The sewage is flowing at the rate of 4.7 million litres per day from a primary clarifier to a standard rate trickling filter. The BOD of the influent is 150 mg/l. The organic loading rate is 160 gm/m³/day and surface loading rate is 2000 l/m²/day. Calculate the depth of the filter in meter.

The sewage is flowing at the rate of 4.7 million litres per day from a primary clarifier to a standard rate trickling filter. The BOD of the influent is 150 mg/l. The organic loading rate is 160 gm/m³/day and surface loading rate is 2000 l/m²/day. Calculate the depth of the filter in meter.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

2. The average wastewater flow from a community of 20,000 is 125 gpcd. The 5 day, 20 deg C BOD is 250 mg/L. The suspended solids content is 300 mg/L. A final plant effluent of 50 mg/L of BOD is to be achieved through the use of two sets of identical settling tanks and trickling filters operating in parallel. The settling tanks are to be designed to a standard of 1000 gpd/^2. The trickling filters are to be 6^ deep and operated at an organic loading of 55 lbm/1000^3 d. There is no recirculalon. (1) What settling tank surface area is required? In ft^2 (2) What settling tank diameter is required? In ft (3) Estimate the BOD removal in the settling tanks? In percent % (4) What is the trickling filter diameter? In ft File Explorer O Expert Q&A | Cheq... (66) These
After primary treatment, a municipal wastewater contains 150 mg/L BOD5. The wastewater flow of 0.44 m³/s (10 MGD) is then treated in an activated sludge system with an SRT of 12 d and an HRT of 6 h. Given the biokinetic parameters tabulated below, determine the aeration volume (m³). Parameter Value 3d¹ 60 mg/L BODs 0.10 d¹ 0.6 mg VSS/mg BOD5 Hmax Ks ka Y
The concentration of suspended solids in the flow is 2500 g/m3. Knowing that (SS) come into the clarifier each day is (31275 Lbs/day). Determine The flow to a clarifier in MGD ? Select one: O a. 1.5 O b. 1.2 O c. None O d. 1.3
Subject: Environmental science Give me right solution A stream receiving sewage effluent has an initial DO deficit of 1.5 mg/L at the discharge point of this sewage. DO deficit at the downstream critical point is 4.5 mg/L. The stream has a saturated DO of 8.0 mg/L under the ambient temperature condition. The lowest DO downstream of this effluent is _____ mg/
2. The average wastewater flow from a community of 20,000 is 125 gpcd. The 5 day, 20 deg C BOD is 250 mg/L. The suspended solids content is 300 mg/L. A final plant effluent of 50 mg/L of BOD is to be achieved through the use of two sets of identical settling tanks and trickling filters operating in parallel. The settling tanks are to be designed to a standard of 1000 gpd/^2. The trickling filters are to be 6^ deep and operated at an organic loading of 55 lbm/1000^3 d. There is no recirculalon. (1) What settling tank surface area is required? In ft^2 (2) What settling tank diameter is required? In ft (3) Estimate the BOD removal in the settling tanks? In percent % (4) What is the trickling filter diameter? In ft domeved Ward
A storm sewer is mixed into a small stream. The stream before the mixing point has a NaCi concentration of 25 mg/L. If the storm sewer has a Nacl concentration of 1.8 g/L and the storm sewer flowrate is 2.5 L/min, calculate for the concentration of the salt in the stream after the discharge point (mixing point). The stream has a flowrate of 2.6 cu.m/s. Assume a complete mixing of the storm sewer flow and the stream flow. Assume also that the salt is nonreactive and that the system is at steady state.
Water treatment plant : SOR = 0.35 mm/sec; The analysis of this water found that there are 6 different particle sizes: 0.1 mm with settling velocity of 0.2 mm/sec; and percentage of particles = 10 %; 0.2 mm with settling velocity of 0.25 mm/sec; and percentage of particles = 20 %; 0.3 mm with settling velocity of 0.3 mm/sec; and percentage of particles = 15 %; 0.4 mm with settling velocity of 0.35 mm/sec; and percentage of particles = 5 %; 0.5 mm with settling velocity of 0.4 mm/sec; and percentage of particles = 30 %; 0.6 mm with settling velocity of 0.5 mm/sec; and percentage of particles = 20 %; Calculate the efficiency of this tank ?
6. After your flash mix the water was sent to a clarification basin that was 24 feet in diameter and 20 feet tall. What was the detention time in hours of 0.43 MGD? 5.4 hours 4.3 hours 3.8 hours 2.3 hours After the water leaves your sedimentation basin, it is ready for filtration. Your two filters measure 10 feet in diameter. What is the filtration rate is gpm for your flow of 0.43 MGD? 19 gpm/sq/ft 29 gpm/sq/ft 39 gpm/sq/ft 49 gpm/sq/ft You have had a filtration breakthrough (failure) and have brought your old roughing filtration system on line. The old filter is 8 feet square and 4 feet deep. What is the filtration rate in gpm/sq/ft for your flow of 0.43 MGD? 10.33 gpm/sq/ft 8.55 gpm/sq/ft 5.99 gpm/sq/ft 4.66 gpm/sq/ft
C A trickling filter plant treats 1500 cum per day of sewage with a BOD, of 220 mg/L and a suspended solid concentration of 250 mg/L. Estimate the total solid production assuming that primary clarification removes 30% of BOD and 60% of influent solids. Take the solid production in the trickling filter as a 0.5 kg/kg of the applied BOD.
Q-The MLSS concentration in an aeration tank is 2000 mg/l and the sludge volume after 30 minutes of setting in a 1000 ml graduated cylinder is 175 ml. Find the value of sludge density index (SDI).
COURSE: ENV 2
Only find the BOD of the mixture.