The segmental arch of span 90cm over a window¯opening is equilateral onthe span and radil. If the orch ring is 20cm thick and the thickness of wall is 30cmestimate the quantity of brickwork in 10 such arches.

Answered: Image /qna-images/answer/733b20ea-0af0-4f42-9cd8-bca5d6df61ef.jpg

The segmental arch of span 90cm over a window¯opening is equilateral on the span and radii. If the orch ring is 20cm thick and the thickness of wail is 30cm estimate the quantity of brickwork in 10 such arches.

The segmental arch of span 90cm over a window¯opening is equilateral on the span and radii. If the orch ring is 20cm thick and the thickness of wail is 30cm estimate the quantity of brickwork in 10 such arches.

Architectural Drafting and Design (MindTap Course List)

7th Edition

ISBN:9781285165738

Author:Alan Jefferis, David A. Madsen, David P. Madsen

Publisher:Alan Jefferis, David A. Madsen, David P. Madsen

Chapter32: Drawing Framing Plans

Section: Chapter Questions

Problem 32.13Q

See similar textbooks

Related questions

Q: A continuous solid slab system shown in Fig. (1) supported by beam with (bw=300 mm and h=650 mm) and…

Q: Analyze the frame using Portal Method

Q: Design a uniform distribution of vertical and hori- zontal reinforcement for the structural wall…

A: Consider the given figure.

Q: Consider an inner beam-column joint in the ground floor roof of a eight storey building in Noida,…

Q: Using transformed area, what allowable uniform load can this beam support in addition to its own…

A: Transformed area method: It is a commonly accepted method for the analysis of member load mainly for…

Q: P01: For the continuous floor system in Fig 1 below, calculate the following: a. be for the beam…

A: Compressive strength of concrete, Yield strength of steel, Width of web, Thickness of slab, To…

Q: Design and detail a one-way slab both end continuous having span of 6m. The slab is to carry a…

Q: A300 mm x 300 mm reinforced concrete column shown is reinforced with 8-16 mm diameter bars with fy -…

A: Transverse reinforcement spacing should be minimum of 48* dia of tie bars 16*dia of main bar Least…

Q: PROBLEM LECTURE 1.3 (CE BOARD NOV. 1999) : A spiral column has a diameter of 600mm. If fc`=21MPa, fy…

Q: Design a uniform distribution of vertical and horizontal reinforcement for the structural wall shown…

A: The nominal flexural strength at the base is calculated:(Mu)Base=Load…

Q: simply supported beam is reinforced with 5-25mm-diameter at the bottom and 2-20mm-diameter at the…

Q: 2.48 Water, oil, and an unkown fluid are contained in the verti- cal tubes shown in Fig. P2.48.…

A: Since the tube is open to atmosphere, so the net préssure on the surface of liquid in both limbs…

Q: Question 1 (a) Differentiate between Ultimate Limit State and Serviceability Limit State giving…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: A 300 mm X 450 mm exterior beam is reinforced with 2 - Ø20 mm and 1 – Ø25 mm bars on the first layer…

Q: simply supported beam is reinforced with 5-ϕ25 mm at the bottom and 2-ϕ20 mm at the top of the beam.…

Q: Example 1: Estimate the Slab reinforcement for the given figure below. All the straight bottom bars…

Q: [Situation 6] The inverted T-beam shown is post - tensioned with cables having a total area of 14…

Q: For a three-hinged parabolic arch, what will be the ratio L/R to satisfy H = W?

A: Given: in a three hinged arch H=W To find: L/R

Q: Consider a three hinged parabolic arch as shown in figure below: 50 KN 5m- B 9m 30 m What will be…

Q: increasing the length of the beams will *

A: In construction beams are horizontal, weight-bearing supports that span between columns or posts.…

Q: What is the minimum required area of steel reinforcement (in sq.mm.) for a 120mm thick one way slab…

A: Given data Depth of one way slab (D) = 120 mm Width of slab (B) = 1m = 1000 mm Grade of concrete…

Q: What is the maximum required spacing (in mm.) of the main reinforcement for a 120mm thick one way…

A: Given: A unit strip of a one-way slab of depth(d) = 120mm, and the yield-strength of steel as fy =…

Q: QI/ Choose the Correct Answer? 1. Queen closer may be placed A. In header course B. In stretcher…

A: Note- Since we only answer up to 3 sub-parts, we’ll answer the first3. Please resubmit the question…

Q: As a Consulting Professional Engineer, you are required to provide a complete detailed structural…

A: hw = Height of wall = H = 14 ft hw = 14×12 = 168 in h = Wall thickness = 10 inlw = Length of wall =…

Q: 4. How would the capacity of the shear wall with aspect ratio 3:1 be different from shear wall with…

Q: Design a cavity wall (specify thickness of the wall, mortar to be used, strength of masonry,…

A: Organizing the fundamentals:- Vicinity: Galveston, Texas, method we want to don't forget wind…

Q: Q.20 The main reinforcement in RC slab consists of 10 mm diameter bars at 100 mm c/c spacing. When…

A: Given data- An RC slab- 10 mm diameter bars- 100 mm c/c spacing, 10 mm bars are replaced by 12 mm…

Q: P01: For the continuous floor system in Fig 1 below, calculate the following: a. be for the beam…

A: To determine:Design moment capacity for the following beams

Q: Given a singly reinforced rectangular beam with fc'= 35MPA and fy = 345MPA What is the minimum steel…

A: Given: The values of stresses are,

Q: What is the stage before failure of an axially loaded prestressed member?

A: The phenomenon of inducing stress in the concrete in order to make it structurally stable is called…

Q: Under what circumstances will de use of an arch become appropriate

A: Modern arches of steel, concrete and laminated wood are highly rigid and light weight, so that the…

Q: A one way simply supported slab of effective length in the shorter span is 3.5 m. Calculate the area…

Q: simply supported beam

Q: building in Noida, U.P. The data are as follows: Consider an inner beam-column joint in the ground…

Concept explainers

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.

Question

The segmental arch of span 90cm over a window¯opening is equilateral on
the span and radil. If the orch ring is 20cm thick and the thickness of wall is 30cm
estimate the quantity of brickwork in 10 such arches.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given Data

VIEW

Estimating Quantity of brickwork

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Design a cavity wall (specify thickness of the wall, mortar to be used, strength of masonry,strength of units, and if the wall needs to be grouted or not) for the top story of a 6-story office buildingin Galveston, Texas. The outer wythe has a vertical span of 11 feet and a horizontal span (simplysupported) of 20 feet. The inner wythe has a vertical span of 10 feet and a horizontal span (simplysupported) of 18.5 feet. Assume a uniform story height of 11 feet. Use the wind design provisions ofASCE 7-16 (consider cladding pressures as the governing wind pressure). Use an outer wythe ofstandard modular brick, and an inner wythe of hollow or grouted CMU. Use Type S portland cement-lime mortar.
Determine the preliminary structural plan for a 10-story (plus a roof) steel residential building which has a rectangular floor plan with a distance between outside columns of 60 ft × 120 ft . The floor-to-floor height for the building will be 14 ft. The lateral system will be concentric K braces in the center bays of the exterior frames.
4. How would the capacity of the shear wall with aspect ratio 3:1 be different from shear wall with aspect ratio 1:1 ?
Can't figure this out
For a three-hinged parabolic arch, what will be the ratio L/R to satisfy H = W? W T R H- ΖΗ AL
6'-6" 3 ASSUME CONCRETE = 150# / 173 5012 35/43 IS THE WALL STABLE?
1. What is the most appropriate construction material to use in the Philippines? Please explain why. 2. Can you please describe this example of Arch in the picture?
Subject : Concrete & Masonry Structure
Solve for the concrete materials of slab, beams and girders using class "A" concrete.
What is the maximum span for a 24-inch deep conventional pan one-way joist floor? Answer from: 26ft, 30ft, 36ft, 40ft
Sketch a cantilever retaining wall. Explain simplified design of reinforcement in the vertical part of the wall.
Question 1 (a) Differentiate between Ultimate Limit State and Serviceability Limit State giving examples. (b) What are the factors that influence the choice of cover in a reinforced concrete member? (c) Given a retaining wall, explain which side of the wall must have greater cover and explain why. (d) What are the importance of material safety factors and load safety factors? (e) Explain how shear force is resisted in a beam without shear links. (f) Differentiate between Rankine and Coulombs methods of calculating earth pressures on a retaining wall.