The rectangular bar carries a load of P = 102 KN and is connected to the support bracket with a circular pin. The pin has a diameter of d = 35 mm. Each leg of the bracket has a thickness of t = 18 mm. Determine (a) the shear stress in the pin. (b) the bearing stress between the pin and the bracket.

Q: For the diagram shown, if the load P = 14 kips, determine: a. the normal force in the member Bar BD…

A: Given data: the applied loadP=14 kipsthe diameter of the pin Bd=0.5 intotal length of the beamL=10…

Q: The pole BC is supported by a pin C and by the steel wire AB. A horizontal force of 30 kN is acted…

A: Given data, Horizontal force at E, FE = 30 KN Ultimate shear stress of the pin, 𝞽ut = 100 MPa…

Q: The five-bolt connection shown must support an applied load of P = 370 kN. If the average shear…

A: Given data as per the question Applied load =370 KN Average shear stress =200Mpa

Q: The concrete post is reinforced using six steel reiforcing rods, each having a diameter of 20 mm.…

A: Given data: Diameter of each rod = d = 20 mm Applied axial load = P = 900 kN Modulus of elasticity…

Q: The d = 12-mm-diameter solid rod passes through a D = 17-mm-diameter hole in the support plate. When…

A:

Q: The d = 16-mm-diameter solid rod passes through a D = 21-mm-diameter hole in the support plate. When…

A:

Q: A pulley is supported by a circular pin at A. The pin has a diameter of d = 0.375 in., and each side…

A:

Q: The bell-crank mechanism shown is in equilibrium for an applied load of F₁ = 10 kN applied at A.…

A: The force applied, F₁ = 10 kNThe dimensions, a = 300 mm, b = 110 mm, c = 80 mm, and θ = 70ᵒThe…

Q: The bell-crank mechanism is in equilibrium for an applied load of F₁ = 12 kN applied at A. Assume a…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.