The rectangular wood panel is formed by gluing together two boards along the 30-degree seam as shown in the figure. Determine the largest axial force P that can be carried safely by the panel if the working stress for the wood is 1120 psi, and the normal and shear stresses in the glue are limited to 700 psi and 450 psi, respectively. 1,0 in. -4 in. 30

The rectangular wood panel is formed by gluing together two boards along the 30-degree seam as shown in the figure. Determine the largest axial force P that can be carried safely by the panel if the working stress for the wood is 1120 psi, and the normal and shear stresses in the glue are limited to 700 psi and 450 psi, respectively. 1,0 in. -4 in. 30

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

CRACKED ANALYSIS ON BEAM
fc = 25 mpa, fy = 414 the tensile stress is in the concrete is?
Two wood boards, each 18 mm thick, are joined by the glued finger joint shown. The finger joint will fail when the average shear stress in the glue reaches 1080 kPa. Determine the shortest allowable length d of the cuts if the joint is to withstand an axial load of P = 4.2 kN. Use a = 18 mm and b = 144 mm. d Glue b P P Answer: d = i mm
The two pieces of wood, 2.94in. by 4.76 in., are glued together along the 48ᴼjoint. Determine the maximum safe axial load P (in lb) that can be applied if the shear stress in the glue is limited to 275 psi. Round off the final answer to three decimal places.
I. Problem Solving: Answer what is being required. Show you complete solution. 1. Compression test was applied to a certain type of wood. Compute the stress based on the following dimensions. The grains are parallel with the length. а. Dimension (mm) Load (N) Compressive stress (МРa) Compression Test L = 50 Parallel to the grain B = 75 130,000 W = 75 L = 50 Perpendicular to the B= 75 W = 75 35,000 Grain b. What would be the shear stress for a single shear for the same data in a.? c. What is the modulus of rupture if the width of the specimen is 50mm, depth is
9. If the value of the fc' of concrete is 30 MPa, and the actual stress of the concrete subjected to a force is 12 MPa, at what stage is the concrete at?
1) Identify the Yield Strength of the material using a 0.2% Offset line
Please show your solution clearly thank you
Give me right solution
Draw/Illustrate all axial, shear and bearing forces.
please answer step by step
Two wood boards, each 15 mm thick, are joined by the glued finger joint shown. The finger joint will fail when the average shear stress in the glue reaches 995 kPa. Determine the shortest allowable length d of the cuts if the joint is to withstand an axial load of P = 5.6 kN. Use a = 21 mm and b = 168 mm. d Glue b P P a Answer: d = i mm