The system shown is in static equilibrium and motionless. Pulley-E and Pulley-F are ideal. NOTE: Submitted responses shall be to 4 significant figures. Do NOT use scientific notation. o Additionally, angles will be reported with 2 decimal places. Find: 1. The magnitude of the internal force in the section of rope labeled as "1" is LB. 2. The magnitude of the internal force in the section of rope labeled as "4" is LB. 3. The magnitude of the internal force in the section of rope labeled as "3" is LB. 4. The magnitude of the internal force in the section of rope labeled as "5" is LB. 5. The magnitude of the angle O (theta) is -4 5 1 30° 3 2- A 120 lb B 150 lb

Q: Blocks in (Figure 1) A and B have a mass of 9 kg and 10 kg, respectively. gure 400 mm 300 mm 8 DO…

A: Mass of block A (mA) = 9 KgMass of block B (mB) = 10 kgCoefficient of friction of A () =…

Q: Determine the max torque that can be applied to a bicycle crank arm . A fillet exists on the wall…

A:

Q: If the wire has a diameter of 0.9 in., determine how much it stretches when a horizontal force of…

A: A36 steel d = 0.9 in P = 2.5 kips

Q: The force F = 45O Ibs acts on the frame. Resolve this force into components acting along members AB…

A: From the given information we have to calculate the reaction at the member AB and AC

Q: 3 m Reactions @A Ic Ax = A₁ = MA = Internal Loads @C V = M= N = 3 m ts) s) 8 kN/m 3 m Force lagram…

A:

Q: A solid stainless steel [G= 12,500 ksi] shaft that is 30 in. long will be subjected to a pure torque…

A:

Q: Learning Goal: To replace force-couple systems with an equivalent force by specifying the magnitude…

A: Replace force and couple system with an equivalent force by specifying the magnitude of the force,…

Q: A cantilever beam OABC shown in Figure 5 is subjected to the forces and moment as shown. Compute the…

A:

Q: Calculate the stiffness of the I-beam with respect to the y-axis when h = 190, b = 100, t1 = 9 and…

A: Given: h = 190 b = 100, t1 = 9 and t2 = 6 mmRequired: stiffness of the I-beam with respect to the…

Q: Please do Part C, E, and F

A: To solve part C,E and F

Q: n W or = 3.35 The electric motor exerts a 500 Nm-torque on the aluminum shaft ABCD when it is…

A:

Q: Consider the beam shown in (Figure 1). Take P = 2 kip and w = 1.9 kip/ft. Point E is just to the…

A: A beam is roller supported at A and fixed at C, also an internal hinge is present at B.At the…

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.