the sign 4. Use Lenz's law to determine whether the induced current in the resistor R is from A to B or from B to A in the 4 configurations in Fig. 3. You should label the direction of B of ADB / At, the direction of Binduced and the direction of I source" and the direction of Iinduced in the coil and R for each of the 4 cases. A R A R B B N N (1) (2) S S A R A R B B N S (3) (4) S S N Figure 3 Four configurations

the sign 4. Use Lenz's law to determine whether the induced current in the resistor R is from A to B or from B to A in the 4 configurations in Fig. 3. You should label the direction of B of ADB / At, the direction of Binduced and the direction of I source" and the direction of Iinduced in the coil and R for each of the 4 cases. A R A R B B N N (1) (2) S S A R A R B B N S (3) (4) S S N Figure 3 Four configurations

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 41P: In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a...

See similar textbooks

Similar questions

The magnetic flux through the loop shown in the accompanying figure varies with time according to m=2.00e3tsin(120t) , where m is in milliwebers. What are the direction and magnitude of the current through the 5.00 resistor at (a) t= 0; (b) t=2.17102 s and (c)t=3.00 s?
The armature and field coils of a series-wound motor have a total resistance of 3.0 . When connected to a 120-V source and running at normal speed, the motor draws 4.0 A. (a) How large is tire back emf? (b) What current will the motor draw just after it is turned on? Can you suggest a way to avoid this large initial current?
Use Lenz’s law to determine tl direction of induced current in each case.
A small, rectangular single loop of wire with dimensions 1, and a is placed, as shown in the plan of a much larger, rectangular single loop of wire. The two short sides of the larger loop axe so far from the smaller loop that their magnetic fields over the smaller fields over the smaller loop can be ignored. What is the mutual inductance of the two loops?
Check Your Understanding A long solenoid of cross-section area 5.0 cm2is wound with 25 turns of wire pet centimeter. It is placed in the middle of a closely wrapped coil of 10 turns and radius 25 cm, as shown below. (a) What is the emfInduced In the coil when the current through the solenoid Is decreasing at a rate dl/dt= -0.20A/s? (b) What Is the electric field Induced In the coil?
Check Your Understanding Shown below is a rod of length l that is rotated counterclockwise around the axis through O by the torque due to mg . Assuming that the rod is in a uniform magnetic field B , what is the emf induced between the ends of the rod when its angular velocity is ? Which end of the rod is at a higher potential?
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
A single-turn circular loop of wire of radius 50 mm lies in a plane perpendicular to a spatially uniform magnetic field. During a 0.10-s time interval, the magnitude of the field Increases uniformly from 200 to 300 mT. (a) Determine the emf Induced in the ioop. (b) If the magnetic field is directed out of the page, what is the direction of the cun-ent induced in the loop?
Check Your Understanding. A current I(t)=(5.0A)sin((200rad/s)t) flows through the solenoid of part (b) of Example 14.1. What is the maximum emf induced in the surrounding coil?
Check your Understanding Themagneticfield shown below Is confined to the cylindrical region shown and is changing withtime. Identity those paths for which =EdI0 .
The accompanying figure shows a conducting ring at various positions as It moves througli a magnetic field. What is the sense of the induced em! for each of those positions?
Two long, parallel wires cy equal currents in opposite directions. The radius of each wire is a, and the distance between the centers of the wires is d, Show that if the magnetic flux within the wires themselves can be ignored, the self-inductance of a length 1 of such a pair of wires is L 0 l in d1 a (Hint Calculate the magnetic flux through a rectangle of length 1 between the wires and then use L=N/I