The sample you analyzed has an intensity of 0.83 and a wavelength 672 nm. When you reanalyze the sample 5 minutes later, the sample has an intensity of 0.73 and its wavelength is 672 nm. The sample's wavelength has undergone O a bathochromic shift. a hypochromic effect. O a hyperchromic effect. O a hypsochromic shift.

The sample you analyzed has an intensity of 0.83 and a wavelength 672 nm. When you reanalyze the sample 5 minutes later, the sample has an intensity of 0.73 and its wavelength is 672 nm. The sample's wavelength has undergone O a bathochromic shift. a hypochromic effect. O a hyperchromic effect. O a hypsochromic shift.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

How does a two-dimensional NMR spectrum differ from a one-dimensional spectrum? In a 2-D NMR spectrum, what is the diagonal, and what leads to the cross-signals (cross-peaks)?
Absorbance measurements in the range of A = 0.3 - 2 are considered the most accurate. Why are absorbance measurements of 0.05 and 2.5 considered inaccurate? If the absorbance is too high (A = 2.5), the signal difference between the sample and the reference is too small for an accurate measurement. At A = 2.5, the transmission is too high for an accurate measurement. The difference in the absorbance of the sample and reference is too small at A = 0.05. At A = 2.5, the detector is saturated because too much light is reaching the detector. At A = 2.5, a sufficient amount of light does not reach the detector for an accurate measurement.
Identify the spectra. All pertinent peaks must be assigned on spectrum (5-6 peaks). Label the peaks on spectrum. I have provided the correct structure in the lower left hand corner, I just need help with labeling the peaks on the spectrum to match the structure.
The students conducted the assay for LDH activity using the two serum samples. Each cuvette (path length 1 cm) contained 3ml of a suitable assay buffer (including pyruvate as substrate). 20 microlitres of either serum was added to the cuvette and the absorbance values immediately recorded at the optimum wavelength for a period of 5 minutes (absorbance readings taken every 30 seconds). Protein concentration of serum sample (mg/ml) Change in absorbance at optimum wavelength per minute Control serum (C) 8 -0.04 Diseased serum (D) 7.8 -0.6 1c. Using the molar absorption coefficient of NADH as 6220 M-1 cm-1, and by application of the Beer-Lambert law, estimate the enzyme activity in the two samples (C and D). Express activity as moles per second. 1d. Estimate the specific activity of the two samples (moles per second per microgram).
What is its Molar Refraction in cm /mole of a solution of a compound (MW = 250.67 g/mole) having a density 0.79 g/cm when its refractive index was measured 1.7 at 25°C. ? Final answer in 2 decimal places. C = 12.01; H =1.00, O = 15.99
After 20 scans, the signal to noise (S/N) ratio was 3.43. How many scans would be required to attain a S/N ratio of 12.5?
What kind of molecular weight do you generally get from light-scattering photometry?
A proton signal measured in a 90MHz spectrometer shows a doublet with peaks at 5.65 and 5.72 ppm. What is the chemical shift and coupling constant for this doublet? a. δ=5.69ppm, J=5.17 Hz b. δ=5.69ppm, J=6.30 Hz c. δ=5.72ppm, J=6.30 Hz d. δ=5.72ppm, J=5.17 Hz