is rotating at 100 rad/s in clockwise direction when looking from the right hand side bearing, the right cord gets broken. For this configuration determine the motion of precession in direction and magnitude also in details discuss the effect of gyroscopic couple on the rotating disc. 1.25m ofe 0.75. Z
The 150-kg wheel shown in Fig. In the initial position shown, the velocity of Gis 2 m/s down the plane, and the spring is stretched 150 mm. If the spring modulus is 1000 N/m, what will be the maximum stretch of the spring? has a radius of gyration of 360 mm with respect to its center of mass G. www 150 kg 30°
The wheel is attached to the spring. The mass of the wheel is m=20 kg. The radius of the wheel is 0.6m. The radius of gyration kG=0.4 m. The spring’s unstretched length is L0=1.0 m. The stiffness coefficient of the spring is k=2.0 N/m. The wheel is released from rest at the state 1 when the angle between the spring and the vertical direction is θ=30°. The wheel rolls without slipping and passes the position at the state 2 when the angle is θ=0°. The spring’s length at the state 2 is L2=4 m. (9) The mass moment of inertial about the IC center is IIC =_________(kg·m2 ) (two decimal places)
8:19 AM 0.4KB/s अमन Airtel 2 minutes ago Tel A car is moving on a curved horizontal road of radius 100 m with a speed of 20 m/s. The rotating masses of the engine have an angular speed of 100 rad/s in clockwise direction when viewed from the front of the car. The combined moment of inertia of the rotating masses is 10 kg-m². The magnitude of the gyroscopic moment (in N-m) is 77%
A uniform disc having a mass of 10 kg and a radius of gyration of 175 mm is mounted on one end of a horizontal arm of 500-mm length. The other end of the arm can rotate freely in a universal bearing. The disc is given a clockwise spin of 350 rpm as seen from the disc end of the arm. Determine the angular velocity of precession.
A homogeneous sphere of mass m and radius a is welded to a rod AB of negligible mass, which is held by a ball-and-socket support at = with no spin or nutation. Determine the largest A. The sphere is released in the position B=0 with a rate of precession Po value of ß in the ensuing motion. Z A B The largest value of Bis O 26g 11a
The wheel is attached to the spring. The mass of the wheel is m=20 kg. The radius of the wheel is 0.6m. The radius of gyration kG=0.4 m. The spring’s unstretched length is L0=1.0 m. The stiffness coefficient of the spring is k=2.0 N/m. The wheel is released from rest at the state 1 when the angle between the spring and the vertical direction is θ=30°. The wheel rolls without slipping and passes the position at the state 2 when the angle is θ=0°. The spring’s length at the state 2 is L2=4 m. (1) If the mass center G is set as the origin (datum), the gravitational potential energy at the state 1 is___ (two decimal places)
The rolling motion of the circle with a zero mass is defined by a velocity V-1.2m.s at the Center of the disk. Calculate d=12m the ongulor Veldrity W. At the time Os is W=0. 163
if mass (m)=345kg radius of gyration kG = 0.54 m θ= 200 degree 1) assuming no slipping and when starting from horizontal cable (θ = 0o) the spool moves to the left- determine the minimum tension in the cable (Tmin) that causes the spool to slip. Assumeμk = 0.4 and μs = 0.5.
A drum can rotate about a fixed-point O. The A block is attached to a cord wrapping around the drum. The mass of the drum is md = 100kg and the radius is r = 0.5 m. The radius of gyration of the drum about point O is ko=0.3 m. The mass of the block is mb= 20kg. The block is released from rest. The acceleration due to gravity is g=9.81 m/s2. (1) Calculate the mass moment of inertia of the drum about the point O, IO_______(kgm2) (two decimal places)