The three-phase power and line-line ratings of the electric power system shown inFigure-1 are given below:G,:(first and Last digit of SAP ID) MVAT:(G,rating-10) MVAT(G,rating-10) MVAM:((T,rating-10)) MVA30 kVX=10%30/300 kVX=11%300/30 kVX=11%25 kVX=9%Line:30 kVZ=First two digits of SAP ID + j (2× first two digits of SAP ID)T1T2VmLine2GMFigure 1• Apply the knowledge of per unit system on above network and draw an impedancediagram showing all impedances in per unit when S, = 100 MVA and V, = 30 kV

The three-phase power and line-line ratings of the electric power system shown Figure-1 are given below: G,:(first and Last digit of SAP ID) MVA T,:(G,rating-10) MVA T,:(G,rating-10) MVA M:((T,rating- 10)) MVA Line: 30 kV X=10% 30/300 kV X=11% 300/30 kV X=11% 25 kV X=9% 30 kV Z-First two digits of SAP ID + j (2x first two digits of SAP ID) T T2 Vm Line 2 G M

The three-phase power and line-line ratings of the electric power system shown Figure-1 are given below: G,:(first and Last digit of SAP ID) MVA T,:(G,rating-10) MVA T,:(G,rating-10) MVA M:((T,rating- 10)) MVA Line: 30 kV X=10% 30/300 kV X=11% 300/30 kV X=11% 25 kV X=9% 30 kV Z-First two digits of SAP ID + j (2x first two digits of SAP ID) T T2 Vm Line 2 G M

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Which termination would result to a phase change of 180 degrees at the load if Zo = 100 ohm? a. 50 ohm b. short circuit c. 75 ohm d. all of these What is the purpose of impedance matching? a. maximum return loss b. maximum SWR c. maximum load power d. maximum reflection A short piece of transmission line that may be open or shorted and used for impedance matching purposes. a. converter b. decoder c. stub d. transformer
2) The power system consists of generators, motors, transformers, and transmission lines. The ratings are as follows: G1: 3-phase generator 25 MVA, 11 KV, X = 20% M1: 3-phase motor M2: 3-phase motor T1:3 single phase transformers T2: 3-phase transformer Line: 15 MVA, 13 KV, X = 25% 7.5 MVA, 13 KV, X = 25% Single phase transformer rating 30 MVA, 6.9/69 KV X = 10% Three phase transformer rating 30 MVA, 13.8/69 KV X = 10% Χ - 50 Ω = Τι G₁ 2. Line Figure 1. 3 T2 Σ M₁ Δι M2 Find the reactance (X) in p.u. units, given the base value of 25 MVA, 11 KV.
Referring to the circuit shown in Figure 1 below, solve the following problems: - i) Calculate the total impedance, ZT. ii) Determine the total current, Ir supplied by the generator iii) Determine the value of current at load impedance, I1, I2 and I3. iv) Calculate total real power, PT and reactive power, Qr supplied by the generator. v) Draw a power triangle of this circuit vi) Calculate the power factor of this circuit.
There is a three-phase system such that the phase current in the generator, lines and charging phase is the same. The phase voltage in the generator must be 1000 [V] with clockwise sequence. The connected load must be such that the phase current in each load is 10 [A] and its power factor is 0.97 “lagging”. a) Determine phase currents in the generator, lines and phase in the load
The steady-state voltage drop between the load and the sending end of the line seen in (Figure 1) is excessive Suppose that V-4950/0° V (rms). A capacitor is placed in parallel with the 192 kVA load and is adjusted until the steady-state voltage at the sending end of the line has the same magnitude as the voltage at the load end, that is, 4950 V (rms). The 192 kVA load is operating at a power factor of 0.8 lag. Part A Calculate the size of the capacitor in microfarads if the circuit is operating at 60 Hz. In selecting the capacitance, use the value that results in the lowest possible power loss in the line. Express your answer in microfarads to three significant figures. ▸ View Available Hint(s) Figure 1 of 1 202 1100 192 kVA 0.8 lag ΜΕ ΑΣΦ. 11 vec C= 22.8 Submit Previous Answers Incorrect; Try Again; 5 attempts remaining Provide Feedback ? F
Figure below shows a power system. The rating of generators and transformers are:G1:25MVA, 6.6KV, jO.2 p.u. G2:15MVA, 6.6KV, jo.15 p.u. G3:30MVA, 13.2KV, jo.15 p.u. T1: 30MVA, 6.6A- 115Y KV, jo.1 p.u.T2: 15MVA, 6.6A- 115Y KV, jo.1 p.u. T3:single phase units each rated 10MVA, 69/ 6.9 KV, jo.1 p.u. Find te reactances in p.u, take a base of 30MVA, 6.6 KV in the circuit of G1 .=.XG1 G2} 4 A lubu T2 T1 T3 G1 G3 j120 2 j90 N
Power engineering book Mehta
Question 1) A 154 kV transmission line has a length of 100 km. The line and the conductors are given in Figure 1. The line is operated at f= 50 Hz. For both old and new lines calculate; a. GMD and GMR. b. Inductance of the line in Henries (H). c. Series Impedance (Z) of the line in Ohms. d. *Compare the results for both lines and comment on the results. e. *If the distance between the two neighbouring conductors is increase from 13 meters to 15 meters what would be the parameters in part a.,b. and c. comment on the results. New Line's Conductors 13 m 13 m Old Line's Conductors d r = 2 cm d = 40 cm r = 2 cm Figure 1
For the system shown in figure, voltages V2, V3 and angles 82, 83 are calculated using Newton-Raphson method. shunt line charging admittances are neglected. All the values are given in per unit on 100MVA base. Calculate the complex power flows S12 and S32 in actual units. 1) Z12 = 0.01+ j0.02 Z3 = 0.02+ j0.04 PL G QL Slack bus V2 = 0.96L -1.67° V3 = 0.884 - 5.48° Vi=1.0/0° (estimated time to answer this question: 13 minutes)
3. A circuit consists of two impedances. Z1 =20230° and Z2 =25260° 2, in parallel, supplied by a source voltage V=1002600 volts. Determine the power triangle for each of the impedances and for the source.
A system consists of four idenital 400 MVA generating units feed- ing a total load of 1016 MW. The intertia constant of each unit is 5 on 400 MVA base. The load changes by 1.5% for a 1% change in frequency. When there is sudden drop in load by 16 MW, obtain the power system time constant (T) with constants H and D expressed on 1600 MVA base.
A three-phase transmission line and a telephone line are supported on the same towers a shown in the figure. The power line carries a 60-Hz balanced current of 200-A per phase . the telephone line is located directly below phase b. assuming balanced three-phase currents in the power line, find the voltage per kilometer induced in the telephone line. 3.6 m 3.6 m Dal Da2 Del De 4 m 11.2 m-